Question about 2000 Chrysler Sebring JXi

Open Question

Have a manual for a 2000 Chrysler Sebring Jxi

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get to try the service completely Free afterwhich it costs $6 per call and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 10 Answers

SOURCE: 1997 Chrysler Sebring jxi

Are you trying to replace one of the turn/hazard signal bulbs? If so, which one. The backside of the bulb will turn about a quarter turn and come out the back side of the housing then you can change the bulb out as usual.

Posted on Sep 05, 2008

Ad
  • 1 Answer

SOURCE: Replacing headlight in 1996 Chrysler Sebring JXI

piece of cake....
take off the two "star" bolts, one toward the center of the engine above the light assembly and the other toward the fender (it is very long). when you remove them both the entier assembly falls off into your hands and makes changing the bulbs much easier.

Posted on Sep 16, 2008

  • 158 Answers

SOURCE: 2000 sebring transmission pan torque spec

10 ft lbs no real patterm needed

Posted on Apr 03, 2009

polarcycle
  • 1392 Answers

SOURCE: Possible plugged AC drain (Chrysler Sebring)

If you are getting clear liquid, with the A/C on, then you have a clogged drain tube. If it is green or reddish, you have a bad heater core. Should be able to have someone blow out the drain tube to clear it out.

Posted on Jun 11, 2009

  • 1244 Answers

SOURCE: 2000 Chrysler Sebring windsheild washer pump

check the fuse panel for weak or blown fuse in the wiper/washer circuit if that all checks ok then using a test light or volt meter then find the washer pump leads at the bottom of the washer pump itself and with the circuit activated make sure you have 12 volts going to it also check the ground wire to it to insure proper ground if voltage is present then remove the motor assembly from the washer housing and relace the motor

Posted on Jan 23, 2010

Testimonial: "Quick, informatve response...perfect & thanks!"

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2000 sebring JXI car alarm won't shut off. Soon as I connect the battery it starts blaring, continues while the car is running. Only way to shut off is disconnect the battery. What can I do??


Try connecting the battery, while alarm is blaring, lock the door with the button on the inside of the door, shut the door, unlock with the key, then start. It worked on a friends durango.

Feb 08, 2017 | 2000 Chrysler Sebring JXi

1 Answer

Obd2 scanner nolink response for 2000 chrysler sebring jxi limited convertible what can I check for?


Check pin 16 of the OBD2 connector it should have 12 volts key on. Pin 16 is the lower pin on the far right of the bottom row of connectors.

Dec 16, 2016 | 2000 Chrysler Sebring JXi

1 Answer

How many freeze plugs in chrysler sebring jxi


Not positive but I would say six. The engine would have to be pulled and that is a 4-6 Hr job. $400-600 just for that.

Feb 23, 2013 | 2000 Chrysler Sebring

2 Answers

How to find 2000 Chrysler jxi convertible top motor


sebring transmission pan torque spec need torque specs for 2000 Sebring jxi convertible, transmission pan torque specs and bolt tighting

Nov 29, 2011 | Cars & Trucks

1 Answer

Air condition blower switch works only on high on my 2000 chrysler sebring jxi


You most likely need a blower motor resistor it reduces the amount of voltage to blower motor but is by passed on high speed

Aug 08, 2011 | 2000 Chrysler Sebring

2 Answers

My 2000 Chrysler Sebring JXI cuts off while i am driving, or stopped, have replaced the fuel pump, fuel relay, fuel filter care still cuts out...please help !!


WE HAVE THE SOLUTION.

WE ALSO HAVE A 2000 SEBRING CONVERTIBLE JXI

REPLACE THE IAC AND EGR VALVE, REPLACE ALL SPARK PLUGS AND WIRES; THREE SPARK PLUG ARE HIDDEN UNDER THE MANIFOLD.

CAR NOW RUNS PERFECT!!!!!!

Sep 15, 2010 | 2000 Chrysler Sebring

1 Answer

Replacing headlight in 1996 Chrysler Sebring JXI


piece of cake....
take off the two "star" bolts, one toward the center of the engine above the light assembly and the other toward the fender (it is very long). when you remove them both the entier assembly falls off into your hands and makes changing the bulbs much easier.

Aug 25, 2008 | 1996 Chrysler Sebring

Not finding what you are looking for?
2000 Chrysler Sebring JXi Logo

Related Topics:

13 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

yadayada
yadayada

Level 3 Expert

76630 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8514 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...