Question about 1991 Honda Accord

1 Answer

No brake lights

I have changed the bulbs I have checked the switch by the brake petal, and the fuse under the hood all is good any other thoughts?

Posted by on

  • velvet_f Jul 20, 2009

    is there a brake relay somewhere I can check?



1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 850 Answers

Ba earth or ground!
or bad & loose, dirty connections
if not any of these then wires may be damaged intrenally test as you go

Posted on Jul 20, 2009


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

My brake lights don't turn on when i press the brake petal.

assuming fuses are ok and the new bulbs are the correct fitment(there are many different types) check the new pedal switch again.
some are adjustable for length. check when you push pedal down that the switch is NOT still in contact with the pedal. if it is then you may need to adjust it to make it shorter, sometimes just pulling the pedal upwards can be enough to do this.
good luck

Dec 04, 2012 | 1998 Ford Contour

1 Answer

Brake lights dont work

Check the fuse if the fuse is good then check the power source when apply brakes everything check out good, then is the brake switch theone that mount on the top of the brake paddle. Good luck

Sep 18, 2012 | 1999 Chevrolet Lumina

1 Answer

Rear lights all work with the exception of the brake lights on either side, changed bulbs and checked fuses but brake lights still do not work

look above the brake petal for a switch that is attached to the petal linkage-it is either unplugged or hung up/misaligned.

Apr 13, 2011 | 2002 GMC Envoy

2 Answers

Headlight dont come on and no blower for heat as well as the brake light stays on

hi did you check your fuses theres a set of fuses under your hood, and in your car check your owner manual it will tell u were they are located. you will have a burn or broken metal bead in the fuse if it blowen also after checking fuses check your light bulbs. same go's for the fan check the fuses if not blown check the fan switch with a test light, if it works check the fan motor itself i would suggest bring it to a shop if the fuses are fine. it is a big job to do on your own the air system. the brake light if its staying on it should be as simple as a break petal switch located on the break petal itself it mite of just sliped out little white button just slip it back into place

Nov 19, 2010 | 1996 Volkswagen Jetta

1 Answer

What do the relays and fuses look like under the hook of a 96 s 10 blazer. Someone said to check theses and how do you. My brake lights dont work and the 10A fuse under the dash is good and i replaced the...

Did you check or replace the brake light bulbs?
It is more common to have burnt bulbs than a bad brake light switch or blown fuse.
Do you have orange signal lights and red brake lights at the rear?
Then the signal light switch will not affect the brake lights.....but....
If they are all red and you use the same bulbs for brake and signal....the brake light wiring goes through the signal light switch and could be affected there.
First....check for power getting to the brake light switch......and leaving it with a test light.......then go to the rear....pull a light assembly and check for power getting to the power? follow the wiring back to the switch looking for a bad connection.
The fuses and relays under the hood are usually in a black plastic box labeled fuses and or relays.

Aug 12, 2009 | 1992 Chevrolet S-10

2 Answers

Brake lights on my wrangler won't work

Check the fuses under the dash. If they are o.k. Check the bulbs. If they are o.k. then it may be the combination switch. (turn signal switch)

May 17, 2009 | 1997 Jeep Wrangler

1 Answer

1994 sl

their is a brake switch on the brake petal about 12 inches high from the bottom of brake petal that is bad or broken, replace it and it will fix your problem.

Mar 07, 2009 | 1994 Saturn Sl

2 Answers

Hyundai accent 2006 brake lights not working

brake light switch under the brake pedal. COMMON PROBLEM OF ACCENTS. 15 TO 20 BUCKS

Dec 23, 2008 | 2006 Hyundai Accent

1 Answer

Reverse lights not working

When you press the brake petal it activates a switch located under your dash. Just follow your brake petal up until you see something that compresses when you apply the brakes. It is possible that the switch is not lined up or needs to be replaced.

Oct 27, 2008 | 1994 Jeep Cherokee Country

Not finding what you are looking for?
1991 Honda Accord Logo

Related Topics:

22 people viewed this question

Ask a Question

Usually answered in minutes!

Top Honda Experts


Level 3 Expert

80637 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides