Question about Ford Expedition

1 Answer

I have a 1988 Ford Expedition 5.4 motor starts and runs when I step on the gas it cuts off what do I do

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Master:

    An expert who has achieved Level 3.

  • Ford Master
  • 946 Answers

Make sure fuel filter has been replaced and then test fuel system pressure at fuel rail. don-ohio

Posted on Dec 13, 2016

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
chiquititas
  • 1010 Answers

SOURCE: 1998 ford expedition

The only way to find out is to take it to a mechanic who has an engine analyzer and the rubbing could be caused by a loose mudshield (or a dozen other things).

Posted on Jun 24, 2008

co7196
  • 3433 Answers

SOURCE: My 2003 Ford Expedition continues to sputter, miss

MAF SENSOR NEEDS CK AND OR REPLACE. 1ST SENSOR COMING OUT OF AIR FILTER

Posted on Jun 14, 2009

  • 25 Answers

SOURCE: 1999 rear wiper motor on a Ford Expedition

take door panel off by prrying clips out, then you should see the motor. unplug the wire harness and take the wiper arm off the outside. Should have to just unbolt it from here, otherwise if its rivited in, you'll need to drill them out and replace them with bolts/washers/lock washer/lock nuts when you put it back in.

Posted on Jun 22, 2009

  • 11 Answers

SOURCE: 1988 chevy s10 blazer 4.3, cut out , will srart but will not stay

Your vehicle as an ignition control module located on top of the distributor (under the cap and rotor) I would pull the ICM and take it to NAPA and have it tested if bad replace it (cost about $80). Sounds like a ICM problem or it could be the ignition switch located on the steering coloum which can't be tested but costs $20. Hope this works

Posted on Jul 16, 2009

bnjmnolivas
  • 10 Answers

SOURCE: 1988 Buick Century, not getting gas

by pass relay to see what happens.

Posted on Apr 05, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2003 ford expedition 5.4 runs fine then motor just cuts off.


Security key or ignition faulty sounds like. Does it do it with both keys IF you have 2 of them? don-ohio

Jun 30, 2013 | 2003 Ford Expedition

1 Answer

99 ford expedition runs fine when u first start it but when u shut it off it wont start kinda wants to if u hold gas pedal to floor


could be fuel pressure regulator or throttle position sensor,check them first,make sure your getting fuel to motor

Aug 21, 2011 | 2001 Ford Expedition

1 Answer

How would a 2006 ford expedition run with bad gas in it


It could consist of skipping, engine cutting off or hesitates from starting, idling . Bad gas gives numerous signs, the best way I have found to deal with this is, Buy a octane booster 104, go to the gas station and put a couple of gallons of high premium in to tank to disperse the water in the gas. They also make a liquid to take water out of gas which also goes into the tank.

Jan 11, 2010 | 2006 Ford Expedition

1 Answer

1988 Ford Exppedition heater in the front will not work


I ASSUME THIS IS A 98, THIS PROBLEM IS CAUSED BY A PART CALLED AN "AIR TEMPERATURE CONTROL BLEND DOOR ACTUATOR MOTOR" THIS MOVES A DOOR BETWEEN THE COLD AIR FROM THE AC AND THE HOT AIR FROM THE HEATER CORE, YOU WILL NEED TO REPLACE THAT ACTUATOR. .

Sep 05, 2009 | 1998 Ford Expedition

1 Answer

My 2003 Ford Expedition continues to sputter, miss


MAF SENSOR NEEDS CK AND OR REPLACE. 1ST SENSOR COMING OUT OF AIR FILTER

Jun 14, 2009 | 2003 Ford Expedition

1 Answer

My Nissan 200sx when I step on the gas it cuts out


The the airflow meter can shut off the car completely, it can also stop the car from reving over 2000rpm "limp mode" to save the engine from getting un-measured amounts of fuel.

Oct 08, 2008 | 1988 Nissan 200SX

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

17 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

76673 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

fordexpert

Level 3 Expert

5537 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...