Question about Cars & Trucks

Open Question

Does masterkey lock gas door at driverside..could not unlock it. frozen

Posted by on


6 Suggested Answers

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

  • 1810 Answers

SOURCE: auto door lock on driverside is making aloud noise and will not o

sounds like a striped gear to me replace the power lock

Posted on Jan 23, 2010

  • 81 Answers

SOURCE: 2006 bmw 325i remote only unlocks driverside door.

fuse 56 and 57 control central locking,the issue is caused by surges typically in the front door lock actuators, normally at a dealer they would replace fuse 56 and 57 with a 20a mini fuse and if still occuring repl the door lock(s) that dont work or typically both front, first replace fuse 56 and 57 with 20a fuses as were too small from factory and than operate ten to 15 times, if it doesnt work at first dont panic,let the car go to sleep which takes about 16 min and than try again this problem has nothing to do with the key fob or the lock unlock button inside,also the fuses are located behind the glove box just rere the access panel and they are found at lower left section

Posted on Mar 27, 2010

  • 172 Answers

SOURCE: all my window doors manual buttons work except my

for a starting point,open the door look in the front see if the hose is chopped in two,
if okand looks intacked,
replace the main door switch

Posted on Apr 16, 2010

  • 52 Answers

SOURCE: My door on the driverside will not lock or unlockwith the remote all other doors work ok

does it work with the switch (both drivers and passengers side?)

It could be the actuator is burned out its self if it doesn't work at all, or you have a broken wire in the door boot.

Other option is its a fault of the BCM. The door lock communications is a data signal on the cars CAN network... when do remote starts on a 01 GM product I use an interface module that will control the door locks, otherwise on certain models you have to wire into the circuit board in the drivers window switch as its the main control for the door locks when using the switch

Posted on Jan 07, 2012

  • 1 Answer

SOURCE: How can i fix a door that won't unlock on a 2002 Lincoln LS I can hear the lock trying to unlock but isn't unlocking door on rear driverside ,I have had this happeh on the other side as well but was a

This is usually caused by a broken actuator motor. You should be able to find the replacement part online and change it yourself of have someone change it for you. I've changed 2 so far on my 2003 Mazda and it was not the easiest to do since there is very little space inside the doors to work but it is doable. Look for instructions regarding the specific model to see where the actuator motor is located and how to replace it.

Posted on Jun 30, 2014

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Can't open door to put fuel in.

Hi could be frozen make sure doors of v?hicule are all unlocked gas doors can lock at same time as u r doors if frozen u can run hot water to unfreeze the door and then dry it off as much as possible. Good to know what kind of v?hicule. Bmw and Audi locks with the power lock system key in door should unlock all. Hope it helps

Dec 26, 2017 | Cars & Trucks

1 Answer

True or false does masterkey affects the locking of fuel lid on driverside beneath the floor

I do not think so . but when in doubt call a dealer of your make and ask them , or read your owners manual

Dec 14, 2016 | Cars & Trucks

1 Answer

I have a olds silhouette 2000 3.4. On my driverside I bought the lock and unlock switch thinking it was damaged. But it does the same thing like the old one it unlocks but doen't lock why?

Possible broken wiring in drivers door where it exits door and enters vehicle. The wiring flexes each time door is opened and can cause wiring issues.Inspect wiring for damage in this area

Jul 09, 2015 | Cars & Trucks

1 Answer


try using a little graphite in the keyhole. If key turns and does nothing, may have a bad lock mechanism or a rod had fallen off inside. See that the lock turns freely. Don't force. Door will unlock from inside and still have a bad lock mechanism.

Jan 19, 2013 | Cars & Trucks

1 Answer

My driverside door will not allow me to use my key to unlock when i turn the key to unlock the key just spins around what is the part where key unlocks the door called and how can i fix it

The linkage between the lock cylinder and the lock assembly has broken or simply come loose because of a broken or faulty retaining clip.

Apr 03, 2011 | 2002 Dodge Stratus

1 Answer

1995 GMC Suburban. The interior power door lock switches not work

Take The Driverside Control panel Off The Door,And Check Conection On The Main Switches,These Vehicles Have Locks On Them, And If They get loose The Stop Working,Also Check The Little Switch Towards The Front of Panel,It Also May Be Loose,Use Caution,The Clips Are Fragile..

Nov 05, 2009 | 1995 GMC Suburban

1 Answer

2003 Tiburon power locks keep automatically lock

replace both door lock actuators to fix problem.

Aug 31, 2009 | 2003 Hyundai Tiburon

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

12 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts


Level 3 Expert

80531 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

john h

Level 3 Expert

15360 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides