Question about Cars & Trucks

1 Answer

What is the agonist and antagonist for a goblet squat?

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Top Expert:

    An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

  • Cars & Trucks Master
  • 8,107 Answers
Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Whats the procedure to replacing valve cover gaskets on a 2001 suzuki grand vitara 2.5liter engine?


the steps you want all steps
why not just read the book your self for 4bucks.

posted 100s of times.

https://suzukipitstopplus.com/Products/1191-2001-vitara-grand-vitara-service-manual.aspx

its all there in the book and 4bucks aint squat.

Mar 11, 2015 | 2001 Suzuki Grand Vitara

1 Answer

What Is correct Tyre Pressure for 1990 Toyota Prominent...


Most cars post the tire pressure information on the bottom right side of inside door jam. Just open the drivers door and squat down low enough so you can see it.

Feb 24, 2015 | Toyota Cars & Trucks

1 Answer

Remove back seat of a wm 2008 statesman


Put the front seat all the way forward, stand/squat in front of rear seat, grasp under the front of rear seat on both sides and snatch it quickly upwards. Pressure from bent wire rods hold in in, you just have to overcome this pressure.

Aug 26, 2014 | Cars & Trucks

1 Answer

What happens if the abs motor pack goes bad?


paddel could be hard to push. but your brakes still work. brakes may lockup on you.

Jan 22, 2013 | 1998 Pontiac Grand Am

1 Answer

My honda crx 5 speed will not down shift


No Hydro clucthes on a CRX, cable only, so pumping away won't do squat, as there is no fluid ! Just another typical stock answer that has no truly specific info to the original post. Way to go !!!!

Jul 07, 2012 | Cars & Trucks

1 Answer

Front and back tire pressure when used to pull 24ft. travel trailer


Hi,
I used to run a tire store so I can tell you that this will vary a lot according to how your trailer rides... tongue weight ECT. Do a quick check on the door frame and on the door itself of the truck, sometimes the manufacturer will supply " fully loaded " tire pressure. Also, make sure you are running the same ply tires that are called out on that plate or heavier. If nothing is listed for fully loaded pressure ... then I would start at a couple of pounds less than the max pressure that the tire is rated for. Hook up your trailer with full weight on your hitch. Look and see if it squats the tire more than usual. You don't want very much squatting or you will wear out the side wall of the tire and cause a blow out. Now the front tires should be OK the way they are, but make sure they are of EQUAL PRESSURE. Take a SHORT TEST DRIVE and see how the vehicle rides and performs. If the ride is bone jarring you can decrease the pressure in increments of two pounds at a time until you get a little better ride. This is a play off ... RIDE VS. HANDELING. WATCH FOR TIRE SQUAT ! And remember to check your pressure frequently on the road as it will increase as the tires get warm.
I hope this helps you,
RSMITH972278
P.S. PLEASE REMEMBER TO RATE ME !

Oct 14, 2009 | 1986 Ford F 250

1 Answer

1997 Pontiac Grand Prix - RPM gauge not working. Car stalling out while driving.


I have 19897 Grad Prix that the RPM gage wont work, only some time, i perchesed a manul for the car but is dont tell me squat about RPM gage

Sep 17, 2009 | 1997 Pontiac Grand Prix

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

29 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...