Question about Cars & Trucks

Open Question

Left hand brake light access - Cars & Trucks

Posted by on

  • rugby prop Dec 15, 2016

    Hi elinor9, I want to help you with your question, but I need more information from you. What make and model of car / van please.

×

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do i replace left rear brake light bulb


1) Open trunk
2) Remove small round plastic access panel with a flat tip screw driver by prying open
3) Remove flat tip screw holding tail light assembly
4) Remove tail light assembly by pulling outward, careful not to break plastic guide/nub
5) Disconnect wiring connectors
6) Remove plastic housing access plate on back of tail light assembly by twisting/turning tabs until they click and then lift access plate from tail light assembly
7) When viewing the the bulbs, the turn signal bulb is the bottom left bulb
8) Install in reverse order, ensuring tail light seal seats properly during installation

Oct 13, 2014 | 1999 Audi A4

1 Answer

Right hand brake light not working vp commodore.bulb has been replaced but still no go


I assume the left hand brake light works.
First check that you have replaced it with the correct bulb. Make sure it is the same as the left hand brake light bulb.
Sounds silly but different bulbs will fit the same socket, but not work.
Make sure no one will push the brake pedal and see that contacts are clean and there is spring pressure behind the contact in the socket. If all the above is okay then you probably have a wiring problem.
Either the earth wire, usually black, is damaged or not connected to earth (body work) .
Or the power wire from left hand side light is cut or damaged. Check the colour of the wire on the left hand brake light. It will be the same for the right side.
If you have a trailer plug follow the wire from it back to where it connects to the cars original wiring. The problem could be at that connection.
Good luck

Feb 17, 2013 | Cars & Trucks

1 Answer

Location of fuse to control side mirrors on 2009 97x


Fuse panel in end of fascia
No. Amp. Function
1 15 Steering wheel lock
2 5 Steering column unit; ignition switch
3 10 Hands-free; cabin CD changer; SID
4 10 Main instrument unit; manual climate control;
automatic climate control (ACC)
5 7.5 Control module in front doors; Park Brake Shift Lock
(automatic transmission)
6 7.5 Brake light switch
7 20 Fascia fuse panel; fuel filler door
8 30 Control module in passenger front door
9 10 Fascia fuse panel
10 30 Trailer socket; electrical socket in storage compartment
between seats
11 15 Data link connection (diagnostics)
12 15 Interior lighting incl. glove compartment
13 30 Accessories
14 20 Radio, sound system I; control panel,
Infotainment System
15 30 Control module in driver's door
16 - -
17 - -
18 7.5 Manual climate control; fan
19 - -
20 7.5 Headlight levelling switch
21 7.5 Hands-free; brake light switch; manual climate
control; clutch pedal switch
22 30 Cigarette lighter
23 40 Cabin fan
24 7.5 Airbag control module
25 - -
26 5 Yaw sensor (cars with ESP)
27 - -


Trunk fuse panel, left-hand side
No. Amp. Function
1-5 MAXI -
6 30 Control module in left rear door
7 30 Control module in right rear door
8 20 Trailer
9 - -
10 30 Left-hand brake light; rear right turn signal; right tail
light; right reversing light; high-mounted brake light;
trailer lights
11 - -
12 - -
13 - -
14 - -
15 15 Seat heating, left seat
16 15 Seat heating, right seat
17 7.5 Autodimming rearview mirror; rain sensor; tire
pressure monitoring
18 15 Sunroof
19 7.5 Telematics (OnStar)
20 7.5 DVD player (navigation system)
21 7.5 Saab Parking Assistance (SPA); control module in
rear doors
22 30 Amplifier, sound system III
23 - -
24 10 Movement sensor; CD changer in trunk (accessory)
25 30 Electrically adjustable driver's seat with memory
26 30 Right-hand stop light; rear left turn signal; left tail
light; rear fog light; left reversing light; license plate
lighting; trunk lighting; trailer lights
27 - -
28 - -
29 - -

Fuse panel in front of battery
No. Amp. Function
1 60
MAXI
Secondary air injection pump (certain models)
2 20 Fuel pump; preheated oxygen sensors (lambda
probe)
3 10 A/C compressor
4 30 Main relay
Relays
1 Secondary air injection pump
2 A/C-compressor
3 Preheated oxygen sensors (lambda probe)
4 Main relay, engine (ECM/EVAP/injectors)

Sep 13, 2012 | 2006 Saab 9-7X

1 Answer

How to change the third break light bulb in a 2007 hyundai sonata ?


