Question about 1992 Honda Accord

1 Answer

I have a honda accord its a 1992 standard 2.2 motor I need a full video step by step how to change my ignition switch

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Honda Master
  • 12,158 Answers

Buy a repair manual !

Posted on Dec 14, 2016

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get 2 Free calls (no credit card required) and instant help on almost anything you can think of (from cars to computers, appliances, handyman, and even pets).
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 88 Answers

SOURCE: 1992 honda accord reset switch for fuel pump

can be in about three different locations under the hood or inthe boot behind one of the panels or in the driver or passenger footwell behind the panels should have a picture of an engine at its location.

Posted on Oct 27, 2008

SOURCE: how to change an alternator in 1983 honda accord

If your radio is coded, make sure you have the code and know how to re-enter the code in the radio.

  • Remove both battery cables and secure them away from the battery terminals.
  • Detach the E, F and N plug from the the alternator.
  • Slacken the alternator mounting bolts and move the alternator forward towards the engine.
  • Remove the drive belt.
  • Now undo all the mounting bolts and lift the alternator clear of the vehicle.
Re-fitting is just the reversal of the removal.

Posted on Dec 01, 2008

breddi2
  • 126 Answers

SOURCE: need to replace radiator in 1997 honda accord se. what are the steps?

First drain radiator by opening drain valve,"located on bottom corner usualy the right,but not always." If you open the overflow or remove cap this will happen much faster.For safety sake disconnect ground wire from battery,the radiator is locked down by top cover that attaches to body with generaly 4 bolts, upper and lower hoses have to be disconnected and if it is automatic the transmission cooling lines are connected in stacked fashion,"one above the other."The cooling fan has to be unplugged and it should be removable at this point,"when unplugging fan be carefull with connector so it doesn't break.reverse steps to replace making sure the bolts go in the right place and it all fits properly.the thermostat,"located behind the kneck of upper hose," should be replaced after connecting lower hose because in order to fill the block up and prevent damaging thermostat the block shoud be filled with coolant before attaching upper hose.

Posted on Apr 20, 2009

  • 1 Answer

SOURCE: Tire Size for a 1992 Honda Accord

they should be 14" tires

Posted on Jun 14, 2009

  • 113 Answers

SOURCE: 1992 Honda Accord (LX) Instrument Cluster Replacement

Same as 2 dr, or a stick.
There are bezel screws that hold the plastic trim (pointing up towards the windshield), you nee to remove these 2 screws. The bottom section is clipped in. Tilt the steering wheel down as far as it will go.
Once you have the bezel off, there are 4 screws holding the cluster to the dash. Remove them and gently pull the cluster forward. Reach around (expect to get scraped knuckles) and unclip the speedo cable, and two large multipin connectors. Don't force anything.
Getting the cluster out after this point is a test of your patience. It only seems to come out one particular way.

Posted on Aug 22, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

1999 Mercury Cougar, the lower grill is said to be pull off/snap back. As I don't want to break tabs can anyone state how to go about this please?


How do I get videos with step for step on how to change my ignition switch on my 92 Honda accord 5 speed 2.2 motor

Dec 14, 2016 | Mercury Cougar Cars & Trucks

1 Answer

Trouble starting accord


well do it.?
need the steps?
is that it?
alldata.com
what i do is look at the switch and adjust it for full compession
at pedal up.
on some cars, there is a jam nut there. and it falls off
and the switch unscrews and changes daily.
only looking and touching works and using any Ohm meter to
test the switch and for consistancy.
all that is hands one.

Jan 18, 2014 | 1990 Honda Accord

2 Answers

Where is the location of the igniter, on a 1992 Honda Accord 2.2L?


inside the distributor.2 screws and four wires attach it to electrical

Aug 13, 2013 | 1992 Honda Accord

1 Answer

I have92 Honda accord ex I can push start run great wont start with key new battery and new starter and fuses and relays what could be wrong


ignition switch is worn out its under dash on steering colum either install push button to start or replace also if its standard check clutch pedal sensor

Feb 16, 2012 | 1992 Honda Accord

1 Answer

If I put a 1995 honda accord engine in my 1992 honda accord will it fit and hook up up to my wireing harness?


I would put your intake manifold and engine harness on the '95 motor. You may also need your Air Conditioner and mounting bracket. Keep your old motor right beside you and switch anything that is different. Notice the O2 sensor(s), etc.

May 21, 2010 | 1992 Honda Accord

1 Answer

1992 Honda Accord - check engine light comes on when I drive down the road and then it stalls when the car comes to a stop


my 92 honda accord check engine light comes on and the car dies and won't restart. need help/ changed the ignition swith.

Dec 04, 2009 | 1992 Honda Accord

2 Answers

!995 Honda Accord won't stay running unless it is in the starting


your starter switch is bad. it is on the coloum. needs to be replaced.

Aug 14, 2009 | 1992 Honda Accord

2 Answers

1992 Honda Accord died


Ignition coil, transistor, rotor, distributor cap or other component in ignition circuit like ignition switch- may crank but no spark. In that order. Good luck.

May 09, 2009 | 1992 Honda Accord

Not finding what you are looking for?
1992 Honda Accord Logo

Related Topics:

23 people viewed this question

Ask a Question

Usually answered in minutes!

Top Honda Experts

yadayada
yadayada

Level 3 Expert

76649 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...