Question about Saab 95

Open Question

99 saab 95 2.3 i need to bypass key cyl, start position w/ pushbutton set up got positive lead figured out,where do I EASILY access other lead to start cellonoid to start vehicle

Posted by on

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My immobiliser is not working so i would like to no how to bypass it


Want to bypass your vehicle security system

You can't remove alarms or bypass them, you have to fix them.

Disconnect the battery fully for at least 2 hours.
Hold the negative and positive leads together for 5 minutes.
PUT THE KEY IN THE IGNITION, but not turned on.
Connect the Positive lead to the battery.
Connect the Negative lead in one swift movement.
Wait 15 minutes for the ECM to re-pair the chips in the key and the ignition key.

Nov 16, 2017 | Cars & Trucks

1 Answer

99 Saab 9-3 Turn-Key cranks over but wont start. It's A 5 speed manual if you pull it it starts but not by the key. It reads key not accepted. What is wrong?


Inside the key close to the blade is a small chip that the ecm needs to receive the code from to allow it to start the engine there is a pickup coil in the plastic surround the steering lock barrel if the connector is dodgy you can get a key error or if the chip has moved out of position in the key same result
the code has to be read and accepted before it will let the engine start

Nov 03, 2016 | Saab Cars & Trucks

1 Answer

2000 saab 95 5 speed transmission is locked in reverse. will not let the key turn to on and start position. need to know how to unlock.


Your car should start regardless of the gear its in since its a five speed all you have to do is press the clutch if not something is wrong with your neutral safety switch and or your clutch pedal positio. Switch don't k kw how Saab calls it exactly are you parked in an incline?

Dec 24, 2015 | Saab Cars & Trucks

1 Answer

Saab 95 2001


first check fuses..then try this..disconnect the battery negative with the key in the run position..all circuits will be dead....then shut the key off..reconnect the battery negative and then turn the key to the run position..DO NO ATTEMPT TO START..wait for 3-5 seconds or until dash indicators go out..this tells you that the factory presets are reprogrammed in the computer..then start the car..see if it works..

Dec 15, 2013 | Saab Cars & Trucks

1 Answer

Will a key and ignition cylinder from a 99 saab 95 wrok in 2002 saab 95


It should I don't think there was that much a change from 99-02 few cosmetic and performance changes

Aug 23, 2013 | 1999 Saab 9-5

1 Answer

My remote didn't open doors, on my1998 Saab 900S, so I used key to unlock manually. The alarm went off, and car won't start. When I open the door the anti theft alarm goes off again. This is E


Replace the battery in the remote, then reset the system.

Resetting a Vehicle Anti-Theft System
This is how you reset an anti theft system if you have the anti-theft light on, or your car is cranking, but you have no spark.

Doing a full reset of the anti-theft system.

Disconnect both battery leads for at least two hours.
Hold the negative and positive leads together for 5 minutes to fully discharge any power.
Put the key in the ignition, but not turned on. VERY IMPORTANT!
Connect the positive lead.
Connect the negative lead in one swift movement.
Wait 15 minutes for the system to fully reset.
Resetting Vehicle Anti Theft System

Mar 06, 2018 | 1998 Saab 900 S

2 Answers

The theft light flashes and the 99 taurus will not start unless i leave the ignition in the forward position for 10 min. and take out three fuses that are for ignition coil, relay and something else then i...


If you could remove the anti-theft system, it wouldn't be called an anti-theft system. Try a different key. If that doesn't work, get it fixed. Those are your only two choices unless you think you know how to rewrite all the software code

Jan 14, 2018 | 1999 Ford Taurus

2 Answers

My saab 95 won't start I think its the Direct Ignition how can I check it


Need year and 4 or 6 cyl. Assuming 4 cyl, need to know year and miles. Is the check engine light on? Easiest way is to swap out. Have to be careful with the DIC. Must be attached to plugs, must be upright. Could get 4 plugs, make sure it is up right and attached to computer. See if there is spark. Usually foul electrical smell if DIC fails. Also could be CPS (Crank Shaft Positioning Sensor).

Jul 18, 2010 | 1999 Saab 9-5

3 Answers

Saab 95 1998 - wont start


The most common problem is the Direct ignition cassette, followed by the crankshaft position sensor. I am assuming that it cranks, but won't start.

Dec 26, 2008 | 1999 Saab 9-5

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

21 people viewed this question

Ask a Question

Usually answered in minutes!

Top Saab Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

yadayada
yadayada

Level 3 Expert

79851 Answers

derek oliveira

Level 2 Expert

85 Answers

Are you a Saab Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...