SOURCE: My RX 330 rear hatch closes. But when I put it in
Sounds like either the hatch is not closed completely or the switch is says the door is still open. verify if the door is shut tight.
SOURCE: How do you align a door on a Ford pick-up so that
Please follow the instructions below, but before u loosen the hinges try adjusting the door striker bolt slightly inboard on the door jamb, u will need a T50 3/8 Drive Male Torx Sockert to to do this adjustment, if the moving of the striker inboard to increse closure force works don't fool with the hinges adjustment. Open the door and make sure it's properly supported. The best way is to have a second person hold onto it. You can also place and raise a jack under the door, but place rags on the jack first to prevent scratching the paint. Loosen the mounting bolts with a socket wrench on one side of the hinge--either the door side or the body side. Move the door in whichever direction you feel it needs to be moved (up or down are most likely), and tighten the bolts with the door in its new position. Check the door's new position. It needs to be aligned so the top of the door lines up with the top of the fenders and the bottom lines up with the lower rocker panel. If not, repeat Step 2 until it is aligned. Use body alignment shims if you can't properly adjust the hinges by themselves. Loosen the hinge bolts, and insert the shims behind the hinges. Adjust the door striker on the door jamb if necessary. The striker's bolts should require a Torx or hex wrench. Loosen the bolts, tap the striker in the needed direction--up, down, left or right--and tighten the bolts back.
Instructions
Things You'll Need:
SOURCE: 207 cc drivers window won't close
the motor in the drivers door is probably bad. check to make sure it has power and ground with a test light at the motor with the wires unpluged.
SOURCE: My Lexus RX 330 back power door won't stay open, it keeps closing.
check the switch at the door and the on the inside
27 views
Usually answered in minutes!
×