Question about Buick Cars & Trucks

1 Answer

2006 buick wiper will not stop - Buick Cars & Trucks

Posted by on


1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Top Expert:

    An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.


    An expert that got 20 achievements.


    An expert that got 10 achievements.

  • Buick Master
  • 8,211 Answers

1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

2006 buick rendezvous when turn on wipers they move very siow and stop half way up

Most likely the wiper transmission. It has plastic bushings that can deteriorate. Inspect the bushings and all are ok, suspect a bad or burnt motor at that position.

Mar 14, 2018 | Buick Cars & Trucks

1 Answer

The rear wiper on my 2006 Buick Rendezvous does not apply enough pressure upon the surface of the glass for the wiper blade to clean water. It skips over the water.

lift arm away from screen if blade and arm pressure spring intact and working, bend arm inwards to increase pressure

Mar 03, 2014 | 2006 Buick Rendezvous

2 Answers

Wiper blade slipped loose in heavy rain.

Unplug the electrical connector at the wiper motor. Use a voltmeter to check for power and ground on the Pink and dark green wires. This setup has two relays: hi speed and low speed. If you're not getting power and ground with IGN switch on RUN and wipers turned on, then yank the relays and check for ground to the relay control coils provided by the body control module. The wiper switch acts as a signal to the BCM to provide ground to the relays. The switch doesn't actually switch power to the relays.

Aug 05, 2017 | Buick Cars & Trucks

1 Answer

How do I replace the rear wiper motor on a 2006 Buick Rendezvous?

there will be an access panel under the trim. remove trim and access panel, wiper arm, replace motor and reinstall.

Jul 26, 2011 | 2006 Buick Rendezvous

1 Answer

Passenger side wiper blade does not run on 2006 lacrosse

On lower side of wiper arm (closest to windshield) is a nut that has probably come loose. They do this when someone has forced frozen wiper. Tighten nut. It's under a flip up cap

Feb 13, 2011 | 2006 Buick LaCrosse

1 Answer

How do I replace the wiper blades on my 2006 buick rendezvous? the driver's side blade was knocked loose and came unhooked when I was scraping ice off my windshield earlier today. How do I put the blade...

look on the other wiper blade on the opposite side
and notice how it fits. Maybe even try to take it off. this should teach you how to put it on, it should slip into the u grove and clip.

Feb 10, 2010 | 2006 Buick Rendezvous

1 Answer

Wipers stopped

It is possible that the wiper motors are burnt out. Its funny, lately Ive been seeing lots of those cars from that year having the same problem so to save you the trouble of troubleshooting find the part which is easy and the mechanics to install it also easy DARN LABOR FEE.well GOOD LUCK.

Aug 23, 2009 | 1995 Buick Century

1 Answer

2006 kia wipper works but stops in the middle of the windshield

It sounds like the the circuit board has gone bad and does not know where the base is any more so it will stop at the middle or the windshield. Auto Zone should have a new board if it's replaceable like the GM products. Good luck and hope this helps, In the mean time you can always turn your wipers on and pull the fuse out when it's at the down position so it's not up.

Jul 11, 2009 | 2006 Kia Amanti

1 Answer

2003 Buick. The pass side wiper stopped working,

the arm mechanism has a clip that pop off get a new clip and remove the access panel and move the arm over to the access area put the arm back into the hole socket and reattache clip , not the easiest repair but with a long pair of needle nose pliers you should have a better chance to complete repair. Some cars to access the arm the wiper motor must be disconnected and pulled out slightly then move wiper over and reattache pin arm into lever hole nstall clip.

Jul 08, 2009 | 2003 Buick Regal

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

19 people viewed this question

Ask a Question

Usually answered in minutes!

Top Buick Experts


Level 3 Expert

78257 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Buick Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides