Question about Ford Cars & Trucks

Open Question

Where is the sim id # locate on a 2007 ford five hundred

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 2 Answers

SOURCE: 2006 Ford Five Hundred -- Where's the fuel filter?

right rear just in front of wheel. push clips back and remove old filter. apply new filter insuring flow is correct direction by arrow on filter press the clips back in place and you are ready. check to see if it is leaking.

Posted on Mar 16, 2009

  • 93 Answers

SOURCE: how to reset factory code on keyless entry ford five hundred

if you do not already know the factory code, the only way it can be obtained is by your local ford dealer. the proprietary computer equiptment they have can access the code that is programed in vehicles security module. if you purchased it used..it is often that the keyless entry code id card is still withe the owners manual..it is a 5 digit code printed on an credit card sized card that is white in color..i hope this helps you...good luck

Posted on Jun 09, 2009

roniecon
  • 6826 Answers

SOURCE: = 07 ford five hundred ac problems

First off,is the ac compressor turning?If so are the large line,near where you put freon in,cold?If the low side lines(large lines)are cold and sweating,and the evaporator box is dripping water on the ground,then the ac is most likely fine.There is a temp door in the ac blower box,that moves for hot,or cold when you select these comfort levels.This door is most likely controlled by a actuator motor.This motor is most likely bad.If it is control by vacuum,look for a broken vacuum hose,or one that has come loose under hood.

Posted on Aug 26, 2009

  • 1 Answer

SOURCE: I have a 2005 Ford five hundred and the

You need to have the transmission serviced. The wrench indicates that the fluid in your transmission is out of spec or you have an out of spec pressure condition.

Posted on Oct 12, 2009

cobra777
  • 80 Answers

SOURCE: Where is the fuel filter located on a 2005 Ford

It is right in front of the tank. It is on the passenger side. Here is a picture. It is #12 in the picture. Hope this helps.. :-)

df94b94.jpg

Posted on Jul 21, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How to deactivated my ford five hundred alarm?


Ford Five Hundred 2005 2007 Service Repair Manual PDF

for better result of your problem contact the reliable-store they have the best service manual

Jan 19, 2016 | 2005 Ford Five Hundred

1 Answer

Where is the speed sensor located?


    2005-2007 Ford Five Hundred Speed Sensor - JC Whitney

    www.jcwhitney.com/2005...ford-five-hundred/...speed-sensor...speed-se...
    Shop for a 2005-2007 Ford Five Hundred OE Replacement Vehicle Speed Sensor by Motorcraft with a 30-day Satisfaction Guarantee at JC Whitney, America's ... images for 2005 Ford Five Hundred Where is the ...

Nov 26, 2015 | 2005 Ford Five Hundred

1 Answer

Meter want read anything on my 2007 ford five hundred


Check the fuses you might have a blown fuse that powers up the data link.

Apr 22, 2015 | 2007 Ford Five Hundred

1 Answer

Where is the map sensor on a 2007 ford 500? Thank you!


Built into the MAF (mass air flow) sensor. Located in the air induction system. Most likely mounted to the box that covers the air filter.

Feb 27, 2015 | 2007 Ford Five Hundred Limited Sedan

1 Answer

Ford five hundred voltage regulator


cc738b50-5ca1-438b-b94a-d5ee1a50f74b.jpgYou are correct as far as a voltage regulator being located inside the alternator. No there isn't a seperate one for the computer and 2 of the wires going to the alternator go directly to the connector of the PCM. Not sure of you problem but am guessing you are having a charging problem. have you checked the fuse for the charging system ? If not it is in the fuse panel under the hood of the vehicle. In the fuse layout I have provided I have marked the fuse you will want to check. If you have a good fuse, have had the alternator bench tested and it tested out good, there is also 2 fuseable links in the wiring for the alternator. One of thos could be blown. You could have a wiring problem and the computer itself could be faulty but that's not very common.

Jul 13, 2013 | 2007 Ford Five Hundred Limited Sedan

1 Answer

Problem resetting oil light on a 2007 ford five hundred


Run system check and when it asks if Oil is new press the reset button press and hold a few seconds to reset oil to 100%.

Nov 09, 2010 | 2007 Ford Five Hundred Limited Sedan

1 Answer

I have an o7 five hundred the speedometer goes to zero and the tack shows two dotted lines as well as the air bag lght comes on and the check engine light and the abs and the wrench and traction control.


This is a sign of a failing instrument cluster. you need to have a dealer use the IDS tool to perform a scan reading prior to repair to see if any other systems are causing this.

Mar 16, 2010 | 2007 Ford Five Hundred Limited Sedan

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

16 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

75197 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

fordexpert

Level 3 Expert

5481 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...