Question about 1992 Buick Park Avenue

Open Question

I don't have heater buick pak ave 1992 - 1992 Buick Park Avenue

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get 2 Free calls (no credit card required) and instant help on almost anything you can think of (from cars to computers, appliances, handyman, and even pets).
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 4 Answers

SOURCE: 1992 buick park ave

have you replaced your ignition module?

Posted on Oct 04, 2008

Ad
countrysi248
  • 443 Answers

SOURCE: DEAD SHORT #11FUSE IF NOT REMOVED COULD BE HEATER

got to be something left on though like cigarette lighter stuck in somewhere or interior light on or maybe light under hood or maybe trunk ? you mean the battery goes dead if you dont remove that fuse right ? thanks Jerry holler back if you need more.

Posted on Jan 30, 2009

  • 2920 Answers

SOURCE: Heater Core Replacement for 1986 Buick Electra Park Ave

there is no easy way to change out a heater core...you have to take the bottom part of the dash loose and that takes some doing. once you get the bottom of the dash apart you will see the heater core.then you have to go under the hood and unhook both water lines that run to it, you should then be able to pull the heater core out and install the new one

Posted on Feb 09, 2009

Sgt Fluffy
  • 157 Answers

SOURCE: location of fuse or actuator for door lock on 1992 Buick Park Ave

Is it an actuator itself? If the lock clicks but really doesn't lock or unlock it could just be a linkage problem. There are some little plastic doohickies on the ends of the linkages that wear out and drop off. You can get those in the right auto parts store. Do all the door locks not work? Then, yes it could be the fuse. Usually a diagram on the fuse box cover, or even printed next to the fuse. If one door lock doesn't work, does it not work from just one switch or both switches? If it works from one switch, then of course it's the other switch. If it's the drivers door lock, then of course there's only one switch. (More often, it's a switch, not an actuator.) The drivers door switches come in a pad of four. It'd be cost-effective to get a used pad from a salvage yard. They can be checked with an ohmmeter right there, and they'd probably do it for you. Or take yours along. You'll have to remove the door panel at any rate. You'll need a Phillips screwdriver, and there's a nifty tool at the parts store for prying the clips on the back of the panel out of the door shell. You might want to find a local shade tree mechanic to guide you or do the job. It helps to be a little double-jointed. Price that stuff new, let your wallet and patience be your guide.

Posted on Jun 11, 2009

  • 224 Answers

SOURCE: where is the fuel filter on a 1992 buick park ave.

inline fuel filter under car

Posted on Jul 30, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Have a 2000 buick park ave. after changing plugs and wires check engine light still on. computer code says misfiring number 5. What part needs changing? Im thinking the coil?


Yes start with the coil pak. There are three located on the front of the engine on the pass side, you probably know this. They are marked as to which cylinder each wire goes to, disconnect the wire for #5 cylinder, and if the engine misfire does NOT change, it is more than likely that Coil Pak. Replace it, and use dilectric grease on the two contacts when reinstalling it. Now, I have stumbled on this issue many times and if that does not cure the issue (I think it will), the coil module below the coil pack is probably bad...To remove this module, remove the coil paks, the electrical connector in front (has bolt holding it in) and I remember one bolt holding the module to the aluminum bracket.

Again, to be sure you can switch coil paks around to make sure it is a coil pak. When you switch the bad with a good, the misfire will follow the coil pak, if it does not it is the module.]

Hope this helps.

Oct 04, 2010 | 2000 Buick Park Avenue

2 Answers

1992 buick lesabre dosnet wana turn over right away when started also dies when i will be driving but starts back up


Remove battery cables from battery and clean the connections on all three of them ,replace both bolts to fix.

Apr 27, 2010 | 1992 Buick LeSabre

1 Answer

1992 park ave transmission slips fluid and


It probably did not slip before the fluid was changed I so the clutches are worn out and need to be replaced The worn fibers were still in the old fluid causing the fluid to be thicker filling the voids much better to shift. Now once drained and new fluid installed it slips

Apr 27, 2010 | 1992 Buick Park Avenue

1 Answer

1996 buick park ave. , heater fan for inside


the ac computer is on the fritz or the ac control panel has a short in it

Jan 19, 2010 | 1996 Buick Park Avenue

1 Answer

Where is the climate control blower relay for the a/c located on my 1990 buick park ave? the blower keeps blowing even when the ignition is turned off.


The relay assmbly is located on the heater case under the hood in the same area as the blower motor its fairly big 2 or 3 7mm hex screws hold it in. its a module on the top of the case with 2 connectors on it guarantee this should fix it..

Nov 24, 2009 | 1992 Buick Park Avenue

1 Answer

Transmission is in my 1995 buick park ave


open the hood, look at the trans, most transmissions have a service tag, look for the service tag, may need to cimb under the car also to find it

Oct 25, 2008 | 1992 Buick LeSabre

1 Answer

1992 buick park ave


have you replaced your ignition module?

Sep 02, 2008 | 1992 Buick Park Avenue

Not finding what you are looking for?
1992 Buick Park Avenue Logo

Related Topics:

16 people viewed this question

Ask a Question

Usually answered in minutes!

Top Buick Experts

yadayada
yadayada

Level 3 Expert

76649 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8518 Answers

Are you a Buick Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...