Question about 2008 Ford Explorer Sport Trac

Open Question

On a 2008 Ford Sport Trac I have a Astrostar TX60A,yesterday it just stopped working all together. No flashing lights. Lock/unlock work. Help it is -30 here!!

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 1 Answer

SOURCE: 2007 jeep wrangler sahara with a mopar remote starter just beeps

That's not a remote starter on your key chain, it's a keyless entry for an alarm system.

Posted on Dec 17, 2008

  • 1 Answer

SOURCE: remote starter does not work but will unlock and lock doors.

I have a 2003 sierra and my remote starter would not work, it would lock and unlock only, checked out this site found the solution, tried it and in two seconds i solved the problem, Just press the lock button and the start button and viola it works again, thanks for all your help , GGGreat site glad i found it John

Posted on Jan 11, 2009

cbcs2008
  • 46 Answers

SOURCE: 2001 ford explorer sport trac 4 wheel drive wont work

Start the car
put in " N"
turn the 4X4 switch on
Then put in gear..
What do you see now?
Do the same in reverse when you take out of 4X4

Posted on Jan 19, 2009

  • 2 Answers

SOURCE: my ford 2005 explorer sport trac the windows don't work.

You may want to check the relay that goes to the primary window. This will provide support to all the other windows. However, it may not just be the window relay, it could possibly be that between your window relay and your main switch there is a short or cut wire that is causing this problem. Unfortunately, you may need to visit your Ford Dealership to run a diagnostic on your wire or if you know an electronic shop that can run one to see if it is receiving and sending power. Have them check the main door fuse and window assembly to see that you are getting power.

Posted on Mar 19, 2009

chuck943
  • 783 Answers

SOURCE: 2007 FORD EXPLORER SPORT TRAC 4X4 Change oil light on

Press and hold the SELECT/RESET
control switch to select SYSTEM
CHECK when “SYSTEM CHECK /
HOLD RESET” is displayed in the
message center. Selecting this
function from the SETUP MENU
causes the message center to cycle through each of the systems being
monitored. For each of the monitored systems, the message center will
indicate either an OK message or a warning message for two seconds.
Pressing the SELECT/RESET control switch cycles the message center
through each of the systems being monitored.

The sequence of the system check report and how it appears in the
message center is as follows:
1. OIL LIFE RESET
2. CHARGING SYSTEM
3. WASHER FLUID
4. DOOR AJAR
5. EXTERIOR LAMP
6. BRAKE SYSTEM
7. PARK BRAKE
8. MILES TO EMPTY
9. FUEL LEVEL LOW (will only display if 50 miles or less to empty)
To reset the oil monitoring system to 100% after each oil change
[approximately 5,000 miles (8,000 km) or 180 days] perform the
following:
1. Enter SYSTEM CHECK to display
“OIL XXX% RESET IF NEW”.
2. Press SELECT/RESET control
switch to display “HOLD RESET IF
NEW OIL”.
3. Press and hold the
SELECT/RESET control switch for
more than 2 seconds. Oil life is set
to 100% and “OIL CHANGE SET TO
100%” is displayed.

Posted on Apr 02, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Door L/R lock i working / door unlock not working


So it locks but does not unlock?
there is more electrical power used on the unlock so if the wires or battery is in poor condition this can happen
Open all the doors and test it then, if it works then there may be a sticky lock that needs greasing.

Apr 07, 2013 | 2004 Ford Explorer Sport Trac

1 Answer

2001 Explorer Sport Trac, Turn Signal, Tail lights work but not brake lights on either side


check brake light switch on brake pedal arm. Does high mount stop lamp work?

Aug 06, 2011 | 2002 Ford Explorer Sport Trac

1 Answer

How do i reset the low tire light on my 2008 sport trac ?


after the tires are all inflated to same air pressure the light should go off by its self after a few miles

Dec 10, 2010 | 2008 Ford Explorer Sport Trac

1 Answer

My left turn signal stopped working on my 2008 ford explorer how do I fix it ?


YOUR TURN SIGNAL RELAY HAS GONE BAD. SOME WHERE UNDER THE DASH YOU WILL FIND THIS. FIRST TURN ON YOUR RIGHT TURN SIGNAL AND LISTEN VERY CLOSLEY UNDER THE DASH YOU SHOULD HEAR A CLICKING FIND THE CLICKING AND YOU WILL HAVE THE FLASHING RELAY THE OLDER ONES WERE ROUND THE NEWER ONES ARE ROUND.

Aug 15, 2009 | 2008 Ford Explorer Sport Trac

1 Answer

Ford explorer sport 01 sport


replace the lock sw...assuming everything else works properly

Jul 06, 2009 | 2001 Ford Explorer Sport Trac

1 Answer

02 SPORT TRAC JOLTS AT A FULL STOP


try changing your tranny fluid and in the torque converter. if that does not help check torque converter and clutch plates

Jun 30, 2009 | 2008 Ford Explorer Sport Trac

Not finding what you are looking for?
2008 Ford Explorer Sport Trac Logo

Related Topics:

21 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

fordexpert

Level 3 Expert

5501 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...