Question about GMC Sierra

Open Question

2530 Sierra GMC 2009 change from Spanish to English cluster gauge ask

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get 2 Free calls (no credit card required) and instant help on almost anything you can think of (from cars to computers, appliances, handyman, and even pets).
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 840 Answers

SOURCE: GMC 1500 SIERRA CLUSTER FAILURE

your right it is a problem with them but some repair shops can send them out and have them in a few days.

Posted on Jan 24, 2009

Ad
cj2176
  • 520 Answers

SOURCE: 1993 GMC Sierra C1500 5.7 just recently started

Most likely the Gage is not the problem these rarely go out. If the pressure is only dropping then the oil pump is getting weaker or is filling with sludge. Try running the engine with an oil additive such as marvel mystery oil or sea-foam. Then after the additive has circulated through the engine for a few heat ups and cool downs you can change your oil. the pressure should change almost immediately. If it doesn't then check the oil pressure switch. You can look on the side of the block and there will be a small piece shaped like a pencil with a wire coming from it. This piece is the oil pressure switch. Hope this helps. Please rate me if you think this helped. Good luck.

Posted on Jun 13, 2009

seanpwright
  • 2030 Answers

SOURCE: 1990 GMC Sierra lifters knocking. Oil pressure

I doubt it....It could be a totally worn out engine.

Posted on Nov 13, 2009

  • 22 Answers

SOURCE: 2003 gmc sierra temp gauge needle stuck in 5 o

Bad IPC.......If u can round up a tech 2 scanner, do a guage sweep and i bet u will see the temp guage will not operate correctly......a new IPC (Instrument Panel Cluster) is really the only fix. Once installed it has to be programmed. If u need any help send me a return message.

Posted on Jan 24, 2010

  • 84 Answers

SOURCE: My gas gausge doesnt work in my 89 gmc sierra. How

If all your other gauges work, more than likely you have a bad sending unit in the gas tank or bad ground to the sending unit.

Posted on Feb 12, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Speedometer doesn't work


You might try an oil pressure sending unit, first making sure the connector and harness are okay. I'm not sure, but I think there is a VSS Sensor as well, or vehicle speed sensor. Check the connector and wiring. If its okay, try a sensor. Good luck, hope this helps.

Sep 15, 2014 | 1998 GMC Sierra

1 Answer

Fuel gauge isn't working right


Some of those GM trucks have a problem with the stepper motor on the instrument cluster sticking. Its pretty simple to change them- a bit touchy tho. order them on amazon for about 3 bucks or take it to a mechanic and he'll put a new cluster in for 150-350 bucks. I just replaced the coolant gauge motor on my 04 Yukon. eureka its fixed.

Nov 03, 2012 | 2000 GMC Sierra

4 Answers

Replace spedometer cable 2003 gmc yukon xl


There is no speedometer cable on the 2003 Yukon, if there is no transmission issues like shifting problem. Your instrument cluster has gone bad, to pinpoint. Your stepper motor to your speedometer gauge has failed and needs to be replaced. You can do a search on Ebay for the stepper motor for around $10.00 which is better then the $400.00 cost of another instrument cluster.
There was a TSB on the replacement of the instrument cluster for your Yukon free of charge. The only cost to you is the labor charge unless your willing to do the job your self. Just go to the Gm Dealer and give them this TSB Number: # 07187C: Special Coverage Adjustment - Instrument Panel Cluster Gauge Needle Function - (Mar 20, 2009)
Subject:
07187C -- SPECIAL COVERAGE ADJUSTMENT - INSTRUMENT PANEL CLUSTER GAUGE NEEDLE FUNCTION

Models:
2003-2004 CADILLAC ESCALADE, ESCALADE ESV, ESCALADE EXT
2005 CADILLAC ESCALADE, ESCALADE ESV, ESCALADE EXT (U.S. ONLY)
2003-2004 CHEVROLET AVALANCHE, SILVERADO, SUBURBAN, TAHOE
2005 CHEVROLET AVALANCHE, SILVERADO, SUBURBAN, TAHOE (U.S.ONLY)
2003-2004 GMC SIERRA, YUKON, YUKON XL
2005 GMC SIERRA, YUKON, YUKON XL (U.S. ONLY)

Some customers of all 2003-2004 model year and certain U.S. 2005 model year Cadillac Escalade, Escalade ESV, and Escalade EXT; Chevrolet Avalanche, Silverado, Suburban, and Tahoe; and GMC Sierra, Yukon, and Yukon XL vehicles have reported that one or more of the instrument panel (IP) cluster gauges stick, flutter, or become inoperative. This may cause inaccurate readings, including the speedometer and fuel gauge. Special Coverage Adjustment This special coverage covers the condition described above for a period of 7 years or 70,000 miles (110,000 km), whichever occurs first, from the date the vehicle was originally placed in service, regardless of ownership.
Dealers are to replace the instrument panel cluster after the condition has been verified. The repairs will be made at no charge to the customer.

