Question about 2005 Mazda Tribute

1 Answer

05 Mazda tribute cuttin out and diein at idle replaced the number 2 coil any suggestions

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    MVP:

    An expert that got 5 achievements.

    Night Owl:

    An expert who has answered 10 or more questions between 12 midnight and 6am on the same day.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Contributor
  • 35 Answers

Sounds like your egr valve is stuck open

Posted on Dec 10, 2016

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 1 Answer

SOURCE: Where is the ignition coil pack located on 2002

The ignition power pack and (aka ignition coil) is located on the 2004 Mazda MPV at the end of each spark plug wire on top of the spark plug. The front ones are easy to replace and all 3 can be done in about 30 min. The back ones are another issue. I had to take off the intake manifold on the top of the engine to get to them. This was about a 5 hour job. The installation of the new unit is pretty simple once you gain access to them. you simply disconnect a clip on wire and take out one screw and reverse the process to put in the new ones. Factory units run about $80 each. You can get them at other locations in after markets for as low as $55. Good Luck.

Posted on Jul 23, 2009

  • 495 Answers

SOURCE: 2002 Mazda Tribute rear liftgate lock replacement

I'm not sure where' the screws are but basically You need to remove the panel on the rear door, then once the panel (interior trim) has been removed you should see a lock mechanism which will be screwed/bolted in place. Easier and cheaper then buying a brand new lock mechanism (unless you want to buy brand new) is going to a wreckers and finding your car model and get it that way (yes it's used but it'll probably save you tons of money vs the dealership) Best Regards.

Posted on Nov 22, 2009

  • 275 Answers

SOURCE: 2003 Mazda Tribute will start, idle rough for a

check the fuel filter air filter and vacuume lines if they all good make sure the spark plugs are making a bright blue spark

Posted on Jan 20, 2010

  • 54 Answers

SOURCE: 2001 Mazda Tribute intermittently stalls at idle.

Check your EGR valve, check your PCV valve, check your mass airflow sensor and throttle body sensor.

Posted on Oct 21, 2010

  • 1565 Answers

SOURCE: i have replaced all 6 coils and plugs and the

start by disconnecting power to each cylinder, one at a time until you find the cylinder that does not affect the idle speed. This will be the dead cylinder. If you have spark to this cylinder, impulse to the fuel injector plug and compression is good then replace the fuel injector for the dead cylinder. Normally your check engine light will be on if you have a misfire. by reading the codes you will know which cylinder is at fault.

Posted on Jan 19, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

05 mazada tribute misfireing on cyn 2


Need take out plug first and check and boot and check all the way to the coil make sure u have spark coming out of the plug if not possible coil or power going to coil/otherwise injector need go step by step. Good Luck

Dec 05, 2016 | 2005 Mazda Tribute

2 Answers

Is number 1 plug at the back and where is the coil


The number one cylinder is always in the front of the engine.
The 4 cyl engine uses one coil for all 4 cylinders.
The 6 cyl engine uses one coil on each plug.

Apr 17, 2013 | 2002 Mazda Tribute

1 Answer

2005 Mazda Tribute P0172 & P2270


Hi Paul, Have you had a fault code relating to the knock sensor? That sensor controls ignition timing which can have a relationship to the fault codes you report? Regards John

Apr 06, 2013 | 2005 Mazda Tribute

1 Answer

How to change spark plug on 02 mazda tribute


Is it a V6? For a V6 if you are standing in front of the car it will be the middle cylinder on the firewall side of the engine. You will have to remove the plastic engine cover and the intake manifold to get to it. If it were on the front side of the engine you would only have to remove the plastic cover. Since there is a good bit of work involved removing the manifold, I would suggest that you go ahead and replace all of the sparkplugs and consider replacing the coil for the one cylinder also. I have a 2001 Mazda Tribute. Mine started running rough so I decided to replace all the sparkplugs. After replacing the sparkplugs it continued to run rough. I took it to a shop and got it scanned (no cost for the scan). The scan showed the coil on the 3rd cylinder was bad. So I wound up having to pull the manifold off again to replace the coil :(
The first time it took me 1-1/2 hours to do the plugs, second time 1 hour to do the coil. Car runs great after coil replacement. Hope this helps.

Apr 28, 2010 | 2002 Mazda Tribute

2 Answers

I have a 2001 Mazda Tribute V-6 and I cannot keep it running at idle. I have replaced the EGR Valve and a fuel filter. It seems to be idling too slow. Any suggestions?


Go to my profile and see my tips for help with this. All you need to do is pull the idle control valve, clean it and lube it. It takes about 5-10 minutes, and your car will start and run great!

Nov 12, 2009 | 2001 Mazda Tribute

1 Answer

2003 mazda tribute engine light diagnoise said its ''coil A'' but the coils are listed 1-6, I think its number one but how can i tell for sure. Mazda dealer won't tell me because they would rather get paid...


i looked on alldat and there is nothing there on lettered coils just numbered! sorry but if i had that issue come into the shop and the custom said what you said i would assume that it was number 1 also and say if i didn't have a scanner and had to figure it out (blind) i would start at the number 1 coil and pull it out of the hole while it was running and while i was wearing thick rubber gloves and see if it made a diffence to the motor idling right. if not then that is the one but if it effected it then i would go to the next coil and do the same thing and so on. till i found the one that didn't cause the motor to mis fire or idle different or more. and change that one! hopefully that helps. best i can do over the computer at night with out the factory software in front of me.

Sep 22, 2009 | 2003 Mazda Tribute

Not finding what you are looking for?
2005 Mazda Tribute Logo

Related Topics:

22 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mazda Experts

yadayada
yadayada

Level 3 Expert

75066 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7754 Answers

Are you a Mazda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...