Question about Scion Cars & Trucks

Open Question

Where is the yaw sensor at on 04 scion xb - Scion Cars & Trucks

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 255 Answers

SOURCE: scion xb wont start

Hi.. Yes i fix my problem by disconecting the neutral suitch and reconecting it ,,they get dirty with time and dont make contact ,Is a good idea to disconect and clean as many contacts as you can and put some special grease on them to prevent other problems ...

Posted on Jul 29, 2008

  • 101 Answers

SOURCE: need help to remove 2005 Scion xB water pump

1st ...that should be covered under 6 year 50k power train warranty from the dealer.
But if your over....you need to unbolt the right side motor mount (on the water pump side) and lift the engine some with a floor jack to get clearance,

Posted on Apr 11, 2009

  • 439 Answers

SOURCE: How d you replace the starter on a 2005 Scion xb?

There are two bolts, one is at the top exactly opposite of the first one you took out. You will not be able to see it, but feel around the head of the starter where it goes into the block and you will feel where it goes.

Posted on Jun 23, 2009

  • 38 Answers

SOURCE: How do I install alt. belt on 2005 scion xb?

I just looked at my '04 xB. It looks very straight forward.
loosen the bolt that holds the alternator to the bracket.
carefully slide the alt to the bottom. (Also be aware of the plug and wires on the alt.They should never hold the weight of the alternator. You dont want them breaking prematurely.)
Pull the belt off, remove the belt from the crank shaft pulley.

Do the reverse, and you will have replaced the belt.

Make sure to check the belt in about a week or so.
New belts will stretch over time. Make sure you keep the tension tight enough to work correctly, but not so tight that the alernator shaft is warped.
I usually place the new belt on both pulleys and give a good "medium" pull on the alt while tightening. Find the middle of the belt and squeeze them together, depending on the type and length of the belt, there should be about 1/4" of flex on both sides.

Posted on Jun 29, 2009

polarcycle
  • 1392 Answers

SOURCE: 2005 scion xb window quit

Sounds like a stuck motor. Hold the switch down and slam the door shut. This will usually break it free. It will most likely need a motor though.

Posted on Jul 06, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do I install a yaw sencer on 2004 scion xb


yaw rate sensors require calibration. I wouldn't advise you do this yourself.

Feb 26, 2017 | 2004 Scion xB

1 Answer

How many Speed sensors are in a 2005 scion xb


As far as i know, thee is only one speed sensor. It is located on your transmission. It is on the right side of you engine, underneath the air cleaner. Just a sensor, and easy to replace. Should take you less then an hour. There also might be one on you ABS system, but i am not aware of it on a Scion.

Feb 02, 2015 | 2005 Scion xB

1 Answer

My 2005 scion xb won't go into overdrive and the speedometer doesn't work


run the fault codes and look for a failed VSS sensor

Feb 22, 2012 | 2005 Scion xB

1 Answer

Track off light is on. what does that mean?


I had the problem a few weeks ago. I took the vehicle to the Scion dealership originally the computer said it was the ECU unit after replacing that my vsc and traction control light remained on. Come to find out it was the yaw rate sensor.

Jan 06, 2011 | 2005 Scion xB

2 Answers

Instructions for replacing 2005 Scion xb water pump.


It's pretty straightforward EXCEPT you must loosen the engine mount and jack the engine up about an inch to get enough clearance to get it out/in because the engine is about 1/4" too far to the passenger side. Just did my 04' and that was a hard to find piece of missing info.2_8_2013_3_15_00_am.jpg2_8_2013_3_15_22_am.jpg

Mar 18, 2010 | 2005 Scion xB

1 Answer

2004 scion xb shuts off while at a stop light ? than has trouble starting back up.


check that the mass air flow sensor has a clean sensor. Cars with MAF dont idle well if the sensor wire gets crude built up on it.

Mar 09, 2010 | 2004 Scion xB

1 Answer

SCION XB CAMSHAFT POSITION SENSOR P0010 CAME ON WHEN CHANGING BEL


Trace your steps, look for the sensor wire or plug that connects the sensor to your harness, you may have unplugged it, or damaged it.

Jan 01, 2010 | 2004 Scion xB

2 Answers

Does my stock pioneer stereo in my 05 xb have an ipod adapter


No i have pulled out the stereo myself and there is no port for it, that option is now offered on the 2008 which sucks because they where giving ipods away at the dealership when i got my 05 Scion xb makes no sense huh.

Jun 08, 2009 | 2005 Scion xB

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

126 people viewed this question

Ask a Question

Usually answered in minutes!

Top Scion Experts

yadayada
yadayada

Level 3 Expert

75817 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Brad Brown

Level 3 Expert

15557 Answers

Are you a Scion Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...