Question about Buick LeSabre

1 Answer

Rear lights staying on

2002 lasabre engine of,key removed

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Top Expert:

    An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

  • Buick Master
  • 35,669 Answers

The brake light switch may be stuck

Posted on Dec 14, 2016

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2002sts wont start getting one click and abs and traction control light stay on


Is the battery , battery cables , and connections all good ? The ABS and the traction control lights being on wouldn't have anything to do with not starting . The check engine light should be on with the key in the on position , should stay on till the engine is cranked over . The battery is under the rear seat .

Dec 14, 2016 | 2002 Cadillac Sts

1 Answer

My Buick Lasabre want start the scerity light stays on


Assuming the light is not flashing, you probably have a bad decoder module and that will require a new, unused module to resolve it.If it's flashing it could be a key or key sensor issue.

Aug 07, 2015 | 1995 Buick LeSabre

1 Answer

Renault trafic headlights stay on


the switch has gone bad would be my first guess

Apr 11, 2014 | 2009 Renault Trafic 1.9dCi

1 Answer

Need to replace the rear O2 sensor in a 2002 buick lesabre


Remove the erg valve and shake it if there is no sounds then you either need to clean it with Carb Cleaner or buy a new one!

Sep 28, 2012 | 2002 Buick LeSabre

1 Answer

2002 f350 will not shut off with key. with key removed dash lights stay on and engine continues to run must pull injector relay to shut down. the dash lights stay on as if you turned the key to accesory...


ok well this is where you might be incorrect... either you have a 12 volt wire bleeding scross or you have a bad ignition switch. the run wire off the ignition switch is the only thing that will keep it running unless you have a remote start then of course that could keep the engine running. you might want to start by making sure the ignition switch is beaking the signal to the PCM.

Aug 27, 2011 | 2000 Ford F350 Super Duty Super Cab

1 Answer

1998 Buick LaSabre LTd. 18,000 miles (no kidding). Engine light came on. Replaced gas cap & engine light stayed off for about a week. Engine light back on. Any suggestions?


Stop at Auto Zone or advance Auto and ask them to read the codes for you. That will give you a better idea of where to start.

Mar 02, 2011 | 1998 Buick LeSabre

2 Answers

How do i replace the rear turn signal bulb on a 1998 buick lesabre?


There are usually only 2 ways to replace tail lights -- either unscrew the lens from the outside if there are screws showing, or, (more likely with this older model), open trunk, find the access panel and remove it, then reach in and unscrew the light socket by turning 1/2 turn counterclockwise.

Jan 25, 2011 | 1998 Buick LeSabre

1 Answer

2003 Prius sometimes will not start, engine light comes on. Removing key from ignition, reinserting key, & turning wheel till it locks will then allow the car to start. Engine light stays on for a


I had a wire connector on the front of the engine that had so much tension, the wires broke. I didn't notice until a wet day when the car wouldn't start (and the Check Engine light was on). (The error code was related to an Emissions error.) The connector is located on the engine, front, just left of center. Hope this helps!

May 25, 2009 | 2002 Toyota Prius

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

17 people viewed this question

Ask a Question

Usually answered in minutes!

Top Buick Experts

yadayada
yadayada

Level 3 Expert

76649 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8522 Answers

Are you a Buick Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...