Question about Cars & Trucks

1 Answer

In my Aveo 2006 Model the problems is that No.2 & No.3 Valves are not working and the Spark plugs are getting Wet due to petrol. Engine Performance is Weak.Can u tell me how to fix it.

Posted by Anonymous on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Sergeant:

    An expert that has over 500 points.

  • Cars & Trucks Expert
  • 236 Answers

Have the coils checked or take it to a shop and have a diagnostic tests done

Posted on Dec 10, 2016

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

SOURCE: Mk1 Cortina engine starting problems

Change the oil. Thick oil winter can cause it, or over diluted oil too. Got similar issue with my mark 1. Bought it but never ran more than 30 secs. Just drained 8 litres of oil out!!! Glad I changed the carby now. Hope you changed the condenser too. Once the plugs are fouled (may look OK) they are no good so might have to change them again.

Posted on Aug 11, 2008

  • 1 Answer

SOURCE: 2004 aveo timing belt broke, all valves bent

just go to any junk yard and find a used deawoo lanos and pull the head if timing belt was not broke, if it looks good, its a exact fit 100%, no special tools needed, just normal wrench set and torqe wrench. after head is installed, get a gates timing belt only.

Posted on Dec 26, 2008

SOURCE: 2000 vw passat 1.8t wont start

First make sure you do a basic tune-up on the car i.e. replacing spark plug wires, spark plugs, distributor cap, rotor button, etc. Secondly, the plugs are probably just wet from fuel from not starting. The low oil pressure light coming on is normal when trying to start the car. Make sure to check for codes too and don't press the accelerator when starting the car, otherwise it will flood the engine.

Posted on Jan 11, 2009

MNfisherman
  • 11896 Answers

SOURCE: how to change spark plug on 2006 cadillac DTS

The plugs are located by engine head. You can use a ratchet wrench and sockets to remove them. Make sure to mark the plug wires so the order doesn't get mixed up.
The check engine light comes on when there is a bad sensor, or bad circuit.
Many part stores will run an engine diagnostic code scan for free which will pinpoint exact problem that is setting of the check engine light
The light can only be shut off by the diagnostic scanner!!

Posted on Nov 23, 2009

  • 540 Answers

SOURCE: I HAVE A 2006 CHEVY AVEO, LESS THAN 80 MILES AGO

when run with a misfire, the cat will get loaded up with fuel, it takes awhile for it to burn out, and a code may set, on some occasions it ruins the converter, try clearing it and running it

Posted on Oct 14, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Full Engine Power is no longer available. "You can continue your journey, but moderate your speed and exercise due caution. Have the engine checked as soon as possible."


Check the Air Filter, and replace it if necessary, also get your AIS(Air Induction System) checked, maybe the wrong fuel air mixture ratio is reaching the engine resulting in lower performance. If the problem is NOT in the morning's first start and its occurring when you drive the car for a few kilometers, then the engine valves have a problem.
In the next oil change activity, have your engine washed by draining the oil from it and filling the engine with around 1 liter of petrol with the oil drain clip in place, and the start your engine at idle for about 30-35 seconds, and turn it off and drain the petrol from engine by removing the oil drain clip, it'll remove all the dirt from the engine and then use some synthetic oil for engine. This whole procedure will give you loads of performance and your car performance will be like brand new again!

Apr 04, 2015 | 2011 BMW X6 M

1 Answer

Spark plug gap for 1997 mitsubishi trition 2.4 petrol ute


Spark plug gap does not effect the engine timing so it's not that critical. Thirty 5 (.035) should work just fine.
Otherwise consult a service manual fro your model or call a Mitsubishi service centre

mitsubishi triton service manual
Mitsubishi Triton L200 2006 2013 Workshop Manuals Factory Service Manuals

May 27, 2014 | Mitsubishi Pickup Cars & Trucks

1 Answer

Whats the proplem ifthe spark plug is wet with petrol


If the plug is wet with fuel, it is an indication that the plug is not firing properly. Possible causes? Distributor cap, rotor, points/inductive pickup, spark plug wire or the spark plug itself. If you or a friend, relative, etc. has or has access to an inductive pickup timing light, connect the light to a power source and the inductive pickup to the plug wire of the "wet" spark plug. Start the engine and observe if the flash from the timing light is relatively constant in its frequency or is it erratic and sporadic. If the latter is true, check the distributor cap, rotor, distributor points/inductive pickup and plug wire. If the former is true, remove the spark plug and check the compression against other cylinders. If compression is good, replace the spark plug with a new one. If compression is lower than others, the air/fuel mixture in that cylinder is not being compressed engough for combustion, leaving the spark plug "wet". To learn the cause, put a teaspoon of motor oil in the spark plug hole, and recheck compression. If it doesn't increase, you probably have a valve or head gasket problem. If it does rise, you probably have a piston ring problem . Good luck

Oct 04, 2013 | 2006 Chevrolet Aveo

1 Answer

2006 Chevy Aveo Acceleration Issues??


If it was running properly before you changed the spark plugs and wires, check to be sure you have the wires routed properly from the coils to the plugs - correct wires on correct coils. It sounds like you may have a couple of wires crossed. Also, some engines are particular about the type of spark plug used. Check with your local Chevrolet dealer to see if the type plugs you used have been known to cause problems with the engine.

May 01, 2017 | 2006 Chevrolet Aveo

1 Answer

Replaced the timing belt car will not try to start checked the plugs and they wet what do i look for next ? made sure all valves were workingre all wet engine is 3.5 v6What's your problem?


Below is the master help link provided to go through belt routing diagram:---Timing belt, drive belt, serpentine belt, accessory belt, fan belt, engine belt routing diagrams for all types of car models?
Click the link below: ----

http://carbeltrouting.blogspot.in/2012/02/timing-beltdrive-beltserpentine.html
----------

Car not starting or turning over indicates towards multiple possibilities. It can be issue with battery or weak battery. But if battery checks out ok, then it can be starter issue or faulty alternator or problem with low fuel pressure or no spark at spark plugs due to dirty spark plugs or faulty ignition coil or injectors getting cracked or dirty and needs to be cleaned.


To confirm the problem, the basic troubleshooting is required.


Click this link below and follow the troubleshooting:------

http://technoanswers.blogspot.in/2012/02/car-starting-issues.html

---------

This will help.

Thanks.

Feb 22, 2012 | 2002 Dodge Intrepid

1 Answer

My ******* car will not start


looks like you have a major problem. Using diesel & petrol as an adultrated mixture have caused undue carbon deposition in the piston-cylider & has frozen the operating valves of the cylinder plus the fuel nozzles(mpfi engines). I am afraid you will have to thoroughly overhaul the engine.

Dec 09, 2011 | 1990 Mercury Sable

3 Answers

Timing belt Broke are valves worped?


Hello momma_green: My name is Roger and I will help you. The 2005 Chevy Aveo 1.6 engine is a interference motor. That means if the timing belt breaks.The valves will be bent. I have one in my shop now that the belt broke on it. Bent all 16 valves and damaged all 4 pistons. This is not a forgiving motor. I wish I could tell you good news but I cant. Should you need further help please just ask. Please rate the answer you received. Thank You for using Fix Ya. Roger

Oct 30, 2009 | 2005 Chevrolet Aveo

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

15 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

75744 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...