Question about Cars & Trucks

1 Answer

Rear left wheel slanted and got worse drioviong and swerving all over plz help

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Top Expert:

    An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

  • Cars & Trucks Master
  • 42,184 Answers

Wheel bearing failure
suspension rubbers failed
loose or broken suspension part
if you can see that it is not right ,you should be in a suspension shop having it fixed

Posted on Dec 12, 2016

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Whining noise at speed 35/40 left front side wheel 2000 infinity qx4


Try driving at 35/40, so you can hear the noise, try swerving (just a little) to the left, if the noise goes away, when you swerve, you most likely have a bad wheel bearing on that side.

Feb 24, 2015 | Cars & Trucks

1 Answer

How does a bad wheel bearing sound on a lincoln Mkz awd?


due to the awd you cant just jack up each wheel and spin it . when i road test for w/brg noise you listen for a slight whirring hum that increases and decreases with speed or sometime as you swerve back and forth you hear it as the vehical weight shifts side to side (right swerve left w'brg left swerve right w'brg) as a rule but not always . have a passenger sit in the back to help verify front or rear> dont guess and just replace one .
w'brg's come in three flavors cheap mid grade and premium.
the labour to change is the same. my advice dont end up paying for the labour twice buy the better or best , cheap parts cost more in the long run!

Aug 30, 2014 | Cars & Trucks

2 Answers

Humming noise from front right passenger side of chrysler 300, changed the tires and the noise is still there. any suggestions??


typical wheel bearing sound
when you drive, safely swerve on the road from left to right and again. when you swerve right the sound should attenuate when left it should be louder.

Dec 19, 2012 | 2007 Chrysler 300 AWD Sedan

1 Answer

Whining from front left seems to be the tire, steering wheel slightly vibrates when turning left


If you swerve the car back and forth and the sound dissapeers when swerving to the left( reducing the weight on front left tire) this could indicate a wheel bearing problem

Sep 03, 2012 | Ford Edge Cars & Trucks

1 Answer

What noise does wheel bearings make when going out?


They will make a growling sound. Offten times it will be better or worse when swerving left to right down a road.

Jun 14, 2012 | Dodge Cars & Trucks

1 Answer

2000 dodge caravan rear wheel bearing noise


Improve the FixYa experience for everyone by voting. I want you to let me know if the solution(s) suggested were of any value. Constructive criticism is welcomed.

Hi,

I'm Ben and -- hopefully -- I can provide some meaningful assistance.

Discussion

Replacing the rear wheel bearings on these vans is relatively simple pretty simple. However, the first thing that you must do is satisfy your self that it's the bearing and not something rubbing on a tire or something else back there in the rear.

Follow this steps to diagnose the problem:
  1. Jack up the rear of the car
  2. shake the wheel side to side and top to bottom.
  3. if there is any wobble in it then it is a wheel bearing.
  4. However, you cant alway tell by the shake test.
  5. You can also go down the road and swerve side to side (being careful of oncoming traffic).
  6. Iif you swerve to the right and the noise is loudest on the left side.
  7. If you swerve to the left and its louder its on the right side.

How to remove and replace rear wheel bearings.

Before servicing the vehicle, refer to the Precautions Section of your User Manual.

Remove or disconnect the following:
  1. Rear wheel
  2. Brake drum or caliper
  3. Wheel speed sensor, if equipped
  4. Hub and bearing assembly from the rear axle

To install:

Install or connect the following:

  1. Hub and bearing assembly. Tighten the bolts to 95 ft. lbs. (129 Nm).
  2. Wheel speed sensor, if equipped. Tighten the bolt to 105 inch lbs. (12 Nm).
  3. Brake drum or caliper
  4. Rear wheel

May 26, 2012 | 2000 Dodge Caravan

1 Answer

Swerving steering wheel axle left to right


Do you mean the car pulls to one side as you drive, severely?
If this came on suddenly, there is a good chance something has gone wrong. If it has gotten worse slowly It may just need an alignment. I would take it to get the alignment checked. That will reveal any serious problems too.

Mar 10, 2012 | Jeep Wrangler Cars & Trucks

1 Answer

1999 subaru forester growls from rear wheels


Hello, from the sounds of it you have a wheel bearing out. One way to usually verify that it is a wheel bearing is to drive down that road and swerve side to side to transfer the wieght of the vehicle back and forth. If it is a wheel bearing you will notice a change in the sound. If you hear a change in the sound figure out which side it is coming from. If when you swerve right and it's louder or makes more noice then it will be the left bearing and vice versa.

Mar 31, 2009 | 1999 Subaru Forester

2 Answers

2000 Lincoln LS rumble from 40 - 45 mph


See If the pitch changes when you swerve the car from left to right. You don'e have to swerve hard enough to scareanyone, just enough to load one side more than another. If the pitch changes, you likly have a bad wheel bearing or tire. Tires will make any noise a wheel bearing will so switch tires first side to side and see if the problem fgollows the tires. If not then check the wheel bearing.
Also and maybe first:

The fact that the noise is limited to such a narrow speed could also indicate an aerodynamic issue such as a roof rack or bike rack or somthing like that having moved and is now vibrating.

Feb 07, 2009 | 2000 Lincoln LS

1 Answer

Rear end noise from front wheel drive car


At that mileage it could be, and most likely is given your description of the noise. I assume it reduces in volume as you slow down. If you can find a quite piece of road drive up to where the noise is apparent and lightly swerve from left to right. (Don't roll the car!! ) If the noise reduces as you swerve left then its the left bearing. If its when you swerve right that the noise reduces its the right bearing. If its both the only way is to jack the rear up and spin the wheels as fast as you can and listen. If there's a hint of a rumble from it, its that bearing or both. It should be completely quite apart from the slight hiss as the shoes rub on the drum.
35K may not seem much but if you don't know the history of the car it could have hit a bad pot hole or even had a knock on a kerb.
I have replaced bearing with a lot less miles than yours.

Cheers John

Dec 17, 2008 | 2007 Suzuki Forenza Sedan

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

16 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...