Question about Volvo S80

1 Answer

How do you fix error code 3542 in a 1999 S80?

It's a 2.8L engine. I'm not sure where to begin.

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Top Expert:

    An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

  • Volvo Master
  • 33,282 Answers

No such DTC

Posted on Dec 12, 2016

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2006 Raider. Check engine light on-Key not recognized-invalid Vin ??


Begin with the basics........
Check engine lamp illuminated ??
Scan,code(s) stored ??

May 28, 2015 | 2006 Mitsubishi Raider

1 Answer

Error codes P0128 & P0442


Well code 128 is for the engine running too cool. Which is usually a thermostat problem. But it could be the coolant temp sensor.
You may have a different sensor for the gauge and for the computer.
Code 442 is for a small leak detected in the EVAP system. It can be a faulty gas cap, but since you have replace the cap, its probably a hose or gasket. The computer vents the gas tank to the vapor canister when the engine is running. It checks gas tank pressure to make sure all valves are closed when you turn the truck off.

Apr 11, 2013 | 2005 Buick Rainier

1 Answer

P0420 error engine light is on


One or the other. Before I would change out a catalytic converter, I would want the old one tested first to make sure it is bad. Or you might just try a new oxygen sensor on bank 1. Bank 1 would be the driver's side, or whatever side of engine has the number one cylinder-that is bank 1.
P0420: catalyst system efficiency below threshold (Bank 1).

Nov 29, 2012 | Cars & Trucks

1 Answer

I have a 2005 ford expedition 5.4L error code p0304 large vaccum leak fuel system concern ignition system or engine mechanical condition... we had a vacuum leak before but my husband fixed it and I HAVE NO...


try removing the gas cap , and put it back on, I know that sounds dumb, but its a sealed system and sometimes that will fix the problem,, you can have the cap checked at many parts supply stores, also,, Once he fixed the vacuum leak, did you ever have the codes cleared ? you can have that done free too at many places, you just have to check around your town to see who will do that for you , they can use the code checker to clear all codes,, then ask them to re check the codes again, it may be that your problem has already been repaired , Just not cleared in the computer

Aug 25, 2011 | Ford Expedition Cars & Trucks

1 Answer

How to turn off check engine light on a 1997 dodge neon


You will require an error code reading machine, Which can be bought from car auto stores at low prices, You only need a cheap one to read the current error codes if you are sure everything has been fixed then clear error codes saved onto car system, However investigate each error code so you don't keep resetting the light when its coming on due to a fault with the engine.

Jul 02, 2010 | 1997 Dodge Neon

2 Answers

My ckeck engine light just came on


If you have a 1997 Wrangler, turn the key on and off three times in five seconds (without cranking the engine). Error codes should begin to flash in the odometer, and the check engine light will flash out the numbers (like Morse code). Write the numbers down, excluding the number 55 which means "end of codes". Finally, google "TJ error codes" and see whats wrong with your truck.

The most common are battery disconnect and upstream/downstream O2 sensor. If battery disconnect comes up, it means that you disconnected the battery for some reason and will go away after 40 warm-up cycles. For O2 sensors, you will have to get them replaced by your local mechanic.

Apr 22, 2010 | 1997 Jeep Wrangler

1 Answer

In the begining when i put a gearbox to drive,it must begin with 1 then 2 ,it jumps to 3 from the begining


It's in FAIL SAFE mode. Did the 'Check Engine' Light come ON? Whenever the 'CHECK ENGINE' light comes on, the ECU (Engine Control Unit) sets a Diagnostic Trouble Code (DTC). These codes identify the particular engine management system which caused the light to come on.
You'll need to use/find an OBDII (On-Board Diagnostic) Scanner to retrieve any code which have been stored in the ECU computer. Afterward, we might be able to help you DIAGNOSE and perhaps eventually fix the problem.

Oct 06, 2009 | 2007 Hyundai Santa Fe Limited

1 Answer

2002Ford taurus 98,600mi engine light is on Read out codes P303 cylinder #3 misfires detected and code 1506 IAC valve over speed error how to repair? Car stumbles at start up very sluggish will not pick up...


Did you ever do a tune up? If not you need to change the spark plugs pvc if you have one,some do and some dont anymore.also change the spark plug wires.This is where you have to start,even if your car was in a shop.Then you go from there if this does not fix your problem take to a good repair shop.

Jul 23, 2009 | 2002 Ford Taurus

1 Answer

Error Code 27 for 1994 Jeep


adding If you are getting correct pulses to the injectors, you can try 3oz of acetone and 1oz of marvel oil to each 10 gal of gas your fuel for the next few fill-ups...this will safely clean injector nozzles, providing they aren't worn out or internally binding.Your injectors are triggered by the computer, so check the plugs and wiring to make sure nothing is loose or shorting. There is much more to this, but it's a good place to begin.

May 30, 2009 | 1994 Jeep Grand Cherokee

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

21 people viewed this question

Ask a Question

Usually answered in minutes!

Top Volvo Experts

yadayada
yadayada

Level 3 Expert

74945 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7697 Answers

Are you a Volvo Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...