Question about Dodge Cars & Trucks
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
a lot of pain and heart ache. even on a rack they are a pain . check with your dealer there wae a recall on them for failing its worth the phone call to see kdc744
Posted on Feb 08, 2009
first off, disconnect your battery for at least 30 min before touching any plugs or harnesses. next, bleed your A/C and disconnect the quick connects that go inside the firewall. drain your coolant, and disconnect hoses from firewall. note a certain bolt with nut on it that is going to the inside of the firewall, you'll need to take that off when you get to the airbox inside the truck which houses your heater core. next, take off the pillar handles next to the windshield, then pop off the plastic dash panel with defroster vents. there are a few bolts up there that need to be taken out all the way across. next, take off your glove box. remove plastic below the drink carrier. there are 2 bolts there on left and right once you remove the plastic. there's a yellow or red AirBag plug which you may or may not need to disconnect later. next, drop down the whole steering wheel column. 4 bolts I believe. look up under there on both sides, you will see a 2inch piece of tubing that goes from each side of the truck. your dash and everything you see in front of you is connected to that tube. find on each side of the truck where that tube is mounted to the body with brackets. There are 2-3 bolts on each side I think. When you get those out, and the steering wheel is sitting in the seat or on the floor, the whole dash and panel should tilt and lay on the seats. there are wires from your a/c controls and radio which you'll have to disconnect and some various other wires as well. I also think you'll have to disconnect a harness plug with bolt in it on the drivers side. (white) after you've done all that and don't have the dash and panel in a bind with wire hangups you can now get to the air box. I don't remember how many bolts, but don't forget the one in the engine bay going to it also. get the box unbolted, then roll it up, remove 2 clips holding the heater core in, replace heater core and do this whole process backwards. Hopefully you didn't lose any screws or bolts. charge your a/c, replace coolant, make sure all plugs are connected before connecting power. Should save you $400-$500 in labor.
Posted on Mar 25, 2009
Posted on Apr 08, 2009
SOURCE: 1999 dodge durango heater core
It's a big job. Drain the coolant down, recover the freon in the ac system and disconnect the lines and heater hoses. Lower the steering column, remove the instrument panel assembly, remove the heater housing. Split the case halves on the housing and there you are. Usually around 500 to 700 dollars at a dealership.
Posted on May 29, 2009
Tips for a great answer:
Feb 08, 2017 | 2011 Dodge Nitro
Dec 22, 2016 | 2009 Dodge Nitro
Jan 27, 2016 | 2007 Dodge Nitro
Mar 10, 2015 | 2007 Dodge Nitro R/T New Cars
Sep 20, 2014 | 2007 Dodge Caravan
Dec 20, 2013 | Cars & Trucks
Oct 24, 2013 | 2008 Dodge Nitro
Jun 02, 2012 | 2007 Dodge Nitro R/T New Cars
94 people viewed this question
Usually answered in minutes!