Question about Cars & Trucks

1 Answer

My ka is spluttering its guts out I've changed the coil pack , leads , plugs , injectors , and rail and it's still playing up . What shall I do next

Posted by on


1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 20 achievements.


    An expert that got 10 achievements.


    An expert that got 5 achievements.

  • Cars & Trucks Master
  • 22,326 Answers

Fuel pump in the tank ?

Posted on Dec 17, 2016

Testimonial: "Is that a defo coz it goes perfect for a bit then then goes back the same over n over its much better science I changed the injectors n rail fella"

  • Colin Stickland
    Colin Stickland Dec 17, 2016

    sounds like a weak pump ,to check you would need to connect a pressure gauge to the rail ,i made one with a tyre valve connector on the end of old AC low pressure filler that came with some gas bottles i bought cheap but a tyre pressure gauge from a footpump should do ,most cars run at around 30 something pound pressure.

  • Michael starmore
    Michael starmore Dec 22, 2016

    Nah it's still the same my friend have a look at my recent request see if you have any ideas for that please buddy



1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

2 Answers

I have an 06 Daytona and it started running really rough so we put it on the computer and it is misfiring on 5 6 7 8 cylinders changed plugs moved the coil packs around and still missing

Did you try removing and leaving 1 coil pack at a time, see if it changes the engine?? and swap them one at a time always leving one off..

Mar 04, 2018 | Cars & Trucks

1 Answer

1992 jag spec440.. just changed ext coil and run for 10 minutes and stop....i wait 5-10 min and good to go for another 10 minutes

check your injectors with a noid kit the next time it does a no start..this can explain mysterious no starts because of shorts on the ground in the injector rail..kills the the fuel rail pulse and coil packs.they get their feedback from the computer ground..wiggle the fuel rail connector..then check the harness by feeling down it for burnt or touching the block areas..GOD BLESS

Jan 28, 2018 | Cars & Trucks

2 Answers

How do you take off the fuel rail on a 1996 Volvo 960?

Hesitation is rarely due to injector problems! Have you checked the throttle position sensor, and checked for possible vacuum leaks? What about the EGR valve?

Apr 22, 2017 | 1996 Volvo 960

1 Answer

What causes misfire in #1 cylinder

A failed fuel injector will do it also. Compare the injector coil resistance with that of another injector. If it's open or significantly different, the injector coil is bad. The injector could also have a mechanical problem such as a clog.

Nov 14, 2011 | Cars & Trucks

3 Answers

H3 2006 62000 miles misfire in cylinder 2 I change the plugs and the coil pack whats next

Go directly to dealership, 2006 h3 models came with bad valvetrain worksman ship ,the chances are ur head needs to be replaced and will be fixed under warranty.

Mar 11, 2010 | 2006 Hummer H3

1 Answer

How do i change the spark plugs on a 2002 jaguar s-type v8 i cant locate where they are? i pulled off what i thought was it and it looks like some kind of injector of some sort but i cant see the plugs...

The the injector are hook up to a fuel rail, the coil pack's and you have 8 on them sit almost next to the fuel injector's, the coil pack's are held on with a 8mm bolt, there round looking on top about 2" in dim. with a clip on connector, remove small bolt pull up on coil pack, coil pack will have a boot at the end, down in that hole will be the spark plug's, no rail or tube will be hooked to the coil pack, just the harness.Spark plug gap .50, but if your using Platinun +2 or +4 not adjustable. Hope this was very helpful.

Jan 19, 2010 | 2002 Jaguar S-Type

1 Answer

Fuel Rail Wiring Harness

salvage yards or online

Nov 16, 2009 | 2001 Dodge Caravan

1 Answer

1998 mercury grand marquis 4.6 sparkplug change

un-plug the coil packs--injectors--pull wiring out of the way,and then unbolt the coil packs and pull them out,and use a 6 inch to 8 inch extension on a 3/8 drive rachet with a 5/8 plug socket...snug the plugs back in pretty good because the 4.6 and 5.4 are known to blow the plugs out and wreck the threads on the head.On the drivers side you may have to unbolt the fuel rail(2 bolts)and lift it up off from the injectors,make sure that you dont tear the 0 rings on the injectors and watch to see if some or any 0 rings comes off from the injectors and stays with the fuel rail..when putting the fuel rail back on the injectors,use a little motor oil and wipe it on all 0 rings to assist in going back together without tearing the 0 rings.

May 08, 2009 | 1998 Mercury Grand Marquis

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

20 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts


Level 3 Expert

79865 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

john h

Level 3 Expert

14479 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides