Question about 2000 Jeep Grand Cherokee Laredo

1 Answer

I want to find out where is the hood sensor located on my 2000 jeep grand cherokee laredo can u help me.

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Jeep Master
  • 20,706 Answers

Why ask 3 times.
i posted the WG book, non USA car photos in your other post.
here again.

see the wire, that is a switch, there is a hood lamp too
on export jeeps, WG.
this is usa forum so.... be smart to say where you are
as our cars are NOT your cars.

i want to find out where is the hood sensor locate - 26399713-ztpgumilwzorums4ugbll2ay-4-0.jpg

Posted on Dec 16, 2016

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
ArcheryDude
  • 18 Answers

SOURCE: where is the speed sensor located on a 2000 jeep

Since you have the die hard, can not kill 4.0, I believe this mated with the 42RE transmission. My understanding It use's a single sensor (located on the overdrive gear case, over the park gear).The 42RE transmissions use a single sensor (located on the overdrive gear case, over the park gear). The 42RE transmissions use a single sensor (located on the overdrive gear case, over the park gear).

Posted on Oct 02, 2009

wracefans24
  • 1985 Answers

SOURCE: how to replace the Battery Temperature Sensor

it is located under the battery in the battery tray.

Posted on Jan 22, 2010

  • 6982 Answers

SOURCE: I have 2001 Jeep Grand Cherokee Laredo and it is leaking coolant

Front drivers side could be a bad cap, lower hose or the radiator itself. You need to look carefully and find the leak source. Steam travels and isn't a good indication of where the actual leak is coolant will run down and take any path it can to reach the ground. Therefore, you need to follow it back to where it is coming from, then deal with it. Your water pump can also leak and run down the lower hose. there is a small hole in the pump behind the pulley. If you see coolant coming from there the pump needs to be replaced. Sealers will not work on hoses or pump leaks so don't bother using them for that.
Good luck...don't forget this is free, so rate answers!
I will answer follow-up questions too!

Posted on Jan 25, 2010

  • 6982 Answers

SOURCE: Where is the camshaft sensor located on my 99 Jeep Grand Cherokee

If you still have a cap rotor and ignition wires, it's inside the distributor. If not, it is the part where the distributor used to be (center rear of the engine behind the intake manifold)

Posted on Feb 19, 2010

ZJLimited
  • 17970 Answers

SOURCE: Could you tell me where

zjlimited_1234.jpg

Fig. The coolant temperature sensor is installed in the thermostat housing (click image for zoom).

  1. Partially drain cooling system until coolant level is below cylinder head.
  2. Disconnect coolant temperature sensor wire connector.
  3. Remove sensor from thermostat housing.
Hope helps (remember to rate ths answer).

Posted on May 12, 2011

Testimonial: "This is an excellent community. Thanks for the help!"

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I want to find out where is the hood sensor lacated


on the hood
a switch,
no symptoms stated.?
alarm warning
the book on it is free, posted like 400 times now.
here it is again, RTM?
click, WJ jeep here ,in the select jeep box.?

http://www.morris4x4center.com/knowledge-base/index.htm?utm_source=cj#service

bingo,

Dec 15, 2016 | 2000 Jeep Grand Cherokee Laredo

1 Answer

I HAVE TO CHANGE OUT A CRANK SENSOR IN MY GRAND CHEROKEE.


Jeep Crank Sensor Replacement, P Codes P0351, P1391 ...

? 6:24
www.youtube.com/watch?v=7D0vUEDSwXo
May 12, 2013 - Uploaded by Robert DIY Replaced the crank sensor on this 2003 Jeep Grand Cherokee.... to replace my crankshaft position sensor on my 1998 grand cherokee laredo.

Jeep Crankshaft Position Sensor Replacement (CKP, CKPS ...

? 4:07
www.youtube.com/watch?v=1Ho5iAKQV00

Oct 27, 2013 - Uploaded by WeekendHandymen
hi , do you think if I replace crank sensor will solve the problem ,my jeep .... Where's the crankshaft located in 99 jeep grand Cherokee laredo .


Oct 24, 2015 | Cars & Trucks

1 Answer

Wher is the crank sensor located in 1999 grand cherokee laredo located


Hi there:
Check Grand Cherokee Jeep Limited 1999/2000, the CKP sensor is located on the right side (driver side) at the end of the engine block when you open the hood and facing the engine block..the sensor sits on the bell housing..It has its cable connector end pulled all the way to the left side of the engine block and connected there, so you may have to first locate and grab that connector cable end, near the oil filter at that left side at the end of the engine block , and then you feel and trace the connector cable all the way through the back of the engine block back to the CKP sensor on the right end side of the engine block in order to easily locate the sensor.

9_14_2012_3_53_41_am.gif

Hope this helps; also keep in mind that your feedback is important and I`ll appreciate your time and consideration if you leave some testimonial comment about this answer.

Thank you for using FixYa, have a nice day.

Sep 14, 2012 | 1999 Jeep Cherokee

2 Answers

01 Jeep grand cherokee laredo won't start. No fire is going to engine. Changed spark plugs but didn't help at all


you might want to check you cam shaft sensor amd also there is a different sensor under the distutor i had to replace both of these on my 95 jeep grand cherokee laredo

Dec 04, 2010 | 2001 Jeep Grand Cherokee

1 Answer

Where is the fuse box for the 1999 Jeep Grand Cherokee Laredo


I have a 2000 but the 99 is probably the same. Mine is on the passengers side front seat area under the glove box. Youll need to remove the access panel of course. There are also fuses located under the hood on the passengers side.

Dec 02, 2010 | 1999 Jeep Cherokee

1 Answer

I need a diagram of the fuse box under the hood, and the fuse box inside under dash on passenger side..someone has changed the glove box and my key doesn't fit, cannot get to manual.....1997 jeep laredo


You tell us Jeep Cherokee (Laredo), in a Grand Cherokee subforum? I confussed.

If this is a Cherokee, review the Repair Manual XJ Cherokee

If this is Grand Cherokee, review ths Repair Manual ZJ-Secc-8W-Wiring-Diagrams (page 7, 9 and 10 for location, details and description). The diagramas can find it in the next pages.

I hope help yuo with this (remember rated this help). Good luck.

Oct 15, 2009 | 1997 Jeep Grand Cherokee

1 Answer

Where is the washer pump in a Grand Cherokee Laredo 2000


It is located in the bottom of washer reservoir (bottle).

Jul 01, 2009 | 2000 Jeep Grand Cherokee

Not finding what you are looking for?
2000 Jeep Grand Cherokee Laredo Logo

Related Topics:

22 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

yadayada
yadayada

Level 3 Expert

76109 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...