Question about Cars & Trucks
Go to a vet for a proper diagnosis
could be scabies, a mite infection,dermatitis or a fungus
it might be necessary to have a sample taken for proper diagnosis and treatment
Posted on Dec 17, 2016
A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
Tips for a great answer:
Feb 05, 2014 | 2007 Toyota Corolla CE
Nov 05, 2012 | 2010 Mercury Milan
Sep 05, 2011 | Hyundai Sonata Cars & Trucks
Replacing tail/brake/turn signal/backup lamp bulbs (page 59-60 of owners manual)
The tail lamp, brake lamp, turn
signal lamp and backup lamp bulbs
are located in the same portion of
the tail lamp assembly. Follow the
same steps to replace either bulb.
1. Make sure headlamp switch is in
OFF position and open trunk and
remove two plastic mushroom nuts,
three push pins and the plastic
cover from inside the trunk to
access the lamp assembly.
2. Carefully pull the carpet away to
expose the lamp assembly hardware.
3. Remove four nut and washer
assemblies and the lamp assembly
from the vehicle.
4. Remove the bulb socket by
rotating it counterclockwise, then
pulling it out of the lamp assembly.
5. Pull the bulb from the socket and
push in the new bulb.
6. Install the bulb socket into the lamp assembly by rotating it clockwise.
7. Install the lamp assembly on the vehicle with four nut and washer
assemblies ensuring the washers on the nuts are flush with the body to
prevent water from entering the trunk.
8. Carefully push the carpet back in to place and install the plastic cover
inside the trunk with three push pins and two plastic mushroom nuts.
May 31, 2011 | Mercury Sable Cars & Trucks
Apr 04, 2011 | 2000 Jeep Grand Cherokee
Open the back hatch of your Honda Pilot and look for two small screws. They will be right behind the tail light. Remove the two screws, using a standard screw driver. You should now be able to pull the tail light box away from the car a few inches to allow access to the sides of the tail light box
Remove the two ball sockets found on both sides of the tail light box. At this point you should be able to move the entire assembly enough to get at the tail light. Inside the tail light you will find three bulb sockets. Remove all three bulbs by turning the sockets to the left.
Nov 28, 2010 | 2009 Honda Pilot
Jun 08, 2010 | 2002 Chevrolet Venture Passanger
Apr 06, 2010 | 2005 GMC Canyon
Jun 08, 2009 | 2005 Chevrolet Impala
Jan 08, 2009 | 1993 Toyota Camry V6
17 people viewed this question
Usually answered in minutes!