Question about 1998 Dodge Dakota

1 Answer

I have a 1998 dodge dakota 3.9 engion. All of my gages as well as the seat belt warning light kick on and off I can 't get an accurate reading on any thing. Do you have any idea?

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 13 Answers

Most likely the instrument cluster board has bad souder get cluster or have electronics guy look ot the cluster board for bad joint

Posted on Dec 12, 2016

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How to reset the dash gageds on a 1009 dodge dakota


Gages wont cause your truck to jerk back and forth. You have a mechanical problem.

Dec 25, 2014 | 1998 Dodge Dakota

1 Answer

What is the yellow triangle warning light on dodge dakota


Just a systems check. If it stays on after the truck starts, take it to the dealer or a repair shop.

You know, you could always read the owner\'s manual.

Aug 19, 2014 | 1998 Dodge Dakota

1 Answer

1998 dodge dakota 3.9 runs great for about 10 min. than starts to miss and backfire no check engine light


you may have a plugged fuel filter as you don`t say if you have changed it. also have your fuel pressure tested with a gage, it should run about 36 lbs pressure if its multi-point fuel injection or run at about 15/18 lbs pressure if its a throttle body.

Jul 17, 2014 | 1998 Dodge Dakota

1 Answer

I have a 96 dodge Dakota 2.4 L , 4 cylinder. I installed 3 oil sensor switches, thinking they could be bad. I have no reading on oil gage in cab. I grounded lead to sensor, gage working. On the other


Try using a cheap mechanical oil gauge to make sure you do have oil pressure. If you do, something is preventing the senders from making ground to the engine. Are you using tape or sealer on sender threads? DON"T. the threads are the ground for the sender.

Mar 26, 2014 | 1996 Dodge Dakota

2 Answers

My warning chime goes off at random.


Check all your seat belt attachments! This seem to be a leading oroblem with all vehicles that has a few miles on them. All it takes is wasting coffie or soda's into one of those locking mechanisms and it thinks the seat belt is not locked. All these vehicles have seat sensors too! If you sat anything more than 3 to 5 lbs on the seat, it thinks someone is sitting on the seat and the chime will continually go off and drive you nuts. Hope this helps you with your problem Sir

Jan 28, 2014 | Dodge Dakota Cars & Trucks

1 Answer

Dodge dakota will not start, no warning, no gas gage, drove great


have someone listen down next to the gas tank to see if its kicking on when you turn the key on.

Mar 19, 2013 | 1995 Dodge Dakota

1 Answer

Seat belt warning light


Usually a sensor in the seat that recognizes a body in it. Check under the seat for any plug that may have disconnected. maybe someone kicked it with their foot.

Jan 09, 2012 | Cars & Trucks

1 Answer

What is the cable used for-- under drivers side seat in a 1998 Jeep Cherokee Sport?


There are 3 cables under the driver's seat.
1) 1 (single wire) goes to the illumination light of the transfer case position plastic lense panel (underside) 2) 1 (single wire) goes to the seat belt harness for the seat belt warning light 3) 1 (multi-wire) goes to air bag sensor located directly under the seat.
Your welcome :-)
Steve

Jun 02, 2011 | 1998 Jeep Cherokee

1 Answer

Does the 1992 dodge dakota automatic trans have a fuse to overdrive button


The fuse number is

#16 - 5 Amp (Tan)

Gauges & Indicator Lights: Low Oil Light, Low Washer Light, Service Reminder Light, Transmission Oil Light, Brake Warning Light, Anti-Lock Brake Warning Light, Fuel Pacer Light, 4WD Indicator Light, Malfunction Indicator Light, Warning Buzzer, Overdrive Switch (1992-93); Transmission Oil Temperature Lamp, 4WD Lamp, Overdrive Module Seat Belt Warning Buzzer
(1994-95).

Jan 25, 2010 | 1992 Dodge Dakota

5 Answers

2005 seat belt reminder keep beeping and the light keeps flashing


take wire harness apart underseat that connects to seatbelt on drivers side. then take a piece of aluminum foil and stuff it into male part so it makes contact with both prongs and plucg connection back together..problem solved!!!!!!

Jun 29, 2009 | 2004 Dodge Ram 1500

Not finding what you are looking for?
1998 Dodge Dakota Logo

Related Topics:

23 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

76132 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8273 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...