For verified failures between 70,001 miles (110,001 km) and 80,000 miles (130,000 km) on U.S. vehicles, dealers are to provide the customer with an instrument panel cluster (IPC) only. Any additional costs, including labor to replace the instrument panel cluster, will be the responsibility of the customer. Dealers are responsible for the return of the customer's IPC back to the Electronic Service Center

Thank you for using fixya and good luck.

Apr 28, 2010 | 2003 GMC Yukon XL

3 Answers

Gauges stop working in 2003 Silverado 1500


# 07187C: Special Coverage Adjustment - Instrument Panel Cluster Gauge Needle Function - (Mar 20, 2009)
Subject:
07187C -- SPECIAL COVERAGE ADJUSTMENT - INSTRUMENT PANEL CLUSTER GAUGE NEEDLE FUNCTION

Models:
2003-2004 CADILLAC ESCALADE, ESCALADE ESV, ESCALADE EXT
2005 CADILLAC ESCALADE, ESCALADE ESV, ESCALADE EXT (U.S. ONLY)
2003-2004 CHEVROLET AVALANCHE, SILVERADO, SUBURBAN, TAHOE
2005 CHEVROLET AVALANCHE, SILVERADO, SUBURBAN, TAHOE (U.S.ONLY)
2003-2004 GMC SIERRA, YUKON, YUKON XL
2005 GMC SIERRA, YUKON, YUKON XL (U.S. ONLY)

THIS BULLETIN IS BEING REVISED TO INCLUDE CERTAIN 2005 MODEL YEAR VEHICLES IN THE U.S. ADDITIONALLY, FOR U.S. 2003-2005 MODEL YEAR VEHICLES, GM WILL PROVIDE THE INSTRUMENT PANEL CLUSTER (IPC) ONLY, AT NO CHARGE TO THE CUSTOMER FOR VERIFIED FAILURES BETWEEN 70,001 MILES (110,001 KM) AND 80,000 MILES (130,000 KM). ANY ADDITIONAL COSTS, INCLUDING LABOR TO REPLACE THE INSTRUMENT PANEL CLUSTER, WILL BE THE RESPONSIBILITY OF THE CUSTOMER. DEALERS WILL BE RESPONSIBLE FOR THE RETURN OF THE CUSTOMER'S IPC BACK TO THE ELECTRONIC SERVICE CENTER. PLEASE DISCARD ALL COPIES OF BULLETIN 07187B, ISSUED SEPTEMBER 2008.

CUSTOMERS ARE BEING INSTRUCTED TO CONTACT THE DEALERSHIP TO ARRANGE AN APPOINTMENT IF THEY BELIEVE THEIR VEHICLE HAS THIS CONDITION. THE CUSTOMER IS BEING ASKED TO PROVIDE THE VIN SO THE IPC CAN BE ORDERED IN ADVANCE OF THE SCHEDULED APPOINTMENT. THIS WILL ELIMINATE THE NEED TO KEEP THE VEHICLE OVERNIGHT. DEALERS ARE TO OBTAIN THE VEHICLE MILEAGE WHEN SCHEDULING A SERVICE APPOINTMENT. THE VEHICLE MILEAGE WILL BE REQUIRED WHEN PLACING AN ORDER FOR THE IPC.

Condition

Some customers of all 2003-2004 model year and certain U.S. 2005 model year Cadillac Escalade, Escalade ESV, and Escalade EXT; Chevrolet Avalanche, Silverado, Suburban, and Tahoe; and GMC Sierra, Yukon, and Yukon XL vehicles have reported that one or more of the instrument panel (IP) cluster gauges stick, flutter, or become inoperative. This may cause inaccurate readings, including the speedometer and fuel gauge. Special Coverage Adjustment This special coverage covers the condition described above for a period of 7 years or 70,000 miles (110,000 km), whichever occurs first, from the date the vehicle was originally placed in service, regardless of ownership.

Dealers are to replace the instrument panel cluster after the condition has been verified. The repairs will be made at no charge to the customer.

For verified failures between 70,001 miles (110,001 km) and 80,000 miles (130,000 km) on U.S. vehicles, dealers are to provide the customer with an instrument panel cluster (IPC) only. Any additional costs, including labor to replace the instrument panel cluster, will be the responsibility of the customer. Dealers are responsible for the return of the customer's IPC back to the Electronic Service Center.