From 2006 to 2010, the Sonata's 3rd brake lamp requires the rear package deck be removed to access that bulb.
1. Remove the rear passenger seat bottom (remove two12mm bolts between the seat back and the seat bottom - tilt the seat back forward to locate these bolts).
a. Press the two bottom front edge tabs to release the front of the seat bottom from the floor.
b. Remove seat bottom & set aside w/two 12mm bolts
c. Tilt both seat backs downward
2. Remove the left & right hand shoulder cushions (12 mm bolt at the bottom of each cushion)
a. Remove seat belt from shoulder cushion guide at the top of the cushion
b. Lift up and forward on shoulder cushions to remove them (if equipped with side airbags, disconnect wire harness connector).
c. Set shoulder cushions aside w/two 12mm bolts
3. Using a small flathead screwdriver, pop out the 'SRS' button cover from the C pillar panels on the left & right hand side to access either the phillips head screws, 10mm bolts, or #30 Torque Screws
a. Remove screws and set aside
b. Using a standard flathead screwdriver, pop out the C pillar panels on both sides (clips hold these panels in place)
c. Set these panels aside after removal w/screws/bolts
4. Trunk Access-way panels are held in place by phillips head screws (two at the bottom (left and right hand sides) and 4 to 5 at the top .
a. Remove left and right hand panels and set aside w/screws.
5. Rear package deck held in place with two plastic clips (white, yellow or pink)
a. lie on your back inside the trunk (trunk lid open to allow for more light). Looking through access hole find 3rd brake light wire harness connector & disconnect.
b. locate package deck clips, one on the left and another on the right on the underside of the pckage deck
c. Squeeze clips to push them out - package deck will come loose
d. Remove package deck & remove 3rd brake lamp bulb socket (turn counter clockwise to remove). Replace bulb & reassemble in reverse order.

Sep 05, 2011 | Hyundai Sonata Cars & Trucks

1 Answer

I have a indicator light on the lower left of my dashboard that comes on each time I press on the brake. It looks like a light bulb. Do you know what it is?


i don't have access to the owners manual in your glove box, but if i did i would surmise that the car is telling you that your brakes are failing and you need to get to a mechanic and have him look at it and put his hands on it before you have a nasty accident.

Dec 11, 2010 | 1995 Volvo 940

1 Answer

1982 911 sc brake light on, replaced pressure switch but light still on. mechanic says its not the e-brake switch. then what???


Hello there
The brake light onyou are referring to is the light under you went on dash?
This lite should come on with your hand brake on and off .If it does not go off with the hand brake down it is your hand(emergency)brake switch.It needs to be adjusted .Before you try to adjust the switch i recomend to remove your VDO clock gauge and reach with you left hand inside.
Try to locate the back connector on the light switch and gently pull it off and that reconect,this should fix your problem with the light.
If it comes back try to adjust the hand brake switch which is under the rubber cover at the handle
any more Q you can contact me
at
trubka@hotmail.com

trubka

Nov 19, 2010 | 1982 Porsche 911

1 Answer

Flashing hand brake light is on give,s 3 beeps when pulling off plus abs light is on i think left hand front abs sensor is gone would this cause the handbrake light to flash all fluid levels are spot on ....


Yes. Both lights usually come on when there is an ABS problem detected whereas the brake light will usaully only come on by itself with the hand brake or low fluid.

Jun 05, 2009 | 2002 Volkswagen Passat

1 Answer

Red light on all the time on dash small red dot light bottom left


what red light the hand brake light, if it is your hand brake light you need to get that back brakes looked at as they could be binding and heat your brakes up, and you will not stop as you should,

Jun 05, 2009 | 2004 Jeep Grand Cherokee

2 Answers

Towbar wiring


i wiried up my focus estate with the following no relays needed as the wiring is protected by the car fuses
pin 1.yellow/left hand indicator
pin 2.blue fog light
pin 3.white/earth
pin 4.right hand indicator
pin 5.brown/right hand tail light
pin 6.red/ brake lights
pin 7. black left hand tail light
connect these to the car wiring with scotch locks as follows/red/blue.right hand indicator/blue.left hand indicator,green/black,left hand indicator,red/green,right hand indicator,orange right hand light,orange and white,left hand lights, finally green/yellow fog light
hope this is of use to you all my lights are working and correct

May 09, 2009 | 2000 Ford Focus

1 Answer

1999 isuzu rodeo ls


On the left hand side of the truck, there are two screws that hold the light assembly in place. Unscrew them and slowly pull the light assembly straight back. Then you can access the light bulbs from there.

Feb 21, 2009 | 1999 Isuzu Rodeo

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

16 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

76109 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...