Question about Cars & Trucks

1 Answer

Tii only opens 2 inches - Cars & Trucks

Posted by on


1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 20 achievements.


    An expert that got 10 achievements.


    An expert that got 5 achievements.

  • Cars & Trucks Master
  • 3,111 Answers

What part of your car is a Tii ?
Please provide your make, model, year, and mileage of your vehicle.

Posted on Dec 15, 2016


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

My 89 jag 6 cyl wont rev over 3 k

Him tgus us tii vague a query to fully address, can you give more detail, i.e. pre problem history. Did the issue suddenly appear or has it been coming on slowly? When was the engine last serviced? Could be a fuel system issue, , pump / manifold / injection

Please add as much information as possible and repost the query

Jun 08, 2016 | 1989 Jaguar XJ6

1 Answer

My 1990 4runner after putting rebuilt motor in starts but won't stay running. Any ideas?

new engine or starter motor????
stalls. which engine, exactly
all engines have unquick fueling and spark and lots more.
which one? of the 8. (even gas and diesel)

2.0 L 3Y I4
2.2 L 4Y I4
2.4 L 22R-E I4
3.0 L 3VZ-E V6
2.4 L 2L-TE turbodiesel I4
2.4 L 2L-TII turbodiesel I4
2.8 L 3L diesel I4
3.0 L 1KZ-T/TE turbodiesel I4


Dec 28, 2014 | 1990 Toyota 4Runner

1 Answer

How do I release back door latch manually from the inside. handel came off

Easy there is a plastic panel that's about 2 inches by 2 inches pop that off and u can grab the cable with a needle nose pliers pull straight up and it will pop open

Oct 10, 2014 | 2004 Ford Freestar

1 Answer

Can gain entry

use the physical key , or you are able to open the hood using a screw driver with a long shank ('~9 inch if I remember) or a quarter inch stiff steel rod of sorts. However, if you look through the upper center of the grill, locate the "bolt" that holds the safety catch. About 2 inches to the left and half inch down (as you look at it) there is a hole about quarter inch in diameter. Stick the blade of the screw driver in the hole and pry to the right (toward center of car). The latch will trip and the hood will open. Then you can get to the terminals to jumper and/or charge the battery

Feb 27, 2014 | 2011 Cadillac CTS

1 Answer

How do you release the tention on the surpentine belt. 2005 dodge stratus 4cyl 2.7 DUHC

  1. Engage a torque wrench, with a maximum 2 inch extension in the 1/2 inch square opening of the tensioner bracket (Fig. 9).
  2. Apply 141 Nm (104 ft. lbs.) of torque, counterclockwise to the tensioner bracket while tightening the upper fastener. Torque fastener to 28 Nm (250 inch lbs.) (Fig. 9).
  3. Remove torque wrench from tensioner bracket, and torque lower tensioner bracket fastener to 28 Nm (250 inch lbs.).
  4. Verify proper belt tension.

Hope this helps with your question...

Sep 14, 2011 | 2005 Dodge Stratus

1 Answer

When the overhead open switch is pressed, the passenger side rear door opens about 2 inches and stops. After opening manually it will not close with switch. When manually closed, will draw in last inch and...

It sounds like there are 2 motors involved, one that latches and unlatches the door, and a second that moves it out of the way or brings it back.

The one is working, the other is not.

First, look for a blown fuse.

Disconnect that 2nd motor (if you can find the connector), and use a volt meter to see if power is getting to the motor and the motor does not work, or the power is not getting there.

Jun 21, 2010 | 2005 Chrysler Town & Country

1 Answer

After changing the battery the door windows will not close after.

I have two cars that do the same thing. It is in your owners manual on fixing this. Should be an EZ fix. Good luck!

Mar 10, 2010 | 2008 Pontiac G6 Sedan

1 Answer

How to fill the diff again after its drained.. can only open drain plug on bottom. cannot find how to fill the oil back in

On the top of the differential is a fill port. It is usually a 1/2 inch drive square hole that your 1/2 inch drive ratchet goes directly into. It is usually on the passenger side.

Oct 24, 2009 | 2000 Toyota Land Cruiser

1 Answer

Sunroof on Infinity QX4 (2001) won't work properly, the automatic open button only opens it about 2 inches at a time.

Good news I found out from a forum and it worked for me. Here it is

: 2002 pathfinder sunroof acts up after replacing battery (CKirbyjr) 5:30 PM 5/9/2008 qt.gif reply.gif edit.gif

Welcome to NICO -- The same thing happens whenever I disconnect my battery.
Try opening the sunroof all the way (2 inches at a time) and then close it (again two inches at a time). Turn the vehicle off and on again. Sunroof should operate normally.
I'm not sure if the last step is required but I've always done it anyway. It's worked all three times I've had my battery disconnected.

Jul 15, 2008 | 1999 Infiniti.5 QX4

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

15 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts


Level 3 Expert

79186 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

john h

Level 3 Expert

13735 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides