Question about 2001 Pontiac Aztek

1 Answer

A/C Power Knob

2003 Ford Escape
All 3 knobs broke and I have a hard time finding where to buy them

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 850 Answers

Try ford dealers spare parts departments or car dismantlers [wreckers]

Posted on Jul 20, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2003 park avenue door pops and is hard to open


possible problem can be the door check .It is located between the two door hinges. I have repaired a few doors by replacing the door check. I would closely inspect it .

Jan 21, 2014 | 2003 Buick Park Avenue

1 Answer

Fan speed knob won't turn


Best solution would be to replace entire switch and knob. Hopefully, You can find these at a salvage yard. If not you will have to purchase thru dealership

Nov 12, 2013 | 2003 Pontiac Montana

1 Answer

2006 focus cant get it off defrost


my knob broke from turning it because it became hard to turn--- i think the actuator is jammed or broke because even with a new knob, it turns freely and does not change selections.

May 03, 2012 | 2006 Ford Focus

1 Answer

2003 mitsubishi outlander temperature control knob would get stuck while turning..and finally snapped off and broke


The source of the problem is not the knob it is the temp blend door binding. Putting to much stress on the knob. If you replace just the control head with the knob it will only break again. You need a dampener repair kit and to install you will have to remove the dash and heater core.this will slow you to access the door that is binding. Hope this was more help then it broke replace it.

Nov 09, 2011 | 2003 Mitsubishi Outlander

1 Answer

Window handle broke off.


The whole handle with knob needs to be replaced as a unit only

Jun 02, 2010 | 2003 Ford Focus

1 Answer

How can i find out my parking brake adjustments on my 2003 ford escape?


Parking Brake Cable Adjustment Vehicle with low series floor console
  1. Remove the floor console front finish panel.
    1. If equipped, remove the manual transmission shift knob by turning counterclockwise.
    1. Remove the floor console front finish panel.
  1. Remove the floor console rear finish panel.
    1. Apply the parking brake.
    1. Remove the floor console rear finish panel.
Vehicle with high series floor console
  1. Remove the floor console finish panel.
    1. Apply the parking brake.
    1. Remove the floor console finish panel.
All vehicles
  1. Remove the adjustment nut clip.
  1. Turn the parking brake control adjustment nut so that the parking brake control stroke is three to five notches when pulled.
  1. Confirm the parking brake is applied.
  1. Install the adjustment nut clip.
Vehicle with high series floor console
  1. Install the floor console rear finish panel.
Vehicle with low series floor console
  1. Install the floor console rear finish panel.
  1. Install the floor console front finish panel.
    • If equipped, install the manual transmission shifter knob by turning clockwise.

Jan 21, 2009 | 2003 Ford Escape

1 Answer

Shifter knob??


yes I can. Lift the bottom boot area (the plastic trim) from the front first. Lift the boot up over the knob. The knob is attached with a clip that you have to cut. Once that's removed the boot and knob come off as an assembly.

Aug 07, 2008 | 2003 Volkswagen GTI

Not finding what you are looking for?
2001 Pontiac Aztek Logo

142 people viewed this question

Ask a Question

Usually answered in minutes!

Top Pontiac Experts

yadayada
yadayada

Level 3 Expert

75797 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8140 Answers

Are you a Pontiac Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...