Question about Volkswagen Golf

Open Question

My golf5 1.6 doesnt rev i bought lot of sensors n throttle body

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ajkill
  • 2035 Answers

SOURCE: won't rev past 2000 rpm

Check the computer on the car it may be programmed to run still on 2 K rpm you need to reprogram the computer on your car.......

Posted on May 27, 2008

  • 625 Answers

SOURCE: location of crankshaft position sensor 4 cyl

41918676the cranshat position sensor is located very close to the ignition ciol pack, and it is a two wire conector, if you can't still find it remove the coil pack and should be behid it

Posted on Jun 19, 2008

  • 2 Answers

SOURCE: wont rev past 4500rpm

I hade this proble on my 86. It may not be your same problem but check the connection plugs on your secondary injectors the heat from the engine worped the connectors preventing a tight fit so they would come loose and at about 4500 rpm the car would bog cause of lak of fuel.. or your secondary injector are bad

Posted on Feb 10, 2009

  • 38 Answers

SOURCE: 1989 Chevrolet C1500 with 5.7L V-8. Engine dies

fuel pump is working but when accelerating it doesnt pump enough fuel up to the engine then it will fall on its face if it is a electric pump you may have to drop the tank if it is inside and replace it if it is on the engine replace it thats what is exactly wrong with it

Posted on Jul 31, 2009

samtoler
  • 666 Answers

SOURCE: MY 1999 1.8L PASSAT HAVING THROTTLE PROBLEMS REVS

it can still cause trouble, im a former vw tech, and you would be amazed at how long they last or issues that arrise, I watched a tech install an engine once because he refused to belive radio was failed,

Posted on Jun 09, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Car rpms revs up when air condtioner is turned on


It sound like map sensor when it under load it bring the revs up

Jul 01, 2014 | 1999 Saturn SL

1 Answer

My 04 ford explorer 4.0L acceleration petal it's not working . Can it be a sensor?


open the hood you should see the throttle cables on the side of the throttle body twist that monster the cables are wrapped around thats your throttle if the motor doesnt rev up its a problem in the throttle body if it does then your throttle cable may be snapped somewhere

Jan 25, 2013 | Ford Explorer Cars & Trucks

1 Answer

1998 mitsubishi galant revs high then low when idling. runs fine but it sounds horrible.


that is your idle air control valve. it is located on the throttle body next to the throttle position sensor

Dec 15, 2012 | 1998 Mitsubishi Galant

1 Answer

Soon as i turn ignition it imediatly revs to 6000rpm then down to stalling out then right back up 6000 violently, doesnt matter if you hit gas peddle or not it happens everytime


This sounds Like your TPS sensor ....(throttle position sensor) when you check this i would also check the throttle body for gunk and debris recommend a good clean even with the new sensor if the dirt is there it could contamanate the new sensor

May 27, 2011 | 1997 GMC Jimmy

2 Answers

My passat has the epc light on and wont rev mo higher than 1200 revs


hi.
You need to plug a code reader in to find the problem as there are lots of possibilities,from faulty swich /sensor to throttle body failure.

Jul 17, 2009 | 1999 Volkswagen Passat

1 Answer

Engine revs high


I've seen before where the IAC sensor gets dirty. The IAC sensor is located on the top of the throttle body. If you refer to the throttle body as a clock, and picture the egde closest to the front bumper is 6 o'clock then the IAC sensor would be located at 12 o'clock. I think in a 02 GC it should have vaccum lines attached to it, and it's held down by couple of phillp's head screws. (I think) Take it off and clean it with throttle body cleaner until all the black gunk is out of it.
If you are not sure where the throttle body is, find the air filter box under the hood located on the driver's side lower corner. There will be a plastic "tube" going from that box to the top of the engine. Take this tube off and any part that connects to the top of the engine. You will then see the throttle body. It would also be beneficial to clean the throttle body out as well. (It only take a minute and it can only help your gas miliage.) You can find throttle body cleaner at any auto parts store, or Walmart or Target. Let me know if this helps, thanks!

Dec 09, 2008 | 2002 Jeep Grand Cherokee

3 Answers

Surging engine revs.


There is a recall on the engine computer for this problem

Jul 31, 2008 | 1995 Saab 900

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

18 people viewed this question

Ask a Question

Usually answered in minutes!

Top Volkswagen Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

yadayada
yadayada

Level 3 Expert

75797 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8140 Answers

Are you a Volkswagen Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...