Question about Ford Ranger
A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
go to www.motorcraftservice.com then click on the owner guide and put in your truck information
then choose the 1st owner manual printing and should be between page # 184 to 200.
Good luck and I hope this will awnser your question.
Posted on Nov 08, 2008
ok go to this link they have every fuse panel diagram in your truck
they also have the wiring diagrams for most things if you need them too you can go to
Posted on Dec 26, 2008
Save your money, the chip is a ohm resistor at Radio Shack for under $2.00. It splices in to you IAT wire harness located at the intake tube between the air filter housing and throttle body.
Problem with this system is, that you can not adjust anything and have to run a constant 91 octane just to make sure you do not have a Detonation. The ECM will catch the Detonation from the knock sensor and compensate for it by retarding the timing which in turn lose of HP till next start up.
If you like and don't mind the check engine light on once and awhile, you can do the same by just disconnecting the IAT wire harness which give the ECM a 0 resistance thinking it's -20 out side and turn the timing up and lengths the injector pules.
When i was running a Nitro in the Toy before i sold it, i had installed a 10K ohm Potentiometer which you can buy at radio shack for under $5.00 i believe, I just spliced it in to the IAC wire harness so if i wanted to play with the Nitro I'ld turn the resistor up making the engine think it's 185 degrees F and would ****** the timing so i would not hurt the engine. But if i wanted to get more timing i would just turn the knob to drop the resistance to get more time since the engine thinks it's -20 out side.
Hope this helps. Keep me posted if you need more info. Best thing is to do a dyno tune and you can change everything right down to the Shift points.
Posted on May 29, 2009
Haynes Manuals not Chiltons are the source I use for wiring. You local library might have one and photocopy it off.
Posted on Sep 16, 2009
Tips for a great answer:
Dec 10, 2016 | Ford Ranger Cars & Trucks
Nov 05, 2012 | 2000 Ford Taurus
Jul 22, 2012 | Cars & Trucks
Jul 06, 2012 | Ford Cars & Trucks
Jan 30, 2010 | 1999 Ford Ranger SuperCab
Dec 25, 2008 | 1999 Ford F250 Regular Cab
98 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: