Question about Honda Cars & Trucks

1 Answer

My 2016 Honda crv when I drive it about a half hour then come to a red light and stop with the brake on it goes from 800 rpm to 600 rpm and vibrates just had recall done but dealer says

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Top Expert:

    An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

  • Honda Master
  • 45,365 Answers

Any problems after a dealer work done means that the work was not done properly so take it back

Posted on Dec 15, 2016

Testimonial: "thamk you I took it back and they said they couldn't find anthing ,its only when I stop in drive and the rpms drop to 600 like it wants to stall tranny recall just done in computer I think they did it then but don't know what to do now I also think the whooping is in the tranny also it is crying now"

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

3 Answers

How do I recalibrate TPMS so the light will go off? I do not have a TPMS button on the dashboard and in vehicle settings it is not an option. I have a 2016 touring crv.


Depending on the system used, it could have a faulty transmitter valve.

Reprogramming is usually needed whenever a wheel is changed or a tyre replaced.

Diagnostic equipment is needed.

Aug 21, 2017 | Honda CR-V Cars & Trucks

1 Answer

When my crv 2005 on a drive and holding the brake with same gas until 2 rpm I having bad vibration . or ..rubbing noise ?


Hi Gill:
The first thing I'd be checking would be the condition of the brake pads and rotors.

Jul 13, 2015 | Cars & Trucks

1 Answer

Crv vibrates for a few seconds as if going over rumble strips 2004


Check cv joints and check loose bush in diff casewhere the shaft goes in. Try lifting up and down as I think you have a problem with the drive shafts binding up

Feb 11, 2013 | Honda CR-V Cars & Trucks

1 Answer

This rough idle business; With the AC on at a stop, the idle is about 600 to 700 rpm and vibrates the cabin. Can the dealer change a computer setting to correct this?


Problem on focus too . Without A/C on it idle's smooth . With A/C on the PCM - engine computer should raise the idle rpm. 850 . The only way to raise the idle would be to have PCM flashed programmed with up dated software . Adjusting the idle anyother way would cause check engine light problem , Wouldn't be able to get it to go out. Your best bet ,take it to the ford dealer and have the PCM reflashed .

Sep 14, 2017 | Ford Escape Cars & Trucks

2 Answers

2006 Honda CRV makes screeching sound while turning corners


built into the brake pads is a small bit of metal that when the pads get to low to be safe , runs on the rotor and produces the squeal applying the brakes stops the vibration so the noise drops off

Jun 29, 2017 | 2006 Honda CR-V

2 Answers

RPM problem


Check and lube the Idle Air Control (IAC) valve,

This tiny electric motor is mount on top valve cover and close to the accelerator cable.

The function of IAC motor is to idle up the RPM when more load is added.

Example: A/C on,light on,stop light on and radio on.

A stuck IAC can be free by few soft tape on the body of the motor.

To lube the worm gear,you will need WD-40 to free up the old grease and lube white lithium grease.

Clean the electrical contacts with CRC electric part cleaner.

This electric motor is very expensive.

Please handle it with care.

Dec 08, 2009 | 1998 Suzuki Esteem

1 Answer

When I'm stopped, idiling, i hear noise/vibration


If it's coming from under the car, the most common problem is the heat shields on the exhaust system

Sep 08, 2009 | 1999 Honda Civic

1 Answer

Honda CRV vibration at 40 and above


check egine mounts and balancer

Jul 07, 2009 | 2001 Honda CR-V

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

34 people viewed this question

Ask a Question

Usually answered in minutes!

Top Honda Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...