Question about Ford Cars & Trucks

1 Answer

How to find my scytek

Where would my scytek electric start/alarm be installed at in my 2004 ford Taurus my car came with it I have no manual just the remote and it has my car completely locked down so it will not start at all.

Posted by on


1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 20 achievements.


    An expert that got 10 achievements.


    An expert that got 5 achievements.

  • Ford Master
  • 14,585 Answers

Under the dash, drivers side. Remove it or have it removed. You just can't unplug it. Wires have to be fixed. You see it. Bunch of wires and fuses and controller/s.

Posted on Dec 16, 2016


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

2004 Ford tores my car won't start it's the key ignition an this girl got it going by some kind of sequence with the key ii try to find her so he can show me but I don't know her

disconnect the battery cables for 5 minutes then reconnect them and deactivate the alarm with the remote control and it should work if not try a different key the chip might have been erased from the pats system or you must reprogram it into the system register yourself at and then go to your owners manual if you don't already have one when you go to the alarm/key section the program sequence is there all cars are different so you must go to the manual for the correct procedure for your car and if this happens again and again somewhere you have a bad cable and the power keeps disconnecting putting the car into theft mode

Nov 02, 2016 | 2004 Ford Taurus

1 Answer

How to reset a 2004 ford Taurus alarm system with a new code

what's wrong here I might be able to help you if you explain a little better did you disconnect the battery and now your alarms in theft mode or is there a remote control issue for the alarm please post back

Mar 12, 2015 | 2004 Ford Taurus

1 Answer

I have a Taurus 2004, and it happens that the car horn beeps 3 times randomly. does anyone know what would it may be?

the horn beeping at random is indicating a fault in the alarm system. alarms have their own battery which is balanced by the car battery and any unbalance ( corroded connections -bad earth, low charged battery in alarm, loose battery connections ) will cause the horn to sound --same as too sensitive a setting for the alarm or a intermittent power to the alarm

Mar 08, 2015 | 2004 Ford Taurus

1 Answer

My car battery went dead, bought a new one, every time I hook up positive cable, car alarm goes off........

remove alarm reinstall after fitting. at least cut power supply and back up supply fit battery repair reinstall alarm.

Feb 16, 2015 | 2004 Dodge Stratus

1 Answer

Car alarm keeps going off on it's own.

I suggest check the owners manual, you can donwload in Ford-Taurus-Owners-Manual

Hope this helps (remember comment and rated this).

Jul 23, 2010 | 2000 Ford Taurus

1 Answer

Changing throttle position sensor on a 2004

Removal & Installation
  1. Disconnect the negative battery cable.
  2. Disconnect the throttle position (TP) sensor electrical connector.
  3. Remove the screws and the TP sensor.

Throttle position (TP) sensor electrical connector

TP sensor

To install:
  1. Install the screws and the TP sensor. Tighten screws to 7 inch lbs. (3 Nm)
  2. Connect the throttle position (TP) sensor electrical connector.
  3. Connect the battery ground cable.

Apr 25, 2010 | 2004 Ford Taurus

1 Answer

Discunected my battery to replace a/c compreser reconnected my battery and car would not start it gets fire and gas. has antitheft system i have no remot how can i reset it 2004 ford taurus se 3.0 v6.

disconnecting the battery having an alarm system activated the security on it. you will have to get it towed to your local dealer repair shop and have then deactivate the alarm system. i would also go to autozone and buy a devise that you plug into your vehicle to make sure that doesnt happen again.

Feb 23, 2010 | 2004 Ford Taurus

1 Answer


kindly download the manual from the following link

hope i was of help...
pls dont forget to rate my service...
thank you have a nice day and good luck with ur alarm

May 01, 2009 | Toyota Corolla Cars & Trucks

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

33 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts


Level 3 Expert

80339 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers


Level 3 Expert

5687 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides