Question about Mazda B3000

Open Question

My2001 was tested an they said i need a module its a b 3000 manual transmission 6 cyl i have no 4 wheel drive no lights. Come on to show it goes into 4 wheel drive. an where is it located

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad
dgjtex
  • 405 Answers

SOURCE: I have a 1979 Chevrolet

Remove caliper and nut to axle should come of with a little help of a rubber hammer. Knock bolts out from the front and drive new ones in from the back. You can use a lugnut with the flat side down to help pull them in and a hammer to help. Hope this helps.

Posted on Dec 26, 2008

Ad
  • 1 Answer

SOURCE: 4 wheel drive on 02 chevy silverado not working

There is a solinoid on the front differential that shifts the front in and out of 4wd, that could be it.

Posted on Jan 02, 2009

  • 1779 Answers

SOURCE: Where can I find a free owners manual or a free

Go to this site, you will have to sign in and enter your car info, and you should be able to download the manual for free , Let me know if you have any trouble getting the info. Curt
http://www.gm.com/gmownercenter/chevy/

Posted on May 01, 2009

CMV9
  • 594 Answers

SOURCE: where is 2005 mercury mountaineer fuel filter

Fuel filters can usually be found on the drivers side under carriage about middle of the vehicle. There should be a canister type filter with 2 metal lines connected to it. One on both sides of the canister. you will need to disconnect both lines and the bracket that holds the filter in place and install the new filter. I do suggest that you remove the fuel cap to try and relieve some of the fuel pressure built up in the lines before disconnecting the filter so you won't be sprayed too much with fuel. If you have any other questions please do not hestitate to ask.

Thank you for choosing fixya and please rate and comment about your experience today.

Posted on Dec 27, 2009

Testimonial: "great answer! Thank you very much."

wcbotha
  • 92 Answers

SOURCE: 2001 kia sportage 4x4 trouble

Check front wheels there is 2 pipes going to the wheels 1 is for brake fluid to the callepers and the other one is for vacume suction to ingage or dis ingage the free wheel function 99% of the time this pipe is leaking or it is broken. enjoy !! Willem SA

Posted on Feb 23, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I just bought a 2003 superduty crew with a 6.0 diesel it will not go into 4 wheel drive. i have replaced the vacuume pump and the solinoid (they were bad) I have no power to the switch in the dash. i have...


What large square fuse ? The 4X4 switch get's it's B+ voltage from the four - wheel drive control module . computer controlled ! Has two relay's - transfercase hi to low & low to high ,located in the Auxiliary relay box #3 . location left side of radiator core support . Your best bet ,take it to a qualified repair shop that has a diagnostic tool that can communicate with the 4X4 control module . Read code's ! Probably has a code like one of these
P1812 Transmission 4-Wheel Drive Mode Select Circuit Failure 4WD control module Go To Pinpoint Test D . P1815 Transmission 4-Wheel Drive Mode Select Short Circuit to Ground 4WD control module Go To Pinpoint Test A .
But code have a few others as well .
B2105 Throttle Position Input Out of Range Low 4WD control module Go To Pinpoint Test B . B2106 Throttle Position Input Out of Range High 4WD control module Go To Pinpoint Test B . C1728 Transfer Case Unable to Transition Between 2H and 4H. 4WD control module Go To Pinpoint Test C . C1729 Transfer Case Unable to Transition Between 4WD HIGH and 4WD LOW 4WD control module Go To Pinpoint Test D . C1979 IWE Solenoid Circuit Failure 4WD control module Go To Pinpoint Test F . C1980 IWE Solenoid Short to Battery 4WD control module Go To Pinpoint Test F . P1812 Transmission 4-Wheel Drive Mode Select Circuit Failure 4WD control module Go To Pinpoint Test D . P1815 Transmission 4-Wheel Drive Mode Select Short Circuit to Ground 4WD control module Go To Pinpoint Test A . P1824 Transmission 4-Wheel Drive Clutch Relay Circuit Failure 4WD control module Go To Pinpoint Test A . P1826 Transmission 4-Wheel Drive Low Clutch Relay Short Circuit to Battery 4WD control module Go To Pinpoint Test A . P1827 Transmission 4-Wheel Drive Low Clutch Relay Short Circuit to Ground 4WD control module Go To Pinpoint Test A . P1849 Transmission Transfer Case Contact Plate A Short Circuit to Ground 4WD control module Go To Pinpoint Test D . P1853 Transmission Transfer Case Contact Plate B Short Circuit to Ground 4WD control module Go To Pinpoint Test D . P1857 Transmission Transfer Case Contact Plate C Short Circuit to Ground 4WD control module Go To Pinpoint Test D . P1861 Transmission Transfer Case Contact Plate D Short Circuit to Ground 4WD control module Go To Pinpoint Test D . P1867 Transmission Transfer Case Contact Plate General Circuit Failure 4WD control module Go To Pinpoint Test D . P1891 Transmission Transfer Case Contact Plate Ground Return Open Circuit 4WD control module Go To Pinpoint Test D .

Nov 27, 2017 | 2003 Ford F250 Super Duty Crew Cab

1 Answer

My 99 expedition won't stay out of all wheel drive I changed the transfer case motor and now it stays I awd for about 10 minute then kicks back out and then the 4x4 light flashes and then it is ok until...


