Question about Saturn Cars & Trucks

1 Answer

Where is the crank shaft position sensor on a 2008 saturn astra 2dr xr

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Top Expert:

    An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

  • Saturn Master
  • 8,376 Answers
Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2007 Saturn Aura XR 3.6 code p00116. new timing chains and all parts...128,000 miles any ideas besides the crankshaft reluctor.. Car runs great idols smooth


you got a bit carried away with the code
code p 0016 refers to crank shaft position/cam shaft position sensor, bank 1 sensor A---correlation === causes --wiring---CKP sensor --CMP sensor ---mechanical fault
code p 0011 refers to cam shaft (CMP) intake /left /front bank 1 --timing over advanced / system performance==== causes ---valve timing---engine mechanical fault --- CMP actuator ---wiring
you didn't mention the fault so consider this
if the timing is out on the intake cam shaft , it will idle good but play up as the timing actuator moves it further advanced with rpm
if the actuator is not wire properly or the solenoid is faulty , then the inlet will lag with increased rpm and again cause you problems
It is doubtful if the position sensors for either the crank or cam shafts are a problem because it starts and idles good

Nov 12, 2017 | Saturn Cars & Trucks

1 Answer

Constantly have to replace driver's side tail light, brake light and blinker on a 2008 saturn astra xr.


You might have an exposed wire somewhere shorting out. And blowing the circuit's. Causing the lights to get too much power and blown your lights out.

Dec 08, 2016 | 2008 Saturn Astra

1 Answer

Where is the crankshaft position sensor for a 2008 Saturn Astra i have a new one I just can't find it


Do you know where the starter motor is located? My info says to remove starter, first. It appears to be on backside of engine. The crank sensor connector is a three wire connector. Wire colors, blue-- brown with a yellow tracer--black with white tracer.
I found a picture, but, not much orientation. See the starter cavity on left of picture, see flywheel teeth? 1 and 2 are crank sensor and crank sensor wiring harness.

26320443-ve3gjw5ptojjcijdngx2esdq-4-0.jpg

Oct 20, 2016 | Saturn Cars & Trucks

2 Answers

I have a 2008 Saturn Astra Xr its making a grinding noise what could it be if it's not the brakes or rotors.


It could be worn out constant velocity joints, if it is noisy only at slow speeds, and turning makes it happen too, get them checked asap.

Apr 28, 2015 | 2008 Saturn Astra XR

1 Answer

Where on engine can a crank shaft position sensor be located on a 2002 Saturn sl


I think this saturn is the same as the opel astra /zafiro if so then its front bottom right on the engine block in line with the crankshaft ,But no doubt iam wrong as never seen this saturn car here in spain

Dec 09, 2014 | 2002 Saturn Sl

1 Answer

My saturn astra xr is consuming more gas then before, right now it takes 43L last me for 350 km.what the problem with that ?


Reasons for increase in fuel consumption include a fault in the fuel pressure in the manifold, cpu keeping the fuel rich for too lomg Water/ air tem sensors. Brake drag -Brakes staying on slightly.tyre pressure too low blocked exhaust system cat converter clooapsed and blocking exhaust pipe. faulty oxygen sensor. driving in too low a gear for too loong Faulty auto tranny not changing at the right time. Considerwhen the consumption went up and try to remember if something happened that at the time seemed incindental as this may help pinpoint the fault

Feb 22, 2013 | 2008 Saturn Astra

1 Answer

How do you change a crank shaft sensor on a 2007 Saturn Aura XR 3.6


locate the crankshaft sensor, disconnect electrical plug, make sure around sensor is clean so grit etc doesn't fall in when sensor is out, unscrew with appropriate spanner, replace with the new sensor and reconnect plug. may also need some thread tape on thread before screwing in.

Mar 14, 2011 | 2007 Saturn Aura XR Sedan

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

96 people viewed this question

Ask a Question

Usually answered in minutes!

Top Saturn Experts

yadayada
yadayada

Level 3 Expert

80637 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8841 Answers

Are you a Saturn Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...