Question about Nissan Cars & Trucks

1 Answer

No back lights but got brake lights on nissan terrano

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Contributor
  • 47 Answers

Change the bulbs, check the fuse's

Posted on Dec 08, 2016

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How to get the abs light to go out on a 1996 nissan terrano


Get the ABS system fixed, that usually turns the light off. Get the computer scanned for the fault codes and work from there.

May 19, 2014 | 1999 Nissan Terrano

1 Answer

Abs sensor on a nissan terrano do you know where it is


There is a sensor on each brake assembly simply follow the wires to each brake to disc/drum area at the end is the sensor...Good-luck..

Jan 04, 2013 | 1999 Nissan Terrano

1 Answer

1998 terrano immobiliser fault wont start


hi, i have nissan terrano wen i switched on engine light flash and start engine its start then go of.nissan terrano patrol engine

Sep 06, 2012 | Nissan Sentra Cars & Trucks

2 Answers

I have 1995 Nissan Terrano 4x4.Thishas an Automatic trans. It will not change gear.I have a power/hold button next to the hand brake.The power light flashes


If the power hold button switch On,It will stop the gear shifting & hold the gear position. or the problem with the system.

Feb 08, 2011 | Nissan Terrano Cars & Trucks

2 Answers

How to adjust the handbrake on a terrano ll


On the inboard side of the rear wheel hubs, you will find an oval rubber plug, pry this plug out, to gain access to the brake adjuster.
Pull the handbrake up two clicks.
Jack and support. Remove the rear wheel, and adjust the brake using a screw driver levered through the slot to turn the notched wheel of the adjuster, until the hub starts to drag when rotated by hand. Repeat for the other side. Note the ratchet mechanism on the adjuster will only let it turn one way.

May 03, 2010 | 1994 Nissan Pickup

3 Answers

Nissan terrano pr50 4WD warning light starts flashing after about 80 km Auto trans 1995 year


Did this start happening, after tyres were rotated, or a new tyre was fitted? This will probably reset when the ignition is turned off and back on again, then start flashing after another 80km. This can be caused by the rolling diameter of the wheels being different, and the computer is picking up that a tyre is flat, or that the tyres are of different size designation or different levels of wear. This happened to me after rotating tyres, and would repeat every 40-50km, and went away, when i put the spare, back to being the spare.

Apr 07, 2010 | 1995 Nissan Pathfinder

3 Answers

Can i disconect the brake hoses off the nissan terrano alternator or just disconect all the hoses off the back of the alternator and connect them with no problems???


Some (most) Terranos have a vacuum pump attached to the back of the altinater. There should be no problem disconnecting these lines, as they don't contain brake fluid, they only supply vacuum for the brake master cylinder assist servo.

Jan 15, 2010 | 1988 Nissan Pathfinder

2 Answers

Where is the ECU located on the Nissan 94 Terrano


dont know for sure but all nissans ive worked on are behind the passengers side kick panel ( passengers left foot )

Aug 26, 2009 | 1994 Nissan Pathfinder

1 Answer

Brake lights not working.


Most of the time you can find the fuse panel either on the driverside under the steering column near the sidewall. Or it could be under then hood.

Feb 24, 2009 | 1997 Nissan Pathfinder

2 Answers

Nissan terrano headlight


check out
http://www.sferamydlo.com.pl/Zbyszek/Nissan/R20/el.pdf


Bulb Replacement
The headlamp is a semi-sealed beam type which uses a replacable
halogen bulb. The bulb can be replaced from the engine compartment
side without removing the headlamp body.
I Grasp only the plastic base when handling the bulb. Never
touch the glass envelope.
1. Disconnect the battery cable.
2. Disconnect the harness connector from the back side of the
bulb.
3. Pull off the rubber cap.
4. Press end of the retaining pin together to release bulb.
5. Remove the headlamp bulb. Do not shake or rotate the bulb
when removing it.
6. Install the new bulb in reverse order of removal.

Nov 11, 2008 | 2005 Nissan Pathfinder

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

16 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts

yadayada
yadayada

Level 3 Expert

75117 Answers

Phil Lovisek
Phil Lovisek

Level 3 Expert

705 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...