The 4X4 system on your vehicle is computer controlled , GEM module . generic electronic module . The four wheel drive mode switch is a low voltage input to the GEM module . The GEM energizes relay's to control the mode as depicted by input from the mode switch an torque on demand relay an someother inputs . Probably has DTC - diagnostic trouble codes stored in the GEM module .
Transfer Case -Automatic Four-Wheel Drive (A4WD) The automatic 4-wheel drive transfer case system consists of the following:
  • automatic 4WD indicator light
  • brake pedal position (BPP) switch
  • torque on demand (TOD) relay
  • front output shaft speed sensor
  • generic electronic module (GEM)
  • 4WD high indicator light
  • 4WD low indicator light
  • 4WD mode switch
  • rear output shaft speed sensor
  • shift position sensor
  • throttle position output (TPO) from the powertrain control module (PCM)
  • transmission range sensor P1804 Transmission 4-Wheel Drive High Indicator Circuit Failure GEM REFER to Section 413-01 . P1806 Transmission 4-Wheel Drive High Indicator Short Circuit to Battery GEM REFER to Section 413-01 . P1812 Transmission 4-Wheel Drive Mode Select Circuit Failure GEM REFER to the Symptom Chart. P1815 Transmission 4-Wheel Drive Mode Select Short Circuit to Ground GEM GO to Pinpoint Test C . P1820 Transmission Transfer Case Clockwise Shift Relay Coil Circuit Failure GEM GO to Pinpoint Test B . P1822 Transmission Transfer Case Clockwise Shift Relay Coil Short Circuit to Battery GEM GO to Pinpoint Test B . P1824 Transmission 4-Wheel Drive Clutch Relay Circuit Failure GEM GO to Pinpoint Test A . P1826 Transmission 4-Wheel Drive Low Clutch Relay Circuit to Battery GEM GO to Pinpoint Test A . P1828 Transmission Transfer Case Counter Clockwise Shift Relay Coil Circuit Failure GEM GO to Pinpoint Test B . P1830 Transmission Transfer Case Counter Clockwise Shift Relay Coil Short Circuit to Battery GEM GO to Pinpoint Test B . P1836 Transmission Transfer Case Front Shaft Speed Sensor Circuit Failure GEM GO to Pinpoint Test A . P1837 Transmission Transfer Case Rear Shaft Speed Sensor Circuit Failure GEM GO to Pinpoint Test A . P1838 Transmission Transfer Case Shift Motor Circuit Failure GEM REFER to the Symptom Chart. P1846 Transmission Transfer Case Contact Plate 'A' Circuit Failure GEM REFER to the Symptom Chart. P1850 Transmission Transfer Case Contact Plate 'B' Circuit Failure GEM REFER to the Symptom Chart. P1854 Transmission Transfer Case Contact Plate 'C' Circuit Failure GEM REFER to the Symptom Chart. P1858 Transmission Transfer Case Contact Plate 'D' Circuit Failure GEM REFER to the Symptom Chart. P1866 Transmission Transfer Case System Concern - Servicing Required GEM REFER to the Symptom Chart. P1867 Transmission Transfer Case Contact Plate General Circuit Failure GEM REFER to the Symptom Chart. P1874 Transmission Automatic Hall Effect Sensor Power Circuit Failure GEM GO to Pinpoint Test A . P1875 Transmission Automatic Hall Effect Sensor Power Circuit Short to Battery GEM REFER to the Symptom Chart. P1891 Transmission Transfer Case Contact Plate Ground Return Open Circuit GEM REFER to the Symptom Chart. P1892 Trans. Automatic 4-Wheel Drive 4X4 Mechanical Lock Output Circuit Failure GEM GO to Pinpoint Test B . P1893 Trans. Auto. 4-Wheel Drive 4X4 Mechanical Lock Output Short to Battery GEM GO to Pinpoint Test B .
  • Your best bet , take it to a qualified repair shop .

Feb 26, 2018 | Cars & Trucks

1 Answer

1988 Toyota 4 Runner 3.0, 6 cyl. Automatic transmission has shifting issue where sometimes won't upshift past 2nd. With overdrive button on, goes completely out of gear once past about 3000 rpm. With...


your flex plate is going out and it sounds like you need to relace the tranny fluid in it drain the old and put in new i beleave the fluit type is dex tron 3

Jan 05, 2011 | 1988 Toyota 4Runner

1 Answer

I got my 2002 chevy blazer with ZR2 package into deep water and shorted out my 4 wheel drive control module (located under the kick plate on the passenger side). I took the module out and had it replaced...


what sounds like is happening is the front end is not disengaging, it will not hurt it to drive without the module, but you need to find out why the front diff. actuator is not releasing. their is a shift motor on the transfer case, module and switch in the cab, and actuator on the front diff. all are susceptable to water, I would suggest getting a manual on it to aid in diagnostics

Oct 13, 2010 | 2002 Chevrolet Blazer

1 Answer

1992 4Runner 4wd will not engage


check the wires from the shifter for the transfer case they maybe discounected like mine were now mine works fine

Feb 25, 2009 | 1994 Toyota 4Runner

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

17 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mazda Experts

yadayada
yadayada

Level 3 Expert

79865 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8836 Answers

Are you a Mazda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...