Question about 1999 Daewoo Lanos

1 Answer

Daiwoo Lanos 1999. Have to rev high when taking off in 1st gear or engine will die and miss. when driving it runs well so long as the throttle is only pushed to above idle and increased slowly.

If given more throttle quickly the engine dies, but if you then decrease throttle to just above idle position it will pick up and go like a rocket.

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Top Expert:

    An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

  • Daewoo Master
  • 74,902 Answers

You have a misfiring engine, read the fault codes to determine which cylinder is misfiring.

Posted on Dec 17, 2016

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Why do i have to press the gas before i put it in gear if i dont it dies smothes out at 50 mph


Is the shifter real loose and floppy?
If it is you may be starting out in 3rd gear instead of 1st!
Remove the shifter boot below the shifter look at the rods as you shift 1 thru 5 and Rev! Note the rod position as you shift thru the gears. You can do this while sitting idle, not driving!
If while tring to get it into 1st, take your hand and push the left rod farther forward has you move it into 1st gear! If you are able to get it into 1st, try driving forward, if it doesn't stall, chances are you need to replace the shifter do to the worn out Nylon Bushings in the shifter! If this doesn't help, take a look under the hood and see if the shifter cables are attached to the top of the shifter tower! Some times the clips holding the shifter cable to the trans come off and one of the cables will slide making it impossible to get it into 1st gear!
Hope this helps!
if you need photos of what I'm trying to explain, please reply back as soon as possible.

Aug 17, 2014 | 1999 Saturn SL

1 Answer

Want to buy a new daiwoo lanos engine


There is no such thing as a new engine for a used car. Are you referring to a rebuilt or re-manufactured engine? If so you can find one online or talk to you're local repair shops.

Jul 12, 2014 | 1999 Daewoo Lanos

1 Answer

Idling high


I would check the engine coolant temperature switch 1st.

Jan 24, 2014 | 2004 Hyundai Santa Fe

1 Answer

Transmission problems


when checking the transmission fluid always check it while vehicle is running, if you overfill the transmission YOU WILL BURN IT UP. secoundly the high RPM is most likley a cause by a bad TPS Throttle Posiction Sensor. and yes the high RPM can cause transmission damage if you do not fix the problem pretty quick .in this case good idea to do soits getting harder and harder to get parts for these cars TPS-25.00 to 45.00 if you fix it your self, simple to do

Nov 26, 2013 | 2000 Daewoo Lanos

1 Answer

Have a Daiwoo Lanos 2000 1500. Have replaced spark plugs, fuel filter and it looses power with boot up it then after taking foot off accelerator it runs on 2 cylinders as if it is missing etc. Do these...


not really but they do suffer from mass air flow sensors to some extent ,had to renew quite a few on these earlier cars when they get a bit older

Feb 05, 2011 | 2001 Daewoo Lanos

1 Answer

1999 isuzu rodeo slow to shift. Engine revs very high before it will shift.


There is a cable that goes from the throttle body to the transmission. usually by the throttle body you can adjust the cables lenghth by pushing in the tab. only move this a couple of notches at a time, test drive and see where it shifts. adjust as necessary. 1st gear should be at 15 to 20, 2nd at 30. Let me know if this works for you , we can go from there.
Randy

Nov 09, 2010 | 1999 Isuzu Rodeo

1 Answer

After driving for while it starts to run rough and like its going to stall. It looses power and seems to be running on 3 cylinders. Replaced leads and plugs. Suspect injectors.


Put higher octane fuel in to fill and injector cleaner bottle full. Take car on freeway give it a blast ( don't break speed limit but rev engine maybe in lower gear ) and it will run like new. If problem continues after this then diagnostics at dealership next best option.

Oct 21, 2009 | 1999 Daewoo Lanos

1 Answer

Where is the cam shaft located 0n a 2002 daiwoo lanos


on single cam engine its inlet manifold side just behind cam gear rear cover bolted into cam box cover
twin cam its behind cams in middle front of engine in centre of rocker cover remove cover over h.t.leads this one is eazy but tricky

Jun 01, 2009 | 2002 Daewoo Lanos

1 Answer

Car wont idle


you may have a vacuum leak, check all the vacuum lines around your inlet manifold, carbi etc for cracks or ones that have come off their fitting.
Check all the retaining bolts and nuts around the manifold, they may be a bit loose.

May 30, 2009 | 1999 Daewoo Lanos

Not finding what you are looking for?
1999 Daewoo Lanos Logo

Related Topics:

25 people viewed this question

Ask a Question

Usually answered in minutes!

Top Daewoo Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

yadayada
yadayada

Level 3 Expert

74896 Answers

Steve Hurc
Steve Hurc

Level 3 Expert

450 Answers

Are you a Daewoo Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...