Question about 2015 Mercedes-Benz GLK-Class

Open Question

I have GLK 350-2015.Its boot door stops working.I can not open or close it.

Posted by on

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How can I lock a renault megane 56 plate without the key card as it is not working


Locking/Unlocking the doors from the outside
This is done using the RENAULT Card; see the "RENAULT Card" information in Section 1.
In certain cases, the RENAULT card may not work:
- if the RENAULT card battery is weak, flat, etc.
- if equipment operating on the same frequency as the card (mobile phones, etc.) is used;
- vehicle located in a high electromagnetic radiation zone.
It is then possible:
- to use the key integrated into the card to unlock the front left-hand door;
- to lock each of the doors manually;
- to use the interior door locking/unlocking control (refer to the following pages).
Using the key integrated in the RENAULT card
Insert key 1 into the lock in the driver's door and lock or unlock. Locking the doors manually
Turn screw 2 with the door open (using the end of the key) and close the door.
This means that the doors are then locked from the outside.
The doors may then only be opened from the inside or by using the key in the front left-hand door. Interior locking/unlocking door control
Switch 3 controls the doors, boot and, depending on the vehicle, the fuel filler flap simultaneously.
If a door or the tailgate is open or not closed properly, the doors and tailgate lock/unlock quickly.
If you need to transport objects with the boot open, the other opening elements can still be locked: with the engine stopped, press switch 3 for more than five seconds to lock the other opening elements.
Locking the doors without the RENAULT card
For example, in the event of a discharged battery or the RENAULT card temporarily not working, etc.
With the engine switched off and an opening element (door or boot) open, press and hold switch 3 for more than five seconds.
When the door is closed, all the doors and the tailgate will be locked.
Unlocking the vehicle from the outside is only possible with the RENAULT card in the vehicle's access zone or using the key integrated in the RENAULT card.
Door and tailgate status indicator
With the ignition on, the warning light integrated in switch 3 informs you of the locking status of the opening elements:
- indicator light on, the doors and tailgate are locked,
- indicator light off, the doors and tailgate are unlocked.
When you lock the doors, the indicator light remains lit and then goes out.

Dec 12, 2015 | Renault Megane Cars & Trucks

1 Answer

Central locking 2005 subaru liberty stopped working on 2 doors


1. Replace battery in remote
2. Replace sensor at rhf door lock (it is inside of door)

Apr 30, 2014 | Cars & Trucks

1 Answer

92 Toronado headlight doors don't seem to stop when doors are closed.


I would check the headlamp door open and close relays first. One or both of them may be bad. It might be a bad headlamp door motor assembly as well. Is there anything blocking the doors from closing all the way? Have you tried closing and opening them manually? You can remove the rubber boot from the door motor knob and turn it by hand.

Apr 10, 2014 | 1992 Oldsmobile Toronado

1 Answer

Mercedes GLK door


vacumn pipe perished if a older version

Dec 17, 2013 | 2012 Mercedes-Benz GLK-Class GLK350 4dr...

1 Answer

Left front door switches don't work


Try the switches while moving the door open and closed, it is starts to work and stops then you have a broken wire in the harness from the body to the door that runs through the rubber boot from the A pillar to the door frame.

Jun 14, 2012 | 2005 Buick LeSabre

1 Answer

My driver side door lock and window stopped working and time when i turn off engine i used to be able to listen to radio and close other windows that stopped also. this all happened at the same time


Hi, You most likely have a broken wire in the door jam area inside the rubber acordian boot. See the pleated boot aprox 2" in diameter near the hinges when you open the door? Well pull the boot back at one end and check the wiring inside of it. If you find the broken wiring (sometimes more than 1) you CAN repair them right there but expect it to break again. I usually remove the kick panel inside the truck and replace the broken wire all the way through the door jam area inside the door so the repair area is not in the constant bending area. Wire fatigue is what causes this problem from opening and closing the door. Check there first and let me know if you need more assistance as i can give you wire colors and fuse locations as long as you can test the areas with a test light. Good Luck , Scott
Please rate my response , Thank you.

Sep 17, 2011 | 2004 GMC Envoy

1 Answer

Every doors power windows will not work, I am thinking its a fuse or a relay because I do not understand how every door just stopped working. My wipers still work though as I read in a post how the fuse is...


The power windows do not use a fuse rather its hooked to a automatic reset circuit breaker, this is so it would reset after a fault, the first place to look which is the most common reason for all windows to stop working at once, open the driver door and look in the center of the door in the location of the hinges, you will see a rubber type boot that contains the wiring for the drivers door controls. you will need to slide boot back and check each wire, you will find a broken wire or two. this happens from opening and closing of the door and is common. good day.

May 27, 2011 | 2002 Mercury Sable

1 Answer

Passenger window operates intermittingly. When it


The problem could be in the master window switch on the drivers door, or the window motor could be going out, but most likely the cause is a broken wire inside of the weather boot that runs between the door and the body of the vehicle, and the broken wire is making intermittent contact because the door is being opened and closed all the time, and sometimes the wire will touch and make the connection and that is why it only works sometimes.

Try this the next time that the window stops working, hold the window switch down in whatever direction that you want the window to go (up or down) and while holding the switch in that position open and close the drivers side door and move or wiggle around the weather boot that contains the wiring that is between the door and the body of the vehicle, and do the same for the passenger side door, if the window starts working while you are holding down the window switch and opening and closing the door or moving around the weather boot between the door and the body of the vehicle, then there is a broken wire or even wires that will need to be repaired.

The broken wire can be on either the passenger side, or most likely on the drivers side, and if you do find a broken wire or wires, then you should repair the wires by soldering them well and use the same gage wire if you need to lengthen the wire to repair it successfully, and do not use a wire connector if you want the repair to last.

Jun 02, 2010 | 1996 Plymouth Voyager

1 Answer

Dash lights showing door open they arent


have tried all the switches to make sure they are working or turning off when doors ect shut

Jun 05, 2009 | 2000 Ford Focus

Not finding what you are looking for?
2015 Mercedes-Benz GLK-Class Logo

Related Topics:

22 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mercedes-Benz Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

yadayada
yadayada

Level 3 Expert

76649 Answers

Michael Contreras
Michael Contreras

Level 2 Expert

166 Answers

Are you a Mercedes-Benz Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...