1996 Dodge Dakota Logo

Related Topics:

Victor Hernandez Posted on Dec 10, 2016

Fuse in engine compartment that is connected to a pink/blu wire on a 1996 dodge dakota 3.6 2wh drive keeps popping fuse

1 Answer

Matthew Clark

Level 1:

An expert who has achieved level 1.

New Friend:

An expert that has 1 follower.

Corporal:

An expert that hasĀ over 10 points.

Welcome Back:

Visited the website for 2 consecutive days.

  • Contributor 7 Answers
  • Posted on Dec 14, 2016
Matthew Clark
Contributor
Level 1:

An expert who has achieved level 1.

New Friend:

An expert that has 1 follower.

Corporal:

An expert that hasĀ over 10 points.

Welcome Back:

Visited the website for 2 consecutive days.

Joined: Dec 14, 2016
Answers
7
Questions
1
Helped
671
Points
18

Could also have too small of a fuse in

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

1996 Dodge Dakota. Intermittent loss of CMP or CKP. Why is this happening?

Question edited for clarity.
Question moved to model category.

Sensor issues or wiring to them.

Code P1391 Dodge CMP or CKP Signal Intermittent ...

AutoCodes https://www.autocodes.com > p1391_dodge
Engine Light ON (or Service Engine Soon Warning Light) Ā· Lack/Loss of Power Ā· The engine may be harder to start Ā· The engine may stumble or stall.

Cam Sensor Failure Causing no Start or Stalling : Dodge ...

RepairPal.com https://repairpal.com > Problems > Dodge > Dakota
On 3.7L V6 and 4.7L V8 engines the camshaft position sensor may fail causing the engine to crank but not start or it can cause intermittent stalling.

Dodge Dakota Vehicles With This Problem

RepairPal.com https://repairpal.com > Problems > Dodge > Dakota
On the 3.9L V6 and 5.2L V8, an intermittent connection in the crank position sensor wire connector can cause poor engine performance or the engine may crank but ...

..
0helpful
1answer

Where do the pink wires connect on 87 Dodge Dakota dimmer switch

Here is what I have for a Dakota. There is a pink wire that goes to the brake light switch, but nothing for the headlights.



25654727-h4cqrczwsnn3n3vxzzdtph34-2-0.gif
0helpful
1answer

95 Dodge Dakota headlights, taillights dash lights suddenly went out. Have turn signals and flashers, no brake lights. Replace 15 amp fuse under dash that was blown nothing, replaced headlight switch

Did you check for voltage at the 50 amp fuse circuit. Even if the fuse is good if no voltage on the fuse circuit, the circuit is still dead. There is a light green wire that carries voltage from headlamp switch to dimmer, is that wire hot with headlamp switch on?

There are wiring diagrams for free, just about everywhere, if you don't have one. Autozone .com has free wiring diagrams on vehicle repair guides link. You have to register your vehicle, year--make--model, all that good stuff. It's free.
0helpful
1answer

Brake lamp fuse keeps going out what is causing this in my 96 dodge dakota

Sounds like a short in the wire somewhere. Either wires are shredded somewhere and touching. Check exposed wiring for problems. Check all lights on that fuse circuit.

Hope this helps at least some. Good luck!
3helpful
2answers

1996 dodge dakota blower fan , cut out while driving ,no owners manuel , to check what fuse to change

The fuse and blower relay is under the hood...on the left fender in a black box..if you open it up..it will show you what is what in the lid of the black box..i hope this will help
0helpful
1answer

WHERE IS THE FUSE FOR PARKING LIGHTS IN 96 DODGE DAKOTA

have you found the passenger compartment fuse box? it is behind the knee blocker panel in your truck, you have to unscrew 5 screws to get to it. once you get there you are looking for a 20 amp fuse, it's fuse number 8. hope that helps
0helpful
1answer

Turn signals wont work but flashers do

Hi.
On your 98 Dakota.
Is equipaded with a single Flasher.
If you replace all ready.
Check the FUSE # 10, 15 amp..
On the Fuse box. left side of Dash.
and the FUSE D 25, amp. On engine compartment Fuse box.
Check the proper funtion of the HAZARD switch.
Bacause if the Hazard switch is bad the turn signal don't will work. Match the OLD flasher with the New one.

If after of this still not work.
Remove the steering wheel cover, locate the Turn signal switch connector and with a TEST Light check power with the Key ON
12v. to the RED wire and PINK wire..
If you found 12v. check the connection with the switch.
If the connection is good. you will need to replace the turn signal switch.
But if you don't found 12v. You need to look a an open circuit.
And fix it..

I hope this help on your problem..
Thank you for use fixya...
Not finding what you are looking for?

64 views

Ask a Question

Usually answered in minutes!

Top Dodge Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6988 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...