SOURCE: i need a wiring diagram for fog lights oem to my toyota
The link below is a Typical fog lamp / driving lamp hookup. Keep in mind that in most states, for these lamps to be 'legal' (and thus pass inspection), you must wire them such that:
1. You can cut them off (in other words, there must be a switch installed to turn them off)
and
2. They may only be operated with the low beams. (therefore, you must power your on/off switch from the low beam circuit)
http://www.accessconnect.com/fog_driving_lights_wiring.htm
SOURCE: Vacuum leak-P0171 2000 Toyota Echo. Need vacuum diagram
A P0171 code does not indicate a vacuum leak; it indicates a dirty mass air flow sensor. This device is located between the air filter box and the intake manifold. Locate it, unplug the wire harness, and remove the 2 screws that holds it onto the intake pipe. Look down inside th sensor, you will see 2 small wires, that are probably covered with fuzzy things...using a spray cleaner, such as brake cleaner, spray the 2 wires until they are clean and shiny. Do NOT use compressed air, that will damage the sensor. When it is clean; reinstall it and drive it. The computer will recognize the now clean sensor, and your troubles will be over.
SOURCE: Carb vacuum diagram for 1984 toyota 4x4 22r
these things are not available online due to copyright restrictions. you must get a paper manual.
SOURCE: i need a timing belt diagram for a 2000 toyota
My apologies for the delayed response. I am going back and answering questions that were never answered.
Click on the following Link. It has all the Diagrams for the Timing Belt you will need.
Before Clicking, let me know if this helped.
Again my sincerest apologies...
www.2carpros.com/car_repair_information/year/2000/make/toyota/model/camry/2000_toyota_camry_timing_belt_diagram_marks.htm
590 views
Usually answered in minutes!
×