Question about 1993 Honda Accord

1 Answer

Took off wires from cap and put them on rong

Took off cap and put wiresd on rong on a 91 acorod

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Top Expert:

    An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

  • Honda Master
  • 75,822 Answers

Go to this web page for the picture and firing order

http://autorepair.about.com/library/firing_orders/bl-fo-9309.htm

Posted on Jul 20, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Smoke is rising from my steering column


You have a Shorting wire, you will have to dismantle the steering column to trace it. Disconnect your battery and do not drive it until you get it fixed.

May 06, 2015 | 1994 Buick LeSabre

1 Answer

My parents took out my 1993 ford courier engine and dropped it into a 1994 courier I need to know where the wires go on the engine what colour goes where


well bud i would leave it to and expert if you get the rong wire in the rong place you can fry them all it can get expensive but mostly you need the ignition box hoot up and the distributor wires and such make sure you have the correct firing order for the distributor and t fuel lines to go to the engine there are the basics if i was there i could just do it four you hope this helps

Jan 13, 2014 | Cars & Trucks

2 Answers

My truck had a tune up and everything was good ...then is started to sound like it was missing...then i stalled...has gas...has spark


the mechanic may hav a plug wire on rong plug or the wires cud be old and they were pulled on--the distributer cap cud hav corrosion-chec it--inspect injector connections-mite hav been disturbed--fuel filter may be put in backwards--many techs dont test drive vehicles

May 12, 2011 | 1991 GMC Sonoma

2 Answers

Took the distributor out and cleaned it then put it back in and now the truck wont crank but tries to do so. need some tips please


Did you take out the ENTIRE Distributor or just the cap?

If you took out the entire Distributor, and put it back in, there is a possibility that you put it in backwards. The bottom of the Distributor has a 'notch' in it. If you turn it 180 degrees the wrong way, and put it back in, your truck will not start, because it is in effect 180 degrees out of alignment with the timing.

If you only took out the cap, refer to your owners manual (Hanes is best) for the plug wire placement in reference to the firing order, and make sure all the plug wires are in the correct locations. Also, make sure your plug wires are seated all the way down onto the plugs, and the cap is secured tightly onto the base of the Distributor.

Make sure your Coil Wires are also seated properly to the coil and the Distributor.

Clean the battery connections. Remove the battery connections, clean them and reinstall.

Nov 16, 2010 | 1991 Toyota Pickup

1 Answer

91 honda accord wont crank


There is a sensor under the left hand side of the dash that would not allow it to start, provided that you have replaced the electronic spark module inside the distributor first, which is what it sounds like it would be, When you say you replaced the distributor I assume you replaced it complete!

Jun 12, 2010 | 1991 Honda Accord

1 Answer

I have a 91 honda civic and need spark plug wire diagram


Fire order
1-3-4-2

Cylinder #1 will be the one closes to the fan belts and so on 1-2-3-4, on the distributor cap there should be a # 1 stamped on it, put cylinder # 1 spark plug wire on that one, install spark plug wire in firing order clockwise on the cap, the cap some time's might even have the firing order on it.

Jun 04, 2010 | 1991 Honda Civic

1 Answer

91 honda crx suddenly would not start


the stock ground wires are kind of **** , my wifes honda did the same thing so i priced a new stock replacement $60. so instead i got 5 ft of 2 gauge cable, a new marine style battery terminal (with the brass wingnut), and 4 crimp style 2 gauge cable ends, which only cost me $15 and took about 10 minutes to put together. this was after i replaced the battery and the starter relay (descovered it was unneccesary through process of elimination)

Jun 22, 2009 | 1991 Honda Civic

2 Answers

Emissions failing with high NOx


Change the lambda/oxygen sensor in the exhaust.

May 21, 2009 | 1994 Mitsubishi Galant

Not finding what you are looking for?
1993 Honda Accord Logo

Related Topics:

69 people viewed this question

Ask a Question

Usually answered in minutes!

Top Honda Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...