Question about Cars & Trucks

Open Question

How to obtain maximum power from BAM b 40? - Cars & Trucks

Posted by on

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2011 115hp 4stroke runs strong to 3800 rpm but won't throttle up any higher. Compression is good, injectors have been cleaned and new plugs.


Nearly all the things that could limit the maximum revs of a mechanical unintentional nature would probably cause the power to reduce as the maximum rpm is neared so acceleration would similarly reduce and if climbing a hill the maximum would never be reached.

If your description is accurate and the engine produces normal power to 3800 without tapering and won't go any further it is something only electronic rpm limiting is capable of rather than the usual culprits of strangled intake, strangled exhaust, insufficient fuel or timing problems. Sometimes it was something as simple as the throttle butterfly not opening fully.

Checking the injectors is only half the testing the fuel system should have - the fuel pressure and delivery volume and regulator function needs to be checked.

Opel once made an engine of 1.4 litre and over time it was stretched to 2.0 litres and beyond. That engine pulled strongly until it reached a ceiling of about 5400 rpm, less for a high mileage model. It was impossible to make the intake ports large enough or to maintain a sensible shape to the ports which made the rpm self limiting and was my only experience of what you describe in over 40 years. In all other cases of limited rpm the power always tapered because of external faults.

Feb 24, 2018 | Cars & Trucks

1 Answer

How to replace starter motor


same as on all cars.
ever read a book on car repair?
is this your first time?
no engine stated ,.
to the generic, youtube this 1000s of examples...


1: remove the Neg battery lug and tie it back.
2: gain access to the starter, (jack stands work)
3: remove those wires.
4: remove those bolts at the base of starter.
5: bam it's out.

or RTM?
page 8F -40 , covers this. in the FSM
https://www.techauthority.com/en-US/Pages/Home.aspx


Sep 25, 2014 | 2006 Jeep Grand Cherokee

1 Answer

40 amp Abs fuse keeps blowing


in engine bay?
you have a short.
and the fuse stopped the fire.
i have a current limited power supply that allows me to do this easy
but other us a circuit breaker at the old fuse.
then drops loads until the breaker stop popping.
there are other way, most blow a box of fuse.
the 3rd way
is to drop all loads on that fuse. (new)
and then put them back 1 by 1, BAM , now you know.

Feb 11, 2014 | 2007 Toyota FJ Cruiser

2 Answers

1984 dodge van has power to the coil but not from the distributer, and it doesnt start. van ran fine until the positive post came off while driving down the road, it just died and hasnt fired back up...


Does the coil produce voltage? I know it has power to it, but is it throwing voltage? if so check the coil wire at the distributor. if power is reaching the distributor but not throwing spark from any plug wires, your problem is a bad rotor and or cap. Or bad wires.

Jun 10, 2010 | 1984 Dodge Pickup 4WD

1 Answer

Keyless entry not working


Programming
When
Remote control added or replaced. System malfunction.
How
Obtain all remote controls. Remove key from ignition switch. Close all doors. Open driver's door. Carry out the following within 24 seconds: Turn ignition switch ON and back to LOCK position 3 times. Remove key. Press and release driver's door courtesy light switch 3 times. Ensure doors lock and unlock. If not, wait 40 seconds and repeat procedure starting with driver's door already open. Press each remote control lock or unlock button twice. Ensure doors lock and unlock after each remote control operation. If not, proceed as follows: Press and release driver's door courtesy light switch once. Ensure doors lock and unlock twice. Repeat procedure starting with driver's door already open.
NOTE: A maximum of 3 remote controls can be programmed.

Mar 29, 2010 | 2004 Mazda 6

2 Answers

I am loking for an users manual for my slk 320 cabriolet,year model 2000


Hi,

You can download the user manual from the below mentioned link :-

http://safemanuals.com/user-guide-instructions-owner-manual/MERCEDES/S320%20%40%40%20S420%20%40%40%20S500-_E

Hope i helped.

Thanks for using " Fixya " and Have a Wonderful day!!

Jul 08, 2009 | Mercedes-Benz SLK Cars & Trucks

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

14 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

80417 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

john h

Level 3 Expert

15314 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...