Question about Chrysler Cars & Trucks
Recheck wiring or maybe you blew fuse installing it
I know this happens if you put in an after market stereo, your original car radio has anti theft device in it,you must replace original radio and reset the ecm/brain by disconnecting your positive cable from battery after replacing original radio.Then you must get a ether a control box compatible with the radio you are programming,if it is and after market stereo.If it is a factory radio it must be programmed to the car by a chrysler dealer, Just a guess maybe its done something to the heater as it was working fine you said before insalling stereo.
Posted on Dec 15, 2016
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
SOURCE: Where is the EGR valve
I saw on another forum...that it is on the rear of the motor on the passenger side. It also stated that it is easy to replace. I haven't looked yet.
Posted on Aug 19, 2008
If it is an error produced by the engine control system, you should be able to clear it using an OBD II reader. OBD=on board diagnostics. You have to find the plug for the unit, but just plug it in and the machine will read it. I usually borrow one from the local car parts store--give an ID and they will let you temporarily borrow it. Make sure you read the error code as well. There may be some interesting info about what produced the error message. Good luck.
Posted on Apr 09, 2009
you have to get the cable that conects your factory deck harness to the aftermarket deck, and that will allow you to use your factory speakers and amp, the wire harness is availiable at canadian tire or any stereo shop
Posted on May 06, 2009
Locate the fuse pannel and check for blown fuse...If fuse not blown - check fan control relay for proper operation - If thats not the problem check for voltage at the switch.
Posted on Feb 07, 2010
Tips for a great answer:
Mar 21, 2016 | Cars & Trucks
Feb 24, 2015 | Chrysler Cars & Trucks
Dec 17, 2014 | 2010 Chrysler Sebring Touring
Sep 13, 2014 | 2010 Chrysler 300 Touring
Apr 08, 2014 | 2010 Chrysler 300 Touring
Jun 29, 2012 | 2010 Chrysler 300 Touring
Jul 11, 2009 | Chrysler 300 Cars & Trucks
20 people viewed this question
Usually answered in minutes!