Question about Suzuki Cars & Trucks

1 Answer

Suzuki super carry 1.3 engine revs high low high low high low when clutch is put down engine revs very high

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Suzuki Master
  • 20,706 Answers

Wow no year car stated nor a country x10 worse.
welcome to our USA forum!
the country with ZERO, carry cars. not a one. here
and due to that , no books here nor coverage at mitchells. either.
That is a G13 engine, (not m13) is my 1st guess.
Most Suzuki's with tiny engine and run a map sensors, not MAF
so is called SPeed Density system.

if yes, the that means ALL vacuum leaks cause fast idle.,
armed with that juicy fact, we know why it races.
you never said and actual RPM so no Tachometer?
only 2 causes. a huge vacuum leak
or unlikely the ISC stuck wide open with gunk inside, (clean it?)
ISC is idle speed control.
old suzuki's had man killler ISC software, my 91 did it.
and all others like it........
it would hunt idle like mad with any vacuum leak.(of any kind)
today this is very *******, this mode. (hunt)
toyata cost them $1billion in fines for this same deal.

but Clutch drivers have no problems with idle hunt, "skills"
what year/country.?
please showa photo of engine. ?
and win. a win/win
you win and I win not guessing all that.

fact 2 , is that that hunt tells me the ISC is moving fast.
so is not stuck. (99% says R3PO)
unplug ISC see the hunt end? sure.
the ECU has lost its wits. from..... this....
it sees a massive air leak (vacuum map readings ) and then (dumbblly ) hunts it like mad, (bad Firmware code) but real.
i can demo this is seconds hood up.
causes?
1: vacuum hose fell off.
2: same hose cracked.
3: brake booster diaphragm cracked, sucking air big time)
4: lots more,. even gunk under throttle plate blocking it open.
and more. lots more. can cause lots of vacuum leaks.

Posted on Dec 17, 2016

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Sx4 /engine revs at 2000-2500engine managment light on and no acceleration


the CEL is not fibbing to you,
its in FAILSAFE mode, Limphome(generic).
get it serviced or
DIY, SCAN IT, and read the FSM for the tests. to do,

FSM = factory service manual sold at all Suzuki stealerships.

Jul 20, 2014 | 2007 Suzuki SX4

1 Answer

1991 Suzuki Swift GTi very low idle and stalling


Oxigen sensor. Check accelerator pot also, and fuel pump.

Jan 13, 2013 | 1991 Suzuki Swift

2 Answers

2008 hyundai accent clutch slipping, i think?


seems a bit early for clutch. how many k's? I would start by checking the intake tube for splits & security & airflow sensor. they will cause the engine to rev but no response (like a slipping clutch) so its manual right?

Oct 09, 2012 | 2008 Hyundai Accent

1 Answer

200 ford focus no air conditioning and when turned on engine revs up and down


Sounds like you are low on Freon. The engine has a separate RPM control which is used to increase the speed anticipating the A/C clutch to engage. When the A/C clutch does not engage, the engine overspeeds. The system then slows down and you get the variation you describe.

Service the A/C. If you try to do it yourself you will be alright if there is still a little Freon in the pipes. But if you do not have any pressure, th leak will need to be found and fixed. Then borrow a big Vacuum pump and evacuate the system. Best performance is a pressure between the high and low limit switch cutouts.

Jul 17, 2012 | 2000 Ford Focus

1 Answer

Suzuki vitara power loss


Sounds like the transmission is slipping if it is an automatic or the clutch is if standard transmission.

Apr 05, 2012 | Suzuki Grand Vitara Cars & Trucks

1 Answer

Suzuki sidekick clutch problem


Check the cable clearance. Too much clearance will cause clutch slippage or total clutch disengagement. Adjust the cable so that the clutch pedal will be hard to press by hand .5 to .75 inch from its initial point.

May 27, 2009 | 1996 Suzuki Sidekick

1 Answer

Starts O.K. Lacks pulling power. Will not rev to full power.


check for a clogged exhaust look at catalytic converter it could be stop up.

May 24, 2009 | 1999 Suzuki Vitara

1 Answer

Grinding sound on pressing clutch in at high revs


The grinding sound may be a throw out bearing or the pilot bearing. The sticking throttle problem sounds like a linkage or cable binding up from possibly damage due to the impact from the accident.

Feb 05, 2009 | 2008 Toyota Yaris Sedan

1 Answer

Rev high when changing gear up


my friend has same model its normal he said it does it more so when its cold

May 24, 2008 | 2003 Honda CR-V

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

32 people viewed this question

Ask a Question

Usually answered in minutes!

Top Suzuki Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Boyet Soriano
Boyet Soriano

Level 2 Expert

293 Answers

Are you a Suzuki Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...