Question about Seat Cars & Trucks

Open Question

Wheels for seat - Seat Cars & Trucks

Posted by on

  • kakima Dec 17, 2016

    Hi Thomas Reintges, I want to help you with your question, but I need more information from you. Can you please add details in the comment box?

    Any particular seat?

×

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where are the spare wheels kept in a Hyundai terracan looking the bar for releasing spare wheel


The bar to lower the spare wheel is located under the back seat. The back seat is a 60/40 split seat and the bar is under the 60 longer seat. You need to pull the lever at the top of the seat near the head rest and lean it forward as far as it will go and then pull another lever at the base of the seat facing the door, Then lean that part of the seat forward to reveal the spare wheel lowering bar sitting in 2 clips. Take that bar to the back of the car and lift the tailgate. Just to the right of the latch that locks the tailgate in place is a hole to suit the bar. slide the bar all the way home and use the tyre lever to wind (anti clockwise)the spare wheel down. You're welcome.

May 19, 2017 | Hyundai Cars & Trucks

1 Answer

Hi, i have a precor 612 rowing machine, were can i find a wheel for my seat to go back & forth?


Hi
Remove seat stop - Philips screwdriver (back end of sliding bar).
If you are looking place where to buy wheels let me know i will try find them for you.

Aug 17, 2015 | Seat Cars & Trucks

1 Answer

Intermittant vibrationin seat and steering wheel a highway speeds


Have the play in the front wheels checked. This will check for worn ball joints, tie rod ends and wheel bearings. Otherwise, it could be a brake issue, a quick inspection could tell you.

Mar 16, 2015 | Seat Cars & Trucks

1 Answer

I have a rover75classic 54 it is leaking water when it rains on near side is it a useual fault


Had same problem. Lift up rear seat on drivers side and you will see a steel tube running from the wheel arch under the seat. Tube is about 2 inches wide. If this is rusted underneath then water is getting via the wheel arch open end of the tube. It runs into the rear foot well and forward into drivers footwell, also runs under rear seats and into the boot! I removed the rear drivers side wheel, pulled away the plastic wheel arch lining then sealed the hole where the wiring leads through this pipe. Covered it with plastic flashing replaced the wheel arch lining. Took 30 mins to repair, took a week to dry the carpet, rear seats and boot carpet.

Jan 20, 2013 | 2000 Rover 75

1 Answer

How do you remove the rear seats in a 1993 Toyota Previa?


hi

The rear seats have 1 x12mm or 13mm bolt securing it to the rear wheel arch.

Remove the cover over the bolt and unbolt the bolt 12mm or 13mm on the left and right side wheel arch

Then under each seat is a metal clip that holds the seats in place lift them up to unclip the seats, and then they can be removed.

cheers

Nov 16, 2012 | 1993 Toyota Previa

2 Answers

SRS light remains on after starting (engine) Why?


When the airbag light (SRS) is on or blinks it means a fault has occurred in the system and the airbag diagnostic monitor has disabled the system, the most common problem that turns the light on is a break in the connection to the steering wheel mounted airbag, this is due to a rotating ribbon contact that breaks under the steering wheel that connects the airbag to the wiring harness and the diagnostic monitor, the part is called the clock spring contact, a coiled up ribbon electrical contact that turns with the steering wheel while maintaining a mechanical connection to the airgag mounted on the steering wheel, to replace this part you must disarm the airbag system and remove the steering wheel, this requires a special steering wheel puller tool and that you disarm the airbag system before you start the work, to do this disconnect the battery negative cable for 1 hour prior.

Nov 11, 2009 | 2002 Honda Civic

1 Answer

Back seats legs will not retract.


Most likely the problem is due to the little white wheel inside the pivot point on the seat. This little white wheel holds the other end of the cable which is attached to the legs. This wheel likes to snap in half - and is a noted problem on the Ridgeline (just ask a dealer). Want even better news? You CANNOT buy this part unless you purchase the ENTIRE seat frame for a mere $325. You can purchase EVERYTHING else in the assemble but this cheap plastic wheel. Sounds fishy but that is what Honda has decided to do to their consumers. Calling the Honda customer service number won't help you so don't bother!

Jun 10, 2009 | 2007 Honda Ridgeline

1 Answer

Seat and steering adjustment on the daewoo lanos


check uder or to the sides to move the seat and to adjust the steering wheel there should be a small leaver at the left side of the steering wheel

Jun 04, 2009 | 1999 Daewoo Lanos

2 Answers

Seat position


this might be a faulty preset sensor on the seat. which explains why the sterring wheel and mirrors work on preset but the seat doesn't

Aug 27, 2008 | 1995 Jaguar XJ6

1 Answer

Driver's seat position


Try setting the seat position memory before you switch off.

Jul 25, 2008 | 1995 Jaguar XJ6

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

14 people viewed this question

Ask a Question

Usually answered in minutes!

Top Seat Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

yadayada
yadayada

Level 3 Expert

75822 Answers

Adam Truesdale

Level 2 Expert

265 Answers

Are you a Seat Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...