Question about 2004 Ford F150

1 Answer

I have a ford f150 2004 and I have replace all elictronic parts on my ignition switch and it still acts like my key is on but wont crank all my lights and gages exc my speedo or temp gages a

And it acts like key is on even with out the key in

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Ford Master
  • 12,423 Answers

I suggest you take it to a qualified repair shop , you did something wrong .

Posted on Dec 10, 2016

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Why wont my car start gauges and lights come on but wont crank no power going to soelinoid wire


If the security system has been reset ( no light on/flashing ) you may have a neutral safety switch problem, Will the vehicle crank over in neutral? In most cases, the neutral switch grounds the starter relay and allows it to operate. Does the starter relay connector have 2 powers? One constant and one with key on/cranking? If these power supplies are there, suspect the ground side of the relay to be the problem and possible neutral safety switch

Jan 20, 2016 | 2000 Ford Taurus

1 Answer

Put in a used instrument cluster had a new key made cranks put wont start


the transponder has to be set to the ignition switch see ford manual.
Note. non ford key wont work

Sep 21, 2014 | 2000 Ford Windstar

2 Answers

Truck wont start


It could be the fender mounted starter relay under the hood. Or if you took off the small wire at that relay (its from the ignition switch), it should have voltage when the key is held in start. If it does have power in start, probably the relay. If no power in start, either the switch or the neutral safety switch is acting up.

Jan 24, 2014 | 1985 Ford F150

1 Answer

Why would turning the steering wheel while cranking engine gets my car to start?


The ignition switch in the column most likely has a break in it. So when you move the steering wheel, it moves the wire so it completes the connection when you turn the key. Have the ignition switch replaced.

Oct 19, 2012 | 1992 Honda Civic

1 Answer

Ignition wont crank ford F 150


Make sure your getting 12V at the starter (fm batt) & have a good, clean ground from the batt. Good luck

Jun 10, 2017 | 2005 Ford F-150

1 Answer

1992, 4.9L f150 has no spark. I have a new distributor, computer, ecc, coil, wires, plugs, checked fuses, cleaned connectors, new relays, have 12v at the coil, good ground and no spark at all? help.


Help,
I have a 92 F-150 XLT with a 5.0. The ignition switch block burned up so I replaced it. Now it will not get spark when I crank it over, but when I crank it and let off of the key, I get one spark jump from the coil; to the distributer. (I have a spark tester I placed on the cap to the wire) I have replaced the coil and the ignition module that is on the fender attached to the brain, I have replaced the ignition cylinder and key (It was acting up) and I took the dash apart to see the wire harness to ensure there was no burnt wires. (The wire connection to the ignition block is not damaged from when the switch burned.
Does anyone know if there is a part that tends to go bad when the ignition block burns up??
Help, Thanks, Todd

Oct 17, 2009 | 1992 Ford F150 SuperCab

2 Answers

No gas or spark


Try your inertia switch in the cargo area in back. Its located on the passenger side rear wheel well. Push the button.
2_27_2012_8_29_26_am.gif

Sep 23, 2009 | 1994 Ford Escort

Not finding what you are looking for?
2004 Ford F150 Logo

Related Topics:

31 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

fordexpert

Level 3 Expert

5546 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...