Question about 2010 Chevrolet Traverse

Open Question

WHERE IS THE THERMOSTAT ON A 2110 CHEVY TRAVERSE LS 3.6 L LOCATED

Posted by on

Ad

2 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
  • 11704 Answers

SOURCE: Where is the fuel pump fuse located on a 2009 Chevy Traverse

FSCM Fuse
25A
Fuel Pump Flow Control Module , under hood fuse/relay box.
do you know what a fuel pump control module is ?
The in-tank fuel pump is controlled with a fuel pump control module (FPCM). The engine control module (ECM) enables the FPCM and sends the desired fuel line pressure to the FPCM via GMLAN. The FPCM sends a pulse width modulated (PWM) voltage to the in-tank fuel pump allowing the fuel line pressure to be varied as commanded by the ECM. The high pressure fuel pump, fuel rail pressure, fuel injection timing, and injection duration are controlled by the ECM.

I would bet that the fuse isn't the problem ! Don't get me wrong , the fuse could be blown but fuse's don't blow for no reason . The fuel pump control module .

Video on youtube fuel pump control module diagnostic's .

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where is the thermostat located on a 2010 traverse ls


Where the hose from the radiator enters the motor, its in the thermostat housing.

Dec 21, 2014 | Cars & Trucks

2 Answers

My rear air conditioner on my 2011 Traverse only blows warm air. Front air works good


clogged air condition filter leading to rear unit Possible LOW on FREON

Aug 20, 2014 | 2011 Chevrolet Traverse LS

1 Answer

2009 traverse the defroster doesnt blow any air all other settings work fine. would this be covered by warranty


Not unless you have purchased an extended warranty that covers HVAC components. The original factory warranty was for 3 years.

Jan 22, 2014 | 2009 Chevrolet Traverse LS

3 Answers

Recharge Air Conditioning Chevrolet Traverse


it's straight below the high pressure valve about a foot. it's a little stem with a cap on it. it's kind of by the oil flter. i didn't see it the first time i looked either.

Mar 11, 2013 | 2010 Chevrolet Traverse

1 Answer

My traverse lost all power, will not start


ck battery cables ,ck battery voltage,if good ck fuses use owner manual index for fuse box locations and fuse numbers,if all are good and still has no power inside or to dash it will have to go to chevy.

Jul 29, 2012 | 2012 Chevrolet Traverse LS 4dr SUV 3.6L V6...

1 Answer

Replace cabin air filter on chevy traverse 2010


2009 chevy traverse- where is the cabin air filter located. It definatly has one but ??? where.

Jun 18, 2012 | 2009 Chevrolet Traverse

1 Answer

Crankshaft sensor location chevy traverse 09


I spent hours in engine and on the internet. I viewed 15 different sites with 15 different answers. Finally found it...The crankshaft position sensor on a 2009 Chevy Traverse (3.6 liter) is as follows: You need to jack up vehicle (or useramps) and climb under. You CANNOT access it from top (as many sites state). On the firewall (vehicle) side of motor, in the center, directly below the exhaust outlet, you will see a silver (aluminum) heat cover/plate. It is held on by 2 bolts. (one 15mm and one 10mm). The sensor is located benind this cover. Once you get this cover off, you will see two seperate sets of wires, wrapped in silver heat deflection tape. The set of wires that extends further to the left go to th CPS (sensor). I used a small extendable automotive mirror to see it. It is in a tight spot, but once you find it, it is easier to access than it looks!!! Took me about 30 minutes total to switch it out. Hope this helps !!! Good luck.

May 05, 2012 | 2009 Chevrolet Traverse

1 Answer

Iam having trouble with 2 codes 2107 2110


I have a 2003 V6 lincolin LS with codes 2107/2110, I've changed everything but the plugs and the cam postion sensors. make sure you use Iridum spark plugs, with the gap at .051. Once I did this and replaced the cam sensors the car runs great no wench light. At 150 miles and 3 days,so far with no problems.It took me about 6 months to get it right. And I don't want anyone to go through what I did. I hope This helps.

Jul 18, 2010 | 2004 Lincoln LS

Not finding what you are looking for?
2010 Chevrolet Traverse Logo

Related Topics:

45 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

76051 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8265 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...