Question about Ford Cars & Trucks

1 Answer

What will happen if the entake and exhaust valve were tampered alittle of its tip of expedetion ford automatic 1999

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Ford Master
  • 17,417 Answers

Depends what you mean by 'tampered a little'?

If you ground a quarter inch off the top, a lot will happen. If you tapped it with a hammer, nothing will happen.

Posted on Dec 11, 2016

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do I fix code P0478 on a 2005 ford f350 6.0 diesel,automatic


code p 478 refers to exhaust gas pressure control valve---high input====causes --wiring short to positive---exhaust gas pressure control valve ---ECM

Dec 29, 2016 | Ford Cars & Trucks

Tip

2006 Ford Taurus wiper replacement tip


All of my tips have been tampered with. I deeply regret I must remove the content from these tips. I will not write another tip for fear of further tampering of my literature. If you have any questions I am on facebook.

JW Webster

on Jun 07, 2010 | Ford Taurus Cars & Trucks

Tip

Taurus belt replacement


All of my tips have been tampered with. I deeply regret I must remove the content from these tips. I will not write another tip for fear of further tampering of my literature. If you have any questions I am on facebook.

JW Webster

on Dec 25, 2009 | Ford Taurus Cars & Trucks

1 Answer

What will be the effect if the exhaust and entake valve are tammpered a litle?


Bad fuel mileage to a no start. If you did this mechanically , bad news for you. I can adjust this with a scanner , some. Usually timing components.

Dec 11, 2016 | Cars & Trucks

1 Answer

Expedetion constantly overheats and I have replaced the water pump, and the thermostat and flushed the radiator. what counld the problem be?


Its possible that the water pump is not working some of them used to have plastic impellers that would break apart and some of the steel ones would come loose on the shaft its fairly easy to check if you have the right tools. Worth a shot.

Feb 13, 2011 | 1999 Ford Expedition

Tip

96 Ford Taurus rear brake pad replacement tip


All of my tips have been tampered with. I deeply regret I must remove the content from these tips. I will not write another tip for fear of further tampering of my literature. If you have any questions I am on facebook.

JW Webster

on Dec 07, 2009 | Ford Taurus Cars & Trucks

1 Answer

My exhaust is red hot, just replaced the cat and entire exhaust and the engine is running rough


a few things i can think of as this happen to me on my ford , somebody left a rag in exhaust pipe before refitting , funnily enough this has happened , but i think if vacume hoses are incorrectly fitted this can cause this also , also check timing , also the exhaust gas return pipe may have fault at the inlet manifold regulator , which is where the pipe comes of the inlet manifold , check that also , sometime that valve is at fault .


hope this helps , good luck

Oct 09, 2010 | 1999 Chevrolet Cavalier

1 Answer

Misfire only in drive when idle. Ok when driving


you have an ignition coil going bad if the check engine light is on have the code pulled and it will pinpoint witch cylinder is missfiring if it is not on you will need a scan tool to watch the missfire in data mode to pinpoint it that way.you may also find when you pull the coil out that is missfiring it may be covered in oil you will need to replace the valve cover gaskets if this is going on and clean the oil off the coil and **** the oil out where the spark is

May 29, 2009 | 1999 Ford Expedition

1 Answer

1999 ford Explorer 4.0 v6 4x4 will cranck but not start has spark


Honestly it's probably just dirty spark plugs. Did you pull any of the spark plugs and inspect the tips for build up? A couple things to remember:

1.) If the timing chain broke, the valves wouldn't be opening so you wouldn't have any air coming out of the exhaust during crank. You said it smells like you're getting fuel, so I'm assuming that means you're smelling the exhaust fumes, right?

2.) The crank sensor tells the ignition system when to send a spark to the plugs. If you're getting good spark, it's unlikely that the crank sensor is faulty.

If it's too soon for spark plugs to need replacing, check your sensors. A faulty oxygen sensor for example could cause your engine to run 'rich', resulting in faster crud build up on spark plug tips.

Feb 12, 2009 | 1999 Ford Explorer

3 Answers

1999 ford expedetion


I hade the same problem it is your blend door or blend door actuator which are easy fixes and can be accessed by taking out your glove box.

Dec 05, 2008 | 1999 Ford Expedition

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

16 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

77499 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22306 Answers

fordexpert

Level 3 Expert

5626 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...