For vehicles covered by Vehicle Service Contracts, all eligible claims with repair orders on or after September 28, 2007 for 2003-2004 model year vehicles, and March 23, 2009 for 2005 model year vehicles, are covered by this special coverage and must be submitted using the labor operation codes provided with this bulletin. Claims with repair orders prior to September 28, 2007 for 2003-2004 model year vehicles, or March 23, 2009 for 2005 model year vehicles, must be submitted to the Service Contract provider.

Apr 19, 2010 | 2003 Chevrolet Silverado 1500

2 Answers

2003 gmc sierra temp gauge needle stuck in 5 o


Bad IPC.......If u can round up a tech 2 scanner, do a guage sweep and i bet u will see the temp guage will not operate correctly......a new IPC (Instrument Panel Cluster) is really the only fix. Once installed it has to be programmed. If u need any help send me a return message.

Jan 23, 2010 | 2003 GMC Sierra

3 Answers

Speedometer freezes


GM has had a issue with the clusters in the 2003-2005 trucks. The cluster will be replaced for free for your truck if it has less then 70k miles. I would take it to your local dealer and tell them that the voltage gauge sticks at times. They should order one for you, takes 1-2 days and replace it for you at no charge. If this does not fix the problem, you will have a new cluster at no charge.Unless the battery light comes on, the alternator should be good. This is a copy of the GM bulletin.

#07187C: Special Coverage Adjustment - Instrument Panel Cluster Gauge Needle Function - (Mar 20, 2009)

This special coverage covers the condition described above for a period of 7 years or 70,000 miles (110,000 km), whichever occurs first, from the date the vehicle was originally placed in service, regardless of ownership.

Dealers are to replace the instrument panel cluster after the condition has been verified. The repairs will be made at no charge to the customer.

For verified failures between 70,001 miles (110,001 km) and 80,000 miles (130,000 km) on U.S. vehicles, dealers are to provide the customer with an instrument panel cluster (IPC) only. Any additional costs, including labor to replace the instrument panel cluster, will be the responsibility of the customer. Dealers are responsible for the return of the customer's IPC back to the Electronic Service Center.

For vehicles covered by Vehicle Service Contracts, all eligible claims with repair orders on or after September 28, 2007 for 2003-2004 model year vehicles, and March 23, 2009 for 2005 model year vehicles, are covered by this special coverage and must be submitted using the labor operation codes provided with this bulletin. Claims with repair orders prior to September 28, 2007 for 2003-2004 model year vehicles, or March 23, 2009 for 2005 model year vehicles, must be submitted to the Service Contract provider.

Involved are all 2003 and 2004 model year and certain U.S. 2005 Cadillac Escalade, Escalade ESV, and Escalade EXT; Chevrolet Avalanche, Silverado, Suburban, and Tahoe; and GMC Sierra, Yukon, and Yukon XL vehicles built within the following VIN breakpoints: 51100014-51247028 / 5E100002-5E223209 / 5F800001-5F882297 / 5Z100003-5Z224691

Good luck friend.

Jan 11, 2010 | 2003 GMC Sierra 2500HD

1 Answer

My 2004 gmc sierra had 3 gauges go out on my last trip yet there was no problem with the truck as far as performence was concerned


It is probably the gauge motors. these gauge clusters are bad about that. Hope this helps

Oct 19, 2009 | 2004 GMC Sierra

1 Answer

My 04 GMC Sierra has the dash light for the oil pressure out. is there a way to change that bulb or do i need a whole new gauge cluster?


pull the cluster out... it will not be as easy as the older ones. but pull off bake plate exsposing the circuit board.. you will see these little black pieces that will turn then pull out that is the bulb.. get replacement from dealer and pop back in... any probs let me know

Aug 31, 2009 | 2004 GMC Sierra

1 Answer

Gauges don't regester


That year is under a factory recall for the gauge cluster. The dealership can do a test for you(gauge sweep) to see if thats the issue and if so the get the replacement gauge clusters from Seattle, WA and replace the whole cluster. Ran me about $538 to have the Delear do it in Oregon.

Jun 28, 2009 | 2003 GMC Sierra 2500HD

1 Answer

GMC 1500 SIERRA CLUSTER FAILURE


your right it is a problem with them but some repair shops can send them out and have them in a few days.

Jan 24, 2009 | 2003 GMC Sierra 1500

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

20 people viewed this question

Ask a Question

Usually answered in minutes!

Top GMC Experts

yadayada
yadayada

Level 3 Expert

76649 Answers

Freddy

Level 3 Expert

1311 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Are you a GMC Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...