Question about 2006 Nissan Maxima

1 Answer

My 2006 nissan maxima starts but wont go over 3000 rpms engine dies off if held there nd stalls

Posted by on


1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.


    An expert who has achieved Level 3.

  • Master
  • 222 Answers

Sounds like your catalytic converter is plugged.

Posted on Dec 17, 2016


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

2000 Nissan Maxima Stalls out

Check engine light on ?
Could be one of the sensors such as the mass air flow or tps.

Feb 19, 2014 | Cars & Trucks

1 Answer

Swirl control valve vacuum check switch

sounds to me like something besides the throttle is opening up in the intake manifold-the fuel could be shutting off also causing a lean situation-nasty little cars-I hate cars that don't preform properly-when it stalls does anything smell hot-cheers Denny

Nov 02, 2013 | 2000 Nissan Maxima

1 Answer

Jumping rpms and car starting in 5th gear

The engine and automatic transmission in this vehicles drive train are fully electronically controlled by a computer called the PCM (Power Train Control Module). Whenever a problem like this occurs the computer stores a record of the problem (there are of course some exceptions to this, like the fuel pump, engine coolant temperature sensor and MAF sensor for instance) in the form of a fault code in its memory, to read these fault codes you must have the systems memory scanned with a special tool. Once the fault code(s) are read you then must perform the appropriate diagnostic testing to find and resolve the problem(s) DO NOT REPLACE ANY PARTS UNTIL A TRAINED TECHNICAIN HAS DIAGNOSED THE PROBLEM TO AVOID SPENDING YOUR HARD EARNED MONEY ON PARTS THAT MAY NOT CORRECT THE PROBLEM

Aug 26, 2012 | 2006 Nissan Maxima SL

1 Answer

My nissan wont start when i tried to start the car it just idled funny an continued to die what can i do to fix it

run comuter hand held on it to get code look up code for answer could be crankshaft sensor or camshaft

Apr 21, 2011 | 1995 Nissan Maxima

1 Answer

Wont idle stalls at low rpms

Take it for scanning but I believe the plugs could be defective and or the air flow sensor....This last part is situated between the air filter housing and the throttle body, and has a connector with five cables.... It's held in place with small machine screws....Its a very delicate piece of equipment so please be careful with it.... ....If you have a friend with the same type of vehicle you can borrow from there and use a trial and error technique....
Regards Johngee10

Nov 01, 2010 | 2000 Nissan Maxima

1 Answer

1995 Maxima idling at 400 rpms. No diagnostic code.

If a mouse chewed the wire into you may need to check all the wires. It sounds like you need to check the operation of the idle air control valve and it's wiring circuit. Good fortune!

Jul 07, 2009 | 1995 Nissan Maxima

1 Answer

1995 Nissan Maxima

Since RPM meter is also important so that you can control the engine from overspeed. It is also important to repair the thing your rpm cable maybe worn out already. If it is an electronic rpm meter cold Solder in electronic lead might be the cause.

Jun 01, 2009 | 1995 Nissan Maxima

2 Answers

1992 SE maxima jerking, sputtering, stalling

I had a similar problem and resolved it by replacing the mass airflow sensor. Ive got 235k+ miles on my 1992 Maxima SE.
Still runs good but having problems with the alarm system.

Jan 27, 2009 | 1992 Nissan Maxima

Not finding what you are looking for?
2006 Nissan Maxima Logo

Related Topics:

15 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts


Level 3 Expert

77932 Answers

Phil Lovisek
Phil Lovisek

Level 3 Expert

726 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22306 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides