Question about Chrysler Cars & Trucks

1 Answer

I have a 99 Chrysler concorde and it over heats and the heater doesn't get hot or even warm. I put a new thermous stant in though the old one still worked. So what else might it be?

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Chrysler Master
  • 2,027 Answers

These are just ideas to look at.
Fluid in radiator could be low. Make sure it's topped up.
Water pump malfunctioning.
Radiator Plugged.
Pinched or buckled hoses.
Is the serpentine belt working properly?

Posted on Dec 09, 2016

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 1 Answer

SOURCE: 1997 chrysler concord

My girlfriend's 95 concorde was having a problem that sounds like that. Some times when she started the car, the heater control console would not turn on but the heater would turn on full blast. I fixed it by replacing the control console with one that i picked up from the junk yard. Hope this helps you

Posted on Nov 12, 2008

  • 141 Answers

SOURCE: heater on ford 2003 ford pick up blows cold air

on the evap box there is a control mtr that switches the hot cold door. these mtrs are prone to failure. the other problem that i have seen is that the door breakes in side the evap box and that means removing the box to replace the door . if i remeber correctly you may have to slide the dash back to gain assces to the control mtr to test it good luck

Posted on Dec 22, 2008

motor1258
  • 6674 Answers

SOURCE: Heater Problem: 2004 Chrysler Sebring Convertible

First off, time for a thermostat change if not done recently. Where does your temperature gauge ride when at normal operating temperature? Same as usual, or lower? As far as fan goes, sounds like fan resistor has gone and will need to be replaced. I'll double check to see if it's an inline resistor, or part of blower motor & get back to you. Are you planning on attempting all this yourself?

Posted on Feb 16, 2009

  • 1 Answer

SOURCE: 2000 Chrysler Town & Country , no heat, blower fan working fine

Probably one of two things. First make sure that your coolant level is full. If the coolant is not flowing properly you won't get heat. If you begin to get heat while driving, but only when you are excelerating, this is your problem. If that is not it you may need to change the thermostat. This is noot hard as long as it is easy to get to and it should be easy.

Posted on Apr 08, 2009

  • 1348 Answers

SOURCE: MY HEATER WONT TURN OFF AND IT BLOWS HOT AIR EVEN

have the a/c pressure tested.if it is ok,then there is a vacuum actuator problem in the center console under the radio,it is on full heat

Posted on Jul 18, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

What do i do to get my 2002 Chrysler Concorde to blow heat?


Check the temp of the two hoses going to the heater core, one should be hotter then the other, if they are both the same of very little difference you have no flow through the core, if there is a heat control valve in the supply or return line it could be bad, or has a vacuum leak so its not actuating if not the core is probably plugged, or could be leaking, but usually you will smell the fluid and/or see a wet spot on the floor.

Mar 02, 2015 | 2002 Chrysler Concorde

1 Answer

NO HEAT IN MY CONCORDE 98. PUT NEW THERMOSTAT IN AND STILL NO HEAT. WHY?


make sure the water pump is working then check the heater valve if it has one check both hoses going into the firewall both should be hot if water is circulating through the heater coil

Nov 28, 2011 | Chrysler Cars & Trucks

1 Answer

My 94 concorde will not put out heat but everything else appears to function correctly. i have checked the heater hoses and they are hot, but still no heat. how do i fix it?


Hi,
Sounds like the heater valve is stuck.
Check if there is heat on the return hose from the heater core back to engine inlet.

Tell me if am right.

Nov 24, 2011 | 1994 Chrysler Concorde

2 Answers

I have a 96 sl saturn. takes half an hour for my car to reach running temp. When i start driving the engine cools down so far, to the point i have no hot air for my heater. I replaced the thermastat, i...


replace the thermostant again this time get a hotter temp thermostant and buy it from the dealer, the other thing is that these cars are known for the temp sensors being bad this would give you the false reading on the gauge but would not affect the heat, if its taaking a long time then i would replace the stant and this time or before replacing the stant i want you to flush out the heater core, remove the hoses from the heatercore and use a water hose to flush water through the heater core, a plugged core will not throw heat or will start to allow water to flow when it gets good and hot to flow through the retricted core due to rust and crud, try the flush first and then try a new temp sensor if the flush helps the heat, hope this is helpful good luck.

Jan 07, 2011 | 1993 Saturn SL2

1 Answer

I have a 97 Dodge Concord that the Air Conditioning works great but when put on heat it will not get hot. Any idea to as what could be causing the problem


Is the temp gauge reading normal? If it low it could need a thermostat. If engine temp is ok, then let the engine warm and check the 2 hoses going into the firewall they should both be the same temp. If not then you will need to flush the heater core. If they are the same then you have a heater door under the dash not working

Oct 20, 2010 | 1997 Chrysler Concorde

1 Answer

Temperature gauge goes to hot and shortly later goes back to normal though car does not seem to run badly even while needle is at hot . reserve tank seems to draw antifreeze


you need a new thermostat, its sticking and causing you problems, soon it will just stay stuck, the reason the reserve keeps filling up is because of heat and pressure in the radiator

Jul 01, 2010 | 1994 Chrysler Concorde

1 Answer

Lack of interior heat


If you are getting air into the cabin, then there is prbably no abstruction the is keeping the warm air out.

Check the coolant leval. There might be enough to cool the engine, but becuase the heater core is higher than the engine, the coolant might not be able to get to it.

Nov 26, 2008 | 1998 Chrysler Concorde

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

22 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

yadayada
yadayada

Level 3 Expert

76649 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8522 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...