Question about Ford Cars & Trucks

1 Answer

I own a 2002 Ford Escape, 3.0L, 6 cyl. During a recent flood, the bcm got wet and I want to replace. I'm not sure how to do so, what all needs to be done or where to find one. Can anyone assist me?

Posted by on


1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.


    An expert that has over 500 points.

  • Expert
  • 236 Answers

You can get another one used at the wrecking yard or just let yours dry out and get it checked out, or buy a rebuilt one from the autoparts

Posted on Dec 12, 2016

  • 1 more comment 
  • Glenford Dawson
    Glenford Dawson Dec 12, 2016

    How can I get it checked out? And would it have to be programmed/reprogrammed?

  • swaffken Dec 12, 2016

    ask your autoparts store where they send the cores to and if they could do it for you and if not then the best thing to do is to buy the rebuilt one or just get one from the pick-n-pull junkyard

  • swaffken Dec 12, 2016

    if you order another computer it should come programed if you give them the vin number to the car



1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

3 Answers

How to replace a thermostat on a 2002 ford escape

Hi there, I'm Al the owner of Big As Auto Repair

I look forward to helping you with your thermostat problem but, I'll need to know the engine size of your 2002 ford escape. Go to my website below with the information and I'll help you with your problem. Have an awesome day. Auto Repair

Feb 22, 2015 | 2002 Ford Escape

1 Answer

2002 ford escape has no parking lights and no dash lights

there is a bcm under the dash that controls the instrument cluster and lights

Dec 07, 2012 | 2002 Ford Escape

1 Answer


2002 Ford Escape 2.0 liter DOHC L4 VIN "B"


2002 Ford Escape 3.0 liter V-6 VIN "1"


Hope this helps (remember to rate this answer).

Jan 12, 2011 | 2002 Ford Escape

1 Answer

Where is the crank position sensor located on the 2002 Ford Escape? Will I need a rubber O ring or paper spacer?

The Crankshaft Position Sensor (CKP):
4 CYL - located on the front of the engine, near the flywheel end of the block. remove exhaust manifold, disconnect electrical connector, remove bolt. installation is reverse of removal, no gasket req'd. torque to 62 inch-pounds
6 CYL - located next to crankshaft pulley - remove right wheel, remove lower right splashshield. disconnect electrical connector, remove bolt. installation is reverse of removal, no gasket req'd. torque to 89 inch-pounds

Dec 17, 2010 | 2002 Ford Escape

1 Answer

What is involved replacing 2002 ford escape alternator - 4 cyl engine? e.g. removing other components to get to it.

Remove Serpintine belt. Disconnect ground wire. remove necessary wiring, remove retaining bolts.Remove Alternator.

Sep 14, 2009 | 2002 Ford Escape

2 Answers

Can anyone tell me where the bank 1 sensor 2 for the oxygen sensor is for a 2003 ford escape

sensor two is behind the convertors if you have a four cyl its the only sensor behind cat if its a 6 cyl then the side of engine closest to firewall is bank2

Jul 23, 2009 | 2002 Ford Escape

1 Answer

No start

I'll give you a list of a few things that could be causing your problem. However, I think it's most likely a bad ignition module. I looked this up on the web and I see a lot of ignition module problems for the 2002 Escape. I checked the Ford recall list but there was no recall issued for what looks to be a very common problem with the ignition module.

Here are some other things that could be causing your problem.
1. Bad ignition coil
2. Clogged fuel filter
3. Clogged air filter
4. Clogged fuel injectors
5. Bad spark plugs, wires, distributor cap and /or rotor.

May 25, 2009 | 2002 Ford Escape

1 Answer

2002 escape speedo works sometimes kinda intermittent

Check the speed sensor on the transmission

Feb 19, 2009 | 2005 Ford Mustang

1 Answer


The 2002, 2003 and 2004 Mazda MPV's all use the same Ford 6 cyl. 3.0 duratec engine. The Ford Escape and Mazda Tribute of those years use the same engine. Therefore if you need an inexpensive engine repair manuel for your 2002 MPV, get the Haynes ($20.00) 2001-2007 Escape/Tribute manuel. Mazda sells the a MPV shop manuel for $180.00. I also own a 2002 Mazda MPV LX. 75k miles.

Jun 16, 2008 | 2002 Mazda MPV

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

24 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts


Level 3 Expert

77499 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22306 Answers


Level 3 Expert

5608 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides