Question about Chevrolet Impala

1 Answer

Why do i feel a slight vibration on my gas pedal while in park or stopped at a read light? 2009 chevrolet impala

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Sergeant:

    An expert that has over 500 points.

  • Expert
  • 236 Answers

Check out the motor mount or the transmission mount

Posted on Dec 13, 2016

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 119 Answers

SOURCE: front end vibration

It sounds as though your car has two seperate problems. The first problem with the vibration that goes away when you let off the gas pedal is caused by a bad INNER CV joint. It only vibrates when you are accelerating because that is when the joint is under stress. Your vehicle has two axles, each with an inner and an outer joint. My suggestion is to have a competent shop determine which is the bad side and replace the entire axle. The second vibration which occurs at any speed is most likely cause by either a bad tire, or a bent rim.

Posted on Jun 05, 2008

awcforever
  • 359 Answers

SOURCE: Vibration on the floor underneath gas pedal

I would venture to say your exhaust is hitting your frame, or, you may need new motor mounts. The exhaust is what I would lean toward. If you can imagine your exhaust sitting under your vehicle, and the fact that the vehicle has a little age, the motor mounts probably give a little, causing the motor to move slightly on acceleration and deceleration, thus your exhaust is going to move, and may be vibrating on whatever its touching. Good luck.

Posted on Feb 25, 2009

  • 2 Answers

SOURCE: Nasty vibration on the floor under the gas pedal

check the drive shaft between the intermediate transmission and the front transmission for miss alignement and defectivness of the telescopics system of this shaft. we had about the same problem on our 1996 same model...

Posted on Mar 03, 2009

Onifade
  • 268 Answers

SOURCE: vibrates when gas pedal pressed.

1. Check the ball-joint.

2. Check the Tye-rods.

3. Your shock absorbers/ struts.

4. Wheel balancing and alignment.

Good luck.

Posted on Dec 14, 2009

  • 752 Answers

SOURCE: chevrolet impala dash board said my gas cap need tightening

your gas cap seal might be leaking making ur light turn on change ur cap

Posted on Mar 13, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I feel a vibration on my 2009 chevrolet impala at freeway speeds. I resurfaced the front rotors and installed new front brake pads. What can be causing the vibration? Car has 195000 miles roughly.


I would certainly check the wheel hubs, the main bearings are in them. Also, struts or shocks could be bad or you maybe needing a front end alignment.

Dec 08, 2016 | 2009 Chevrolet Impala

1 Answer

My 1990 s10 vibrates when in park and giving gas .. And also. When driving but stoped on idle or letting go on the gas pedal it doesn't vibrate .. I have replaced flywheel and torque converter and still...


Sounds like a bad spark plug, spark plug wire. Probably the spark plug wire. They usually act that way when load is applied. It may misfire under light load and not at idle. Try plugs and wires.

Mar 01, 2015 | Chevrolet S 10 Cars & Trucks

1 Answer

2001 Chevy Impala 3.4L Base


were the motor & trans mounts checked?

May 26, 2017 | 2001 Chevrolet Impala

2 Answers

Car pulses and rpm fluctuates what is it?


if the car is running does it have the check engine light on? if yes what is the code if no then check to see if temp sensor is reading the right temp by plugging in a scanner that can read all data to give you an accurate reading... if it reads wrong temp it can cause running issues

Jul 08, 2012 | Chevrolet TrailBlazer Cars & Trucks

2 Answers

09 impala accelerator pedal sensor?


the pedal sensor is part of the gas peda assembly. The whole thing needs to be replaced if there is a problem with the sensor.

Feb 16, 2012 | 2009 Chevrolet Impala LT

1 Answer

My 2009 Chevy S-10 Blazer's anti-lock brake system activates when coming to a stop on dry pavement. The typical anti-lock sound is heard and the brake pedal pulsates. There are times when it feels like the...


check the rotors for scoring,worn rotors will "feel"like the abs is coming on due to the vibration caused.and will account for the extended stopping distance.

Dec 09, 2010 | 2001 Chevrolet Tahoe

1 Answer

2003 Chevrolet Impala While the vehicle is moving, at the feel for the change of gear there is feel on the gas pedal as a vibrating pull sensation. Would that be a transmission problem or what else...


It could be your Torque Converter slipping, have the car brought in to a transmission shop and have them do a transmission line pressure test. It could be a simple transmission boost valve that needs to be replaced to bring the transmission line pressure up to keep it from slipping.

See if the problem goes away when the brake pedal is pressed slightly to unlock converter. Have a shop verify line pressure, and provided no valves in the TCC hydraulic circuit are worn, replace the torque converter. Also, Lubegard Shudder Fix will at least fix this for awhile. Or try a transmission flush by a shop that a dirty EPC valve screen could be causing a low transmission pressure.

Good luck and thank you for suing Fixya. .

Dec 06, 2010 | 2003 Chevrolet Impala

1 Answer

Vibrates when gas pedal pressed.


1. Check the ball-joint.

2. Check the Tye-rods.

3. Your shock absorbers/ struts.

4. Wheel balancing and alignment.

Good luck.

Dec 14, 2009 | 2000 Chevrolet Silverado 1500

2 Answers

2005 impala steering vibrations


Probably front wheel drive so it could be A strut needs replacing or tie rods or control arm bushings they are all major repairs unless you know a good cheap mechanic

Aug 20, 2009 | 2005 Chevrolet Impala

2 Answers

Change oil soon how do you shut it off after youve changed the oil


turn ignition on with engine off press gas pedal to floor 3 times & light will flash then go out.
or if you have menu button on radio press button until reset oil life appears ten press enter

Jul 11, 2009 | 2009 Chevrolet Impala

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

17 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

75051 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7726